RESUMO
A simple polymer twin-tube terahertz (THz) fiber that can be used as a polarization filter is proposed and investigated using the finite element method in this paper. The twin-tube THz fiber consists of two closely spaced identical tubes located symmetrically inside the protecting jacket. The simulation results show that the y-polarization fundamental mode (YPFM) can be well confined between the two tube walls near the fiber center, while the x-polarization fundamental mode (XPFM) has a huge confinement loss due to the coupling with the tube mode. For the fundamental mode (FM), a polarization extinction ratio (PER) of 30 dB can be realized after a 1.3 cm length of the fiber, and the insertion loss of the YPFM is less than 0.5 dB at 1 THz. In addition, higher order modes (HOMs) can be effectively suppressed by further increasing the fiber length. Simulation results indicate that all HOMs have powers being 30 dB lower than that of the supported YPFM after a 7.44 cm length of the fiber, and the insertion loss of the YPFM is less than 2.7 dB at 1 THz. Furthermore, the effects of fiber structure parameters on the loss properties are investigated, proving that the proposed fiber has a good fabrication tolerance. Owing to the simple structure, the proposed fiber polarization filter is easy to be fabricated and low-cost, which makes it a potential application in commercial THz systems.
RESUMO
A novel hollow-core anti-resonant fiber (HC-ARF) with glass-sheet conjoined nested tubes that supports five core modes of LP01-LP31 with low mode couplings, large differential group delays (DGDs), and low bending losses (BLs) is proposed. A novel cladding structure with glass-sheet conjoined nested tubes (CNT) is induced for the proposed HC-ARF which can suppress mode couplings between the LP01-LP31 modes and the cladding modes. The higher-order modes (HOMs) which are LP11-LP31 modes also have very low loss by optimizing the radius of the nested tube and the core radius. Moreover, the large effective refractive index differences Δneff between HOMs are all larger than 1 × 10-4 which contributes to a large DGD in the wavelength range from 1.3 to 1.7 µm. The bending loss of the HC-ARF is analyzed and optimized emphatically. Our calculation results show that bending losses of LP01-LP31 modes are all lower than 3.0 × 10-4 dB/m in the wavelength range from 1.4 to 1.61 µm even when the fiber bending radius of the HC-ARF is 6â cm.
RESUMO
With the rapid construction of metro tunnels in many metropolises, a fast and convenient solution to capture tunnel deformation is desired by civil engineers. This contribution reports an automatic and wireless tunnel deformation monitoring system using ultrasonic transducers. A processing algorithm of the redundant ultrasonic information (RUI) approach is proposed to improve measurement accuracy. The feasibility of this tunnel deformation monitoring method is carefully examined with various probe angles, distances, and surrounding temperature variations. The results indicate that high accuracy can be achieved with different coefficients for various probe angles and sensor distances, as well as temperatures. In addition, a physical tunnel model was fabricated to verify the new processing algorithm of the RUI approach for a wireless tunnel deformation sensing system. The test results reveal that average measurement errors decreased from 7% to 3.75% using the RUI approach. Therefore, it can be concluded that the proposed approach is well suited to the automatic detection of critical conditions such as large deformation events in metro tunnels.