Influence of sodium chloride and pH during acidic marination on water retention and mechanical properties of turkey breast meat.

Turkey breast cubes underwent acidic marination in the presence of salt. The transfer of water, salt and acid was measured, and texture was assessed on the cooked meat. While significant mass gains were observed during marination, from 20 minutes of immersion onwards, only long durations produced an overall matter balance greater than that of non-marinated meat. From the first minutes of immersion, these transfers caused hardening, regardless of the presence of salt in the marinade. For longer durations, only in the absence of salt was significant tenderizing seen in comparison to the non-marinated control. This effect appears to be due on the one hand to passing the isoelectric pH of the meat during acidification, and on the other hand to setting up antagonistic mechanisms breaking down or reinforcing connective tissues by acid and salt respectively. The high degree of tenderization observed in a water-acid solution can be explained partly by dilution of the fiber load per section unit due to protein solubilization.

3D strain assessment in ultrasound (Straus): a synthetic comparison of five tracking methodologies.

This paper evaluates five 3D ultrasound tracking algorithms regarding their ability to quantify abnormal deformation in timing or amplitude. A synthetic database of B-mode image sequences modeling healthy, ischemic and dyssynchrony cases was generated for that purpose. This database is made publicly available to the community. It combines recent advances in electromechanical and ultrasound modeling. For modeling heart mechanics, the Bestel-Clement-Sorine electromechanical model was applied to a realistic geometry. For ultrasound modeling, we applied a fast simulation technique to produce realistic images on a set of scatterers moving according to the electromechanical simulation result. Tracking and strain accuracies were computed and compared for all evaluated algorithms. For tracking, all methods were estimating myocardial displacements with an error below 1 mm on the ischemic sequences. The introduction of a dilated geometry was found to have a significant impact on accuracy. Regarding strain, all methods were able to recover timing differences between segments, as well as low strain values. On all cases, radial strain was found to have a low accuracy in comparison to longitudinal and circumferential components.

Personalization of a cardiac electromechanical model using reduced order unscented Kalman filtering from regional volumes.

Patient-specific cardiac modeling can help in understanding pathophysiology and therapy planning. However it requires to combine functional and anatomical data in order to build accurate models and to personalize the model geometry, kinematics, electrophysiology and mechanics. Personalizing the electromechanical coupling from medical images is a challenging task. We use the Bestel-Clément-Sorine (BCS) electromechanical model of the heart, which provides reasonable accuracy with a reasonable number of parameters (14 for each ventricle) compared to the available clinical data at the organ level. We propose a personalization strategy from cine MRI data in two steps. We first estimate global parameters with an automatic calibration algorithm based on the Unscented Transform which allows to initialize the parameters while matching the volume and pressure curves. In a second step we locally personalize the contractilities of all AHA (American Heart Association) zones of the left ventricle using the reduced order unscented Kalman filtering on Regional Volumes. This personalization strategy was validated synthetically and tested successfully on eight healthy and three pathological cases.

Preliminary specificity study of the Bestel-Clément-Sorine electromechanical model of the heart using parameter calibration from medical images.

Patient-specific cardiac modelling can help in understanding pathophysiology and predict therapy effects. This requires the personalization of the geometry, kinematics, electrophysiology and mechanics. We use the Bestel-Clément-Sorine (BCS) electromechanical model of the heart, which provides reasonable accuracy with a reduced parameter number compared to the available clinical data at the organ level. We propose a preliminary specificity study to determine the relevant global parameters able to differentiate the pathological cases from the healthy controls. To this end, a calibration algorithm on global measurements is developed. This calibration method was tested successfully on 6 volunteers and 2 heart failure cases and enabled to tune up to 7 out of the 14 necessary parameters of the BCS model, from the volume and pressure curves. This specificity study confirmed domain-knowledge that the relaxation rate is impaired in post-myocardial infarction heart failure and the myocardial stiffness is increased in dilated cardiomyopathy heart failures.

Understanding the mechanisms amenable to CRT response: from pre-operative multimodal image data to patient-specific computational models.

This manuscript describes our recent developments towards better understanding of the mechanisms amenable to cardiac resynchronization therapy response. We report the results from a full multimodal dataset corresponding to eight patients from the euHeart project. The datasets include echocardiography, MRI and electrophysiological studies. We investigate two aspects. The first one focuses on pre-operative multimodal image data. From 2D echocardiography and 3D tagged MRI images, we compute atlas based dyssynchrony indices. We complement these indices with presence and extent of scar tissue and correlate them with CRT response. The second one focuses on computational models. We use pre-operative imaging to generate a patient-specific computational model. We show results of a fully automatic personalized electromechanical simulation. By case-per-case discussion of the results, we highlight the potential and key issues of this multimodal pipeline for the understanding of the mechanisms of CRT response and a better patient selection.

