Characterization of Mn5Ge3 Contacts on a Shallow Ge/SiGe Heterostructure.

Mn5Ge3 is a ferromagnetic phase of the Mn-Ge system that is a potential contact material for efficient spin injection and detection. Here, we investigate the creation of Mn5Ge3-based contacts on a Ge/SiGe quantum well heterostructure via solid-state synthesis. X-ray diffraction spectra fitting indicates the formation of Mn5Ge3-based contacts on bulk Ge and Ge/SiGe. High-resolution scanning transmission electron microscopy imaging and energy dispersive X-ray spectroscopy verify the correct Mn5Ge3-based phase formation. Schottky diode measurements, transmission line measurements, and Hall measurements reveal that Mn5Ge3-based contacts serve as good p-type contacts for Ge/SiGe quantum well heterostructures due to having a low Schottky barrier height of 0.10eV (extracted from a Mn5Ge3/n-Ge analogue) and a contact resistance in the order of 1 kΩ. Furthermore, we show that these electrical characteristics have a gate-voltage dependence, thereby providing tunability.

Direct Characterization of Buried Interfaces in 2D/3D Heterostructures Enabled by GeO2 Release Layer.

Inconsistent interface control in devices based on two-dimensional materials (2DMs) has limited technological maturation. Astounding variability of 2D/three-dimensional (2D/3D) interface properties has been reported, which has been exacerbated by the lack of direct investigations of buried interfaces commonly found in devices. Herein, we demonstrate a new process that enables the assembly and isolation of device-relevant heterostructures for buried interface characterization. This is achieved by implementing a water-soluble substrate (GeO2), which enables deposition of many materials onto the 2DM and subsequent heterostructure release by dissolving the GeO2 substrate. Here, we utilize this novel approach to compare how the chemistry, doping, and strain in monolayer MoS2 heterostructures fabricated by direct deposition vary from those fabricated by transfer techniques to show how interface properties differ with the heterostructure fabrication method. Direct deposition of thick Ni and Ti films is found to react with the monolayer MoS2. These interface reactions convert 50% of MoS2 into intermetallic species, which greatly exceeds the 10% conversion reported previously and 0% observed in transfer-fabricated heterostructures. We also measure notable differences in MoS2 carrier concentration depending on the heterostructure fabrication method. Direct deposition of thick Au, Ni, and Al2O3 films onto MoS2 increases the hole concentration by >1012 cm-2 compared to heterostructures fabricated by transferring MoS2 onto these materials. Thus, we demonstrate a universal method to fabricate 2D/3D heterostructures and expose buried interfaces for direct characterization.

Induced Superconducting Pairing in Integer Quantum Hall Edge States.

Indium arsenide (InAs) near surface quantum wells (QWs) are promising for the fabrication of semiconductor-superconductor heterostructures given that they allow for a strong hybridization between the two-dimensional states in the quantum well and the ones in the superconductor. In this work, we present results for InAs QWs in the quantum Hall regime placed in proximity of superconducting NbTiN. We observe a negative downstream resistance with a corresponding reduction of Hall (upstream) resistance, consistent with a very high Andreev conversion. We analyze the experimental data using the Landauer-Büttiker formalism, generalized to allow for Andreev reflection processes. We attribute the high efficiency of Andreev conversion in our devices to the large transparency of the InAs/NbTiN interface and the consequent strong hybridization of the QH edge modes with the states in the superconductor.

Resistively loaded coplanar waveguide for microwave measurements of induced carriers.

We describe the use of a coplanar waveguide (CPW) whose slots are filled with a resistive film, a resistively loaded CPW (RLCPW), to measure two-dimensional electron systems (2DESs). The RLCPW applied to the sample hosting the 2DES provides a uniform metallic surface serving as a gate to control the areal charge density of the 2DES. As a demonstration of this technique, we present measurements on a Si metal-oxide-semiconductor field-effect transistor and a model that successfully converts microwave transmission coefficients into conductivity of a nearby 2DES capacitively coupled to the RLCPW. We also describe the process of fabricating the highly resistive metal film required for fabrication of the RLCPW.

