RESUMO
In order to improve the thermoelectric properties of single-walled carbon nanotubes (SWCNTs), bilayer-like structures of graphene quantum dots (GQDs) and SWCNTs films (b-GQDs/SWCNTs) were prepared by directly coating GQDs on the surface of SWCNTs films. Compared to pristine SWCNT films (p-SWCNTs), the electrical conductivity of b-GQDs/SWCNTs increased while their Seebeck coefficient decreased. The special interface structure of GQDs and SWCNTs can not only improve carrier transport to increase electrical conductivity but also scatter phonons to reduce thermal conductivity. A maximum power factor (PF) of 51.2 µW·m-1·K-2 is obtained at 298 K for the b-GQDs/SWCNTs (2:100), which is higher than the PF of 40.9 µW·m-1·K-2 by p-SWCNTs. Incorporation of GQDs shows an obvious improvement in power factor and a significant reduction in the thermal conductivity for SWCNTs, and thus, preparation of b-GQDs/SWCNTs provides a new strategy to enhance the thermoelectric properties of SWCNTs-based materials.
RESUMO
Applying sewage sludge ash (SSA) to produce reclaimed tiles is a promising recycling technology in resolving the increasing sludge wastes from wastewater treatment. However, performance of such reclaimed tiles is inferior to that of original ceramic tiles. Many researchers have therefore tried adding various industrial by-products to improve reclaimed tile properties. In this study, multiple materials including waste glass and waste foundry sand (WFS) were added in an attempt to improve physical and mechanical properties of reclaimed tiles with SSA. Samples with various combinations of clay, WFS, waste glass and SSA were made with three kiln temperatures of 1000°C, 1050°C, and 1100°C. A series of tests on the samples were next conducted. Test results showed that waste glass had positive effects on bending strength, water absorption and weight loss on ignition, while WFS contributed the most in reducing shrinkage, but could decrease the tile bending strength when large amount was added at a high kiln temperature. This study suggested that a combination of WFS from 10% to 15%, waste glass from 15% to 20%, SSA at 10% at a kiln temperature between 1000°C and 1050°C could result in quality reclaimed tiles with a balanced performance.
