Suppressed basal melting in the eastern Thwaites Glacier grounding zone.

Thwaites Glacier is one of the fastest-changing ice-ocean systems in Antarctica1-3. Much of the ice sheet within the catchment of Thwaites Glacier is grounded below sea level on bedrock that deepens inland4, making it susceptible to rapid and irreversible ice loss that could raise the global sea level by more than half a metre2,3,5. The rate and extent of ice loss, and whether it proceeds irreversibly, are set by the ocean conditions and basal melting within the grounding-zone region where Thwaites Glacier first goes afloat3,6, both of which are largely unknown. Here we show-using observations from a hot-water-drilled access hole-that the grounding zone of Thwaites Eastern Ice Shelf (TEIS) is characterized by a warm and highly stable water column with temperatures substantially higher than the in situ freezing point. Despite these warm conditions, low current speeds and strong density stratification in the ice-ocean boundary layer actively restrict the vertical mixing of heat towards the ice base7,8, resulting in strongly suppressed basal melting. Our results demonstrate that the canonical model of ice-shelf basal melting used to generate sea-level projections cannot reproduce observed melt rates beneath this critically important glacier, and that rapid and possibly unstable grounding-line retreat may be associated with relatively modest basal melt rates.

Clean subglacial access: prospects for future deep hot-water drilling.

Accessing and sampling subglacial environments deep beneath the Antarctic Ice Sheet presents several challenges to existing drilling technologies. With over half of the ice sheet believed to be resting on a wet bed, drilling down to this environment must conform to international agreements on environmental stewardship and protection, making clean hot-water drilling the most viable option. Such a drill, and its water recovery system, must be capable of accessing significantly greater ice depths than previous hot-water drills, and remain fully operational after connecting with the basal hydrological system. The Subglacial Lake Ellsworth (SLE) project developed a comprehensive plan for deep (greater than 3000 m) subglacial lake research, involving the design and development of a clean deep-ice hot-water drill. However, during fieldwork in December 2012 drilling was halted after a succession of equipment issues culminated in a failure to link with a subsurface cavity and abandonment of the access holes. The lessons learned from this experience are presented here. Combining knowledge gained from these lessons with experience from other hot-water drilling programmes, and recent field testing, we describe the most viable technical options and operational procedures for future clean entry into SLE and other deep subglacial access targets.

Technologies for retrieving sediment cores in Antarctic subglacial settings.

Accumulations of sediment beneath the Antarctic Ice Sheet contain a range of physical and chemical proxies with the potential to document changes in ice sheet history and to identify and characterize life in subglacial settings. Retrieving subglacial sediments and sediment cores presents several unique challenges to existing technologies. This paper briefly reviews the history of sediment sampling in subglacial environments. It then outlines some of the technological challenges and constraints in developing the corers being used in sub-ice shelf settings (e.g. George VI Ice Shelf and Larsen Ice Shelf), under ice streams (e.g. Rutford Ice Stream), at or close to the grounding line (e.g. Whillans Ice Stream) and in subglacial lakes deep under the ice sheet (e.g. Lake Ellsworth). The key features of the corers designed to operate in each of these subglacial settings are described and illustrated together with comments on their deployment procedures.