A PtNiGe resistance thermometer for cryogenic applications.

Resistance thermometry is a widely employed technique for general-purpose temperature measurements, with applications ranging from basic thermal physics experiments to industrial use in the automotive, aerospace, and microelectronics industries. Platinum is one of the most commonly used materials for resistance thermometry in microfabricated devices due to its broad range of temperature coverage, ease of fabrication, and compatibility with numerous microfabrication processes. For cryogenic applications below 10 K, transition metal oxynitrides and negative temperature coefficient alloys are the dominant choice owing to their superior temperature sensitivity in this range compared to pure metallic thin films. However, these materials often require arduous process development to optimize their sensitivity and may be constrained by a diminutive thermal budget. In this paper, we present a PtNiGe thermometer that has both the fabrication simplicity and thermal stability traits of a Pt thin film. We characterize this PtNiGe material system for a series of annealing temperatures and analyze its sensitivity and temperature coefficient of resistance. We find that this thermometer maintains a performance similar to Pt thin films at 40 K with a sensitivity just one order of magnitude below that of a high performance, commercial thermometer at 380 mK. This PtNiGe thermometer represents a middle ground between Pt thin films and commercial devices.

Strain Effects on Rashba Spin-Orbit Coupling of 2D Hole Gases in GeSn/Ge Heterostructures.

A demonstration of 2D hole gases in GeSn/Ge heterostructures with a mobility as high as 20 000 cm2 V-1 s-1 is given. Both the Shubnikov-de Haas oscillations and integer quantum Hall effect are observed, indicating high sample quality. The Rashba spin-orbit coupling (SOC) is investigated via magneto-transport. Further, a transition from weak localization to weak anti-localization is observed, which shows the tunability of the SOC strength by gating. The magneto-transport data are fitted to the Hikami-Larkin-Nagaoka formula. The phase-coherence and spin-relaxation times, as well as spin-splitting energy and Rashba coefficient of the k-cubic term, are extracted. The analysis reveals that the effects of strain and confinement potential at a high fraction of Sn suppress the Rashba SOC caused by the GeSn/Ge heterostructures.

Single and double hole quantum dots in strained Ge/SiGe quantum wells.

Even as today's most prominent spin-based qubit technologies are maturing in terms of capability and sophistication, there is growing interest in exploring alternate material platforms that may provide advantages, such as enhanced qubit control, longer coherence times, and improved extensibility. Recent advances in heterostructure material growth have opened new possibilities for employing hole spins in semiconductors for qubit applications. Undoped, strained Ge/SiGe quantum wells are promising candidate hosts for hole spin-based qubits due to their low disorder, large intrinsic spin-orbit coupling strength, and absence of valley states. Here, we use a simple one-layer gated device structure to demonstrate both a single quantum dot as well as coupling between two adjacent quantum dots. The hole effective mass in these undoped structures, m* âˆ¼ 0.08 m 0, is significantly lower than for electrons in Si/SiGe, pointing to the possibility of enhanced tunnel couplings in quantum dots and favorable qubit-qubit interactions in an industry-compatible semiconductor platform.

Charge sensed Pauli blockade in a metal-oxide-semiconductor lateral double quantum dot.

We report Pauli blockade in a multielectron silicon metal-oxide-semiconductor double quantum dot with an integrated charge sensor. The current is rectified up to a blockade energy of 0.18 ± 0.03 meV. The blockade energy is analogous to singlet-triplet splitting in a two electron double quantum dot. Built-in imbalances of tunnel rates in the MOS DQD obfuscate some edges of the bias triangles. A method to extract the bias triangles is described, and a numeric rate-equation simulation is used to understand the effect of tunneling imbalances and finite temperature on charge stability (honeycomb) diagram, in particular the identification of missing and shifting edges. A bound on relaxation time of the triplet-like state is also obtained from this measurement.