Hepatitis B Screening and Awareness in the Milwaukee Hmong Community.

INTRODUCTION: Hepatitis B virus (HBV) infection disproportionately affects the Hmong ethnic group, with reported US prevalence rates up to 20%, but data for Wisconsin's large Hmong community is lacking. We assessed the prevalence of HBV at Hmong screening events and whether small-group counseling affects HBV knowledge. METHODS: Free HBV screening events were held in Milwaukee, Wisconsin at a Hmong market, a local church, and annual Hmong New Year festival. Eligible Hmong subjects age 18 years and older also were invited to complete a 15-point survey on HBV knowledge at baseline and after education sessions. Hmong interpreters were available, and free HBV screening was offered. RESULTS: A total of 187 participants were tested for HBV, and 161 completed surveys. After education sessions, the mean knowledge score rose to 10.6 (71%) vs the pre-education score of 6.7 (45%) (P <0.0001). Active HBV [HBsAg(+) HBsAb(-)] was diagnosed in 18 participants (9.6%), 53 (28.3%) were susceptible [HBsAg(-) and HBsAb(-)], 5 (3.4%) were in the gray zone [HBsAg(-) with low/inadequate HBsAb(+) titer], and the remaining 110 (58.8%) were immune [HBsAg(-)/HBsAb(+)]. Of the 18 individuals with active HBV, 13 were male and 5 were female [age range 24-66]. CONCLUSION: Despite evidence that small-group education with visual aids is effective in enhancing HBV knowledge in the Hmong population, a significant knowledge gap remained on post-education scores, suggesting that better tools or repeated interventions may be warranted. While we acknowledge that this convenience sampling may have introduced biases, the rate of active HBV infection in Wisconsin is much higher than general US population reports, and a quarter of those tested were found to be susceptible to HBV.

Tolerance testing of passive radio frequency identification tags for solvent, temperature, and pressure conditions encountered in an anatomic pathology or biorepository setting.

BACKGROUND: Radio frequency identification (RFID) tags have potential for use in identifying and tracking biospecimens in anatomic pathology and biorepository laboratories. However, there is little to no data on the tolerance of tags to solutions, solvents, temperatures, and pressures likely to be encountered in the laboratory. The functioning of the Hitachi Mu-chip RFID tag, a candidate for pathology use, was evaluated under such conditions. METHODS: The RFID tags were affixed to cryovials containing tissue or media, glass slides, and tissue cassettes. The tags were interrogated for readability before and after each testing condition or cycle. Individual tags were subjected to only one testing condition but for multiple cycles. Testing conditions were: 1) Ten wet autoclave cycles (121°C, 15 psi); 2) Ten dry autoclave cycles (121°C, 26 psi); 3) Ten tissue processor cycles; 4) Ten hematoxylin and eosin (H&E) staining cycles; 5) Ten antigen retrieval pressure cooker cycles (125°C, 15 psi); 6) 75°C for seven days; 7) 75-59 °C day/night cycles for 7 days; 8) -80°C, -150°C, or -196°C for 12 months; 9) Fifty freeze-thaw cycles (-196°C to 22°C). RESULTS: One hundred percent of tags exposed to cold temperatures from -80 to -196 °C (80 tags, 1120 successful reads), high temperatures from 52 to 75°C (40 tags, 420 reads), H & E staining (20 tags, 200 reads), pressure cooker antigen retrieval (20 tags, 200 reads), and wet autoclaving (20 tags, 200 reads) functioned well throughout and after testing. Of note, all 20 tested tags tolerated 50 freeze-thaw cycles and all 60 tags subjected to sustained freezing temperatures were readable after 1 year. One dry autoclaved tag survived nine cycles but failed after the tenth. The remaining 19 tags were readable after all 10 dry autoclave cycles. One tag failed after the first tissue processing cycle while the remaining 19 tags survived all 10 tissue processing cycles. CONCLUSIONS: In this preliminary study, these RFID tags show a high-degree of tolerance to tested solutions, solvents, temperature, and pressure conditions. However, a measurable failure rate is detectable under some circumstances and redundant identification systems such as barcodes may be required with the deployment of RFID systems. We have delineated testing protocols that may be used as a framework for preliminary assessments of candidate RFID tag tolerance to laboratory conditions.