Effects on the accelerating electron bunches due to the presence of sulfur hexafluoride or air in the linac waveguide.

Sulfur hexafluoride gas (SF6) is used as a dielectric insulator in the acceleration process of certain medical linear accelerator waveguides. Nevertheless, some innovative development and investigation cases require intervention in the linear accelerator or, specifically, on the waveguide, which could affect the sealing of the device. In this regard, vacuum sealing systems can be compromised, affecting the properties of the radiation beams produced. The presence of sulfur hexafluoride or air inside the VARIAN 6/100 waveguide was investigated under different pressure conditions and non-uniform electric fields, adapting Monte Carlo simulation techniques for modeling radiation transport coupled with electric fields. Obtained results indicated the suitability of the proposed approach, while comparisons with theoretical approaches and experimental evidence supported the model's consistency.

Applicability of 'Toolkit for Safety Assessment' tool to interventional radiology using probabilistic risk assessment techniques.

Interventional radiology brings extensive benefits to patients. Nevertheless, certain procedures may result in high doses of radiation, leading to health risks to occupationally exposed individuals (OEIs). Therefore, a more comprehensive risk analysis is essential to ensuring safety and minimising radiation exposures for all OEIs. The Toolkit for Safety Assessment (TOKSA) tool performs risk assessments based on the concepts described in 'General Safety Requirements' Part 3 (Radiation Protection and Safety of Radiation Sources: International Basic Safety Standards) and Part 4 (Safety Assessment for Facilities and Activities). This tool was developed based on the 'Ibero-American Forum of Radiological and Nuclear Regulatory Agencies' risk models and can promote the use of the risk assessment processes by OEIs. The aim of this study was to experimentally analyse the applicability of the TOKSA tool in interventional radiology with the use/support of probabilistic risk assessment techniques. The results were used to reduce the risks associated with a hemodynamics room in a hospital in Belo Horizonte, Brazil.

Intense foreshocks and a slow slip event preceded the 2014 Iquique Mw 8.1 earthquake.

The subduction zone in northern Chile is a well-identified seismic gap that last ruptured in 1877. The moment magnitude (Mw) 8.1 Iquique earthquake of 1 April 2014 broke a highly coupled portion of this gap. To understand the seismicity preceding this event, we studied the location and mechanisms of the foreshocks and computed Global Positioning System (GPS) time series at stations located on shore. Seismicity off the coast of Iquique started to increase in January 2014. After 16 March, several Mw > 6 events occurred near the low-coupled zone. These events migrated northward for ~50 kilometers until the 1 April earthquake occurred. On 16 March, on-shore continuous GPS stations detected a westward motion that we model as a slow slip event situated in the same area where the mainshock occurred.

[Hereditary multiple exostosis. Case report and differential diagnosis of enchondromatosis]. / Exostosis múltiple hereditaria. Reporte de un caso y diagnóstico diferencial de las encondromatosis.

The enchondromatosis include a heterogeneous group of congenital disorders characterized by the presence of multiple enchondromas associated with musculoskeletal malformations and the main complication is the risk of malignant transformation to chondrosarcoma. The hereditary multiple exostosis is an entity with autonomus dominant inheritance pattern, characterized by having multiple exostosis capped benign cartilage and heterogeneous clinical manifestations. Mutations of EXT1 and EXT2 genes have been cloned and are responsible for over 80% of the cases. We report a case of a six years old female with a diagnosis of hereditary multiple exostosis, that has been multidisciplinary assessed at our institution being the second case study in the Medical Genetics Unit of the Universidad de Los Andes; the clinical and genetic aspects, the differential diagnosis with Oilier disease and Maffucci syndrome were reviewed.

Radiation dose and image quality for adult interventional cardiology in Chile: a national survey.

The aim of this work was to investigate the differences in dose settings and image quality among 10 X-ray systems used for interventional cardiology in Chile. Entrance surface air kerma (ESAK) was measured on a phantom of 20 cm thickness of polymethyl methacrylate slabs. Image quality was evaluated using DICOM images of a test object Leeds TOR 18-FG for cine mode acquisition, through the numerical parameters signal-to-noise ratio (SNR), high-contrast spatial resolution (HCSR) and figure of merit. ESAK rate values for fluoroscopy modes ranged between 7.1 and 121.7 mGy min(-1). For cine mode, ESAK values per frame ranged from 63 to 400 µGy fr(-1). SNR and HCSR parameters for cine mode varied from 4.8 to 8.6 and 0.4 to 10, respectively. FOM values resulted from 6.9 to 64.5 among the different X-ray systems. Results show important differences between systems and point out the need to launch an optimisation programme.

Paediatric interventional cardiology: flat detector versus image intensifier using a test object.

