Multi-factorial analysis of the removal of dichloromethane and toluene in an airlift packing bioreactor.

Biotechnology has proven effective in removing a wide variety of VOCs. In this study, the effects of pH (from 3 to 7), operating temperature (20-30 °C), empty bed residence time (EBRT, 10-40 s) and transient inlet concentration (400-4000 mg m-3) on the removal performance of an airlift packing bioreactor (ALPR) was investigated. The removal efficiency (RE) and stability of the ALPR was evaluated and compared with the conventional airlift bioreactor (ALR). The results showed that under the influence of single factor variation, the ALPR showed significant higher RE and better stability than the ALR in removing dichloromethane (DCM) and toluene. Besides, a factorial design was used to analyses the interaction of multiple factors and their influence on the removal of DCM and toluene in the ALPR and ALR. It shows that pH value has the most significant influence, and plays a crucial role in maintaining high RE of DCM and toluene in both of the ALPR and ALR. Temperature has a great effect on the removal of toluene. EBRT has certain effect on the removal of DCM in the ALPR. The transient concentration of a single substrate has a significant negative effect on the RE of this substrate, while it does not significantly affect the removal of another substrate in the ALPR. However, the steep increase of DCM concentration has an adverse effect on the RE of high concentration toluene in the ALR. The overall RE and degradation capacity of both toluene and DCM by the ALPR are much higher than that of the conventional ALR.

Evaluation of polypyrrole-modified bioelectrodes in a chemical absorption-bioelectrochemical reduction integrated system for NO removal.

A Chemical absorption-bioelectrochemical reduction (CABER) system is based on Chemical absorption-biological reduction (CABR) system, which aims at NO removal and has been studied in many of our previous works. In this paper, we applied polypyrrole (PPy) on the electrode of bioelectrochemical reactor (BER) of CABER system, which induced a much higher current density in the cyclic voltammetry (CV) curve for the electrode itself and better NO removal rate in the system. In addition, a Microbial Electrolysis Cell (MEC) is constructed to study its strengthening mechanism. Results shows that PPy-MEC has a greater Faraday efficiency and higher reduction rate of Fe(III)EDTA and Fe(II)EDTA-NO in the solution when compared to original Carbon MEC, which confirms the advantage of PPy-modified electrode(s) in the CABER system. The results of this study are reported for illustration of potential of CABER technology and design of low-cost high-efficiency NOx control equipment in the future.