Modifying Randles circuit for analysis of polyoxometalate layer-by-layer films.

Multilayer films with anionic phosphomolybidic acid (PMo(12)) clusters have been fabricated via the electrostatic layer-by-layer (LbL) method. The charged mass transport phenomena of these thin films have been studied using cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) with [Fe(CN)(6)](3-/4-) and [Ru(NH(3))(6)](3+/2+) as the redox probes. By adding a film resistance and a film capacitance to the conventional Randles equivalent circuit, we can calculate the diffusion coefficient values that help understand the microscopic nature of the thin films. When the negatively charged probe [Fe(CN)(6)](3-/4-) was used, lower diffusion coefficients were obtained for multilayers deposited from higher ionic strength solutions. This relationship was less obvious when the positively charged probe [Ru(NH(3))(6)](3+/2+) was used, in which the electrostatic attraction between PMo(12) clusters and the probe ions complicates the mass-transfer process. It is believed that the addition of salt to dipping solutions increases the tortuosity of the films so the mass transport takes longer paths, inducing lower diffusion coefficients. Higher PMo(12) loading causes lower diffusion coefficients due to the polyoxometalate clusters blocking the paths for charged probe ions.

Photolytic treatment of atrazine-contaminated water: products, kinetics, and reactor design.

This study investigates the products, kinetics, and reactor design of atrazine photolysis under 254-nm ultraviolet-C (UVC) irradiation. With an initial atrazine concentration of 60 microg/L (60 ppbm), only two products remain in detectable levels. Up to 77% of decomposed atrazine becomes hydroxyatrazine, the major product. Both atrazine and hydroxyatrazine photodecompose following the first-order rate equation, but the hydroxyatrazine photodecomposition rate is significantly slower than that of atrazine. For atrazine photodecomposition, the rate constant is proportional to the square of UVC output, but inversely proportional to the reactor volume. For a photochemical reactor design, a series of equations are proposed to calculate the needed UVC output power, water treatment capacity, and atrazine outlet concentration.

Fourier transform infrared-probed O(3P) microreactor: demonstration with ethylene reactions in argon matrix.

To demonstrate the development of an oxygen atom microreactor in the form of liquid-helium-cooled solid argon matrix deposited on an infrared (IR) window, the oxidation of ethylene by mobile O atoms has been investigated. O atom diffusion through the argon matrix is confirmed and used to examine ethylene-oxygen atom reactions. In a bench-scale matrix isolation system probed with a Fourier transform infrared (FT-IR) spectrometer, matrices of solid Ar at 8-10 K doped with NO2 and ethylene have been prepared on a ZnSe window within an evacuated cryostat. The matrices have been photolyzed using 350-450 nm photons, and the reaction products resulting from the reaction of O(3P), one of the photolysis products of NO2, with ethylene have been identified using FT-IR and a Gaussian 98W simulation program. These products include oxirane, acetaldehyde, ethyl nitrite radical, and ketene. The temperature effect in the range of 10-30 K on the products formed has also been investigated. The reaction mechanisms are discussed and the viability of the solid Ar matrix being a low temperature microreactor to examine reaction mechanisms of mobile oxygen atoms is elaborated.

Water-related matrix isolation phenomena during NO2 photolysis in argon matrix.

Photolysis (350-450 nm) of NO(2) molecules trapped in argon matrices at 10 K has been studied using Fourier transform infrared (FTIR) spectroscopy to examine the mobility of the photolysis products, O((3)P) and NO, and their subsequent reactions. The formation of N(2)O(5) and N(2)O(3) from reactions of these mobile species with immobilized NO(2) and N(2)O(4) is confirmed. Water molecules from the background gases in the vacuum have been found to be isolated in the argon matrix during deposition of diluted NO(2) in Ar. The entrapped water molecules along with some of their NO(2) adducts have been characterized. Exposure of the matrix to photons to photolyze NO() resulted in not only internal matrix reactions, but also an enhanced deposition of ice over the surface of the argon matrix. This is caused by photodesorption of water molecules from the walls of the matrix isolation chamber and their subsequent condensation on the matrix surface. This ice overlayer has been found to give a very significant dangling OH band and a substantial librational band in the FT-IR spectra, indicating substantial surface area and internal porosity, respectively. The potential of using photodesorbed water to establish high surface area ice interfaces with dangling OH groups for heterogeneous photoreaction studies is discussed.