Dissolution behavior of calcium phosphate nanocrystals deposited on titanium alloy surfaces.

We have recently shown that a new implant surface design, achieved by the deposition of discrete nanocrystals of calcium phosphate on microtopographically complex titanium-based substrates, accelerates osteoconduction and also renders the implant surface bone bonding. Thus, we wished to examine the elution behavior of these calcium phosphate nanocrystals and their modulation in vivo. We first compared the total amount of calcium phosphate on these implants with that of plasma-sprayed implants, by measuring the eluted calcium using atomic absorption spectrophotometry. We then plotted their dissolution behavior in vitro as a function of pH relevant to physiological conditions. To assess their structural stability in vivo for periods of up to 1 month, we placed samples in diffusion chambers, implanted them in the abdominal cavity of rats, and examined their surfaces by scanning electron microscopy following retrieval. Our results show that these nanocrystals are stable at normal pH but, as expected, dissolve at acidic pH, and that they remain unchanged when exposed to body fluid in vivo for up to 1 month.

The weight of wastes generated by removal of dental amalgam restorations and the concentration of mercury in dental wastewater.

OBJECTIVE: To determine the amount of amalgam entering the waste stream during removal of dental amalgam restorations. METHODS: Dental amalgam restorations were removed from anatomic replica teeth and natural teeth by means of a tungsten carbide bur, a high-speed handpiece and a conventional suction system. The weight of amalgam particles trapped in the primary and secondary solids separators was determined. Amalgam particles were filtered from wastewater with 15-microm filter paper and weighed. The concentration of total mercury in the effluent collected (by instantaneous flow-through) during the removal of amalgams, with and without an ISO-certified separator, was measured by means of cold-vapour atomic absorption spectrophotometry. RESULTS: About 60% by weight of the amalgam removed was found in the effluent, about a third was retained in the primary solids separator and less than 10% was retained in the secondary solids separator. The ISO-compliant separator reduced the concentration of mercury in the instantaneous flow-through discharge by 99.4%, from 31.2973 mg/L to 0.1800 mg/L. CONCLUSIONS: About 60% of the waste generated during the removal of amalgams escaped the primary and secondary solids collectors and was released into the wastewater. An ISO-certified amalgam particle separator was effective in removing the amalgam from the wastewater.