Rennet-induced gelation of calcium and phosphate supplemented skim milk subjected to CO2 treatment.

A Doehlert design was performed to study the effect of calcium and phosphate supplementation at 0 to 25 mmol/kg and 0 to 16 mmol/kg, respectively, on the rennet gelation of reconstituted skim milk subjected to pH-reversible CO(2) acidification. Supplemented reconstituted skim milk samples were acidified to pH 5.80 by the addition of CO(2) under pressure and depressurized under vacuum to restore the initial pH value. The second-order polynomial models satisfactorily predicted the effect of salt addition on the micellar molar Ca:P ratio and the average diameter of the casein micelles, whereas only trends were used in the analysis of the rennet-clotting behavior of salt-supplemented, CO(2)-treated milk. Whether added Ca was the most determinant factor on the micellar molar Ca:P ratio, added Pi (a mixture of Na(2)HPO(4) and NaH(2)PO(4)) was the most determinant factor on the other responses studied, and its effect was most pronounced when Ca was simultaneously added. By comparison with control samples, changes observed in this study were essentially due to salt supplementation and not to the CO(2) treatment. Therefore, this CO(2) treatment could be considered as an entirely reversible treatment rather than only pH-reversible, and predictions might be applied to untreated milk. In the case of Ca-supplemented milk, the micellar molar Ca:P ratio increased, the average micellar diameter decreased, and the rennet-clotting properties were improved, whereas opposite effects were observed upon Pi supplementation. Since modification of the micellar molar ratio is the result of change in the chemical composition of micellar calcium phosphate, the effect of calcium and phosphate supplementation on the rennet clotting of milk was found to be also dependent on the nature of the interaction between caseins and colloidal calcium phosphate.

Casein interactions studied by the surface plasmon resonance technique.

Surface plasmon resonance technique was investigated for the first time to study the apparent hydrophobicity and association properties of the major bovine caseins: alpha(s)-(alpha(s1)- and alpha(s2)-caseins in a 4:1 proportion), beta-, and kappa-caseins. The apparent hydrophobicities of the caseins were evaluated by a new method based on the binding level of casein on a hydrophobic sensor chip, and kinetic and equilibrium affinity constants were determined for the following casein interactions: alpha(s)/alpha(s), alpha(s)/beta, alpha(s)/kappa, beta/beta, and beta/kappa, using a sensor chip modified with covalent immobilized caseins. The study by surface plasmon resonance technology of these casein interactions under different conditions (pH, ionic strength, calcium concentration, chemical modification) demonstrated that, at neutral pH, electrostatic repulsive forces play an important role since an increase in ionic strength of the medium resulted in a stronger interaction. When charge repulsions were reduced by either acidification, increase in ionic strength, or dephosphorylation, casein interactions were reinforced, presumably due to weak attractive forces. Moreover, in this molecular model, we showed that addition of calcium greatly increased the binding response between the most phosphorylated caseins and that the added calcium (2 mM) participated directly in the formation of bridges between the phosphate groups of the casein molecules.

Effect of salt addition on the micellar composition of milk subjected to pH reversible CO2 acidification.

Response surface methodology was used to investigate the effect of salt supplementation on the micellar composition of reconstituted skim milk subjected to acidification by CO2 pressure to pH 5.8, followed by depressurization under vacuum. Using a Doehlert design, calcium and phosphate were added to skim milk in the range of 0 to 25 mmol/kg and 0 to 16 mmol/kg of milk, respectively, and the pH was adjusted to 6.65 +/- 0.02. After carbonation, the milk sample was depressurized, and the pH returned to its initial value without modification of the ionic strength. Micellar composition was assessed by the concentration of micellar Ca, P, Mg, and protein, and the buffering properties of milk. The second order polynomial models satisfactorily predicted the effect of salt supplementation on the micellar composition (R2adj > 0.75). Added calcium was the most determinant factor, and favored the removal of Ca, P, Mg, and proteins from the soluble phase to the micellar phase when this addition was less than 17.5 mmol/kg of milk. Above this concentration, only the concentration of micellar Ca increased. The buffering response surface showed that the amount of micellar calcium phosphate increased to a maximum upon addition of 17.5 mmol of Ca/kg. By comparison with a control sample (supplemented but untreated skim milk), changes were essentially due to salt supplementation and not to the CO2 treatment. We suggest that Ca formed micellar calcium phosphate when added at a concentration less than 17.5 mmol/kg; whereas above this concentration, Ca bound directly to micellar proteins.