Sulfadiazine's photodegradation using a novel magnetic and reusable carbon based photocatalyst: Photocatalytic efficiency and toxic impacts to marine bivalves.

In the present study, waste-based biochar functionalized with titanium dioxide (TiO2) and afterwards magnetized by an ex-situ approach, defined as synthetic photosensitizer (SPS), was explored for the photocatalytic degradation of sulfadiazine (SDZ), an antibiotic widely used in the aquaculture industry, under solar irradiation. The use of the SPS enhanced the photodegradation efficiency, with a half-life time (t1/2) reduction from 12.2 ± 0.1 h (without SPS) to 5.6 ± 0.4 h. The applied magnetization procedure allowed to obtain a SPS with good reusability for SDZ photodegradation even after five consecutive cycles. To evaluate the effects on marine bivalves of SDZ, before and after photodegradation and in presence or absence of the SPS, a typical bioindicator species, the mussel Mytilus galloprovincialis, was used and different biochemical markers were analysed. Results obtained indicated that the exposure to SDZbefore irradiation, both in absence and presence of SPS, caused an increase in mussels' metabolism and defence mechanisms, evidencing great biochemical impacts. However, after irradiation (in the absence and presence of SPS), biochemical responses were similar to those observed in organisms exposed to control conditions, without SDZ. Therefore, this work provided a promising eco-friendly treatment for the removal of SDZ from aquaculture effluents.

Photodegradation of Aquaculture Antibiotics Using Carbon Dots-TiO2 Nanocomposites.

In this work, carbon dots (CD) were synthesized and coupled to titanium dioxide (TiO2) to improve the photodegradation of antibiotics in aquaculture effluents under solar irradiation. Oxolinic acid (OXA) and sulfadiazine (SDZ), which are widely used in aquaculture, were used as target antibiotics. To prepare nanocomposites of CD containing TiO2, two modes were used: in-situ (CD@TiO2) and ex-situ (CD/TiO2). For CD synthesis, citric acid and glycerol were used, while for TiO2 synthesis, titanium butoxide was the precursor. In ultrapure water (UW), CD@TiO2 and CD/TiO2 showed the largest photocatalytic effect for SDZ and OXA, respectively. Compared with their absence, the presence of CD@TiO2 increased the photodegradation of SDZ from 23 to 97% (after 4 h irradiation), whereas CD/TiO2 increased the OXA photodegradation from 22 to 59% (after 1 h irradiation). Meanwhile, in synthetic sea salts (SSS, 30‱, simulating marine aquaculture effluents), CD@TiO2 allowed for the reduction of SDZ's half-life time (t1/2) from 14.5 ± 0.7 h (in absence of photocatalyst) to 0.38 ± 0.04 h. Concerning OXA in SSS, the t1/2 remained the same either in the absence of a photocatalyst or in the presence of CD/TiO2 (3.5 ± 0.3 h and 3.9 ± 0.4 h, respectively). Overall, this study provided novel perspectives on the use of eco-friendly CD-TiO2 nanocomposites for the removal of antibiotics from aquaculture effluents using solar radiation.

Impact of UASB reactors operation mode on the removal of estrone and 17α-ethinylestradiol from wastewaters.

This work aims to compare the performance of the continuous operation (CO) and intermittent operation (IO) of upflow anaerobic sludge blanket (UASB) reactors for the removal of estrone (E1) and 17α-ethinylestradiol (EE2) from wastewaters. Results suggest that the IO contribute to the improvement of the overall removal of estrogens (above 95% for E1 and EE2) when compared to CO (49% for E1 and 39% for EE2). For both CO and IO, biodegradation was the main removal mechanism for E1, while for EE2, adsorption to sludge was the major removal pathway. Moreover, a higher biodegradation of estrogens was obtained with the IO compared to CO (69.4% vs. 43.3% for E1 and 21.8% vs. 8.0% for EE2). The favourable effect of IO can be justified by effluent recirculation during the feedless period which promotes the adaptation of microbial biomass to estrogens' biodegradation.

Determination of estrone and 17α-ethinylestradiol in digested sludge by ultrasonic liquid extraction and high-performance liquid chromatography with fluorescence detection.

Estrone, 17ß-estradiol and 17α-ethinylestradiol are increasingly recognised as important micropollutants to be monitored in wastewater treatment plants. These estrogens are retained onto sludge due to their high adsorption and since they are largely used in land applications, the monitoring of these chemicals in sludge samples is of great importance. This study describes a method for the determination of estrone and 17α-ethinylestradiol in fresh sludge samples. After spiking fresh digested sludge with estrone and 17α-ethinylestradiol and maintaining in contact during 5, 30 and 60 min, the freeze-dried samples were subjected to ultrasonic liquid extraction, with methanol and acetone, and analysed by high-performance liquid chromatography with fluorescence detection. The average recoveries obtained for estrone and 17α-ethinylestradiol using the different contact times were 103 ± 3 and 97 ± 4%, respectively. Fresh sludge samples from one waste water treatment plant located in Portugal were analysed and estrone was detected in primary fresh sludge, anaerobic digested sludge and dehydrated sludge at a concentration in the range of 1-4.8 µg/g. The method here developed does not require any sample clean-up, being fast and simple, reliable and inexpensive, making possible its application for monitoring the contamination of sludge with these estrogens.