Entrance surface air kerma (ESAK) values and image quality parameters were measured and compared for two biplane angiography x-ray systems dedicated to paediatric interventional cardiology, one equipped with image intensifiers (II) and the other one with dynamic flat detectors (FDs). Polymethyl methacrylate phantoms of different thicknesses, ranging from 8 to 16 cm, and a Leeds TOR 18-FG test object were used. The parameters of the image quality evaluated were noise, signal-difference-to-noise ratio (SdNR), high contrast spatial resolution (HCSR) and three figures of merit combining entrance doses and signal-to-noise ratios or HCSR. The comparisons showed a better behaviour of the II-based system in the low contrast region over the whole interval of thicknesses. The FD-based system showed a better performance in HCSR. The FD system evaluated would need around two times more dose than the II system evaluated to reach a given value of SdNR; moreover, a better spatial resolution was measured (and perceived in conventional monitors) for the system equipped with flat detectors. According to the results of this paper, the use of dynamic FD systems does not lead to an automatic reduction in ESAK or to an automatic improvement in image quality by comparison with II systems. Any improvement also depends on the setting of the x-ray systems and it should still be possible to refine these settings for some of the dynamic FDs used in paediatric cardiology.

Radiation dose and image quality for paediatric interventional cardiology.

Radiation dose and image quality for paediatric protocols in a biplane x-ray system used for interventional cardiology have been evaluated. Entrance surface air kerma (ESAK) and image quality using a test object and polymethyl methacrylate (PMMA) phantoms have been measured for the typical paediatric patient thicknesses (4-20 cm of PMMA). Images from fluoroscopy (low, medium and high) and cine modes have been archived in digital imaging and communications in medicine (DICOM) format. Signal-to-noise ratio (SNR), figure of merit (FOM), contrast (CO), contrast-to-noise ratio (CNR) and high contrast spatial resolution (HCSR) have been computed from the images. Data on dose transferred to the DICOM header have been used to test the values of the dosimetric display at the interventional reference point. ESAK for fluoroscopy modes ranges from 0.15 to 36.60 microGy/frame when moving from 4 to 20 cm PMMA. For cine, these values range from 2.80 to 161.10 microGy/frame. SNR, FOM, CO, CNR and HCSR are improved for high fluoroscopy and cine modes and maintained roughly constant for the different thicknesses. Cumulative dose at the interventional reference point resulted 25-45% higher than the skin dose for the vertical C-arm (depending of the phantom thickness). ESAK and numerical image quality parameters allow the verification of the proper setting of the x-ray system. Knowing the increases in dose per frame when increasing phantom thicknesses together with the image quality parameters will help cardiologists in the good management of patient dose and allow them to select the best imaging acquisition mode during clinical procedures.

[Secondary ionizing radiation generated by digital and analog coronary cineangiographic equipment: influence of external systems of radiologic protection]. / Radiación ionizante secundaria generada en equipos de cineangiografía coronaria digital y analógica: influencia de los sistemas externos de protección radiológica.

BACKGROUND: Exposure to ionizing radiation is a known hazard of radiological procedures. AIM: To compare the emission of secondary ionizing radiation from two coronary angiographic equipment, one with digital and the other with analog image generation. To evaluate the effectiveness of external radiological protection devices. MATERIAL AND METHODS: Environmental and fluoroscopy generated radiation in the cephalic region of the patient was measured during diagnostic coronary angiographies. Ionizing radiation generated in anterior left oblique projection (ALO) and in anterior right oblique projection (ARO) were measured with and without leaded protections. In 19 patients (group 1), a digital equipment was used and in 21 (group 2), an analog equipment. RESULTS: Header radiation for groups 1 and 2 was 1194 +/- 337 and 364 +/- 222 microGray/h respectively (p < 0.001). During fluoroscopy and with leaded protection generated radiation for groups 1 and 2 was 612 +/- 947 and 70 +/- 61 microGray/h respectively (p < 0.001). For ALO projection, generated radiation for groups 1 and 2 was 105 +/- 47 and 71 +/- 192 microGray/h respectively (p < 0.001). During filming the radiation for ALO projection for groups 1 and 2 was 7252 +/- 9569 and 1671 +/- 2038 microGray/h respectively (p = 0.03). Out of the protection zone, registered radiation during fluoroscopy for groups 1 and 2 was 2800 +/- 1741 and 1318 +/- 954 microGray/h respectively (p < 0.001); during filming, the figures were 15,500 +/- 5840 and 18,961 +/- 10,599 microGray/h respectively (NS). CONCLUSIONS: Digital radiological equipment has a lower level of ionizing radiation emission than the analog equipment.