Effect of center of rotation of angulation-based levelling osteotomy on instantaneous center of rotation ex vivo.

Cranial cruciate ligament rupture is a common cause of femorotibial instability in dogs. Despite numerous techniques being described for achieving joint stabilization, no consensus exists on the optimal management strategy. This ex vivo study utilized the path of the instantaneous center of rotation (ICR) to compare normal, pathological and treated joints. Fluoroscopic recordings of seven limbs from a previous study of canine stifle joint stability following center of rotation of angulation-based levelling osteotomy (CBLO) with and without hamstring loading were analyzed using least-squares approximation of the ICR and estimation of percentage gliding (vs. rolling) to determine if alterations in ICR path and gliding caused by CCL transection and following meniscal release could be normalized by CBLO. In intact joints, the ICR path was located mid-condyle, but this shifted significantly proximally and caudally following CCL transection and medial meniscal release (p < 0.007, p < 0.04). Hamstring loading resulted in qualitative and some quantitative improvements in joint movement based on percentage gliding movement analysis. The ICR path after CBLO remained significantly different to the intact location with or without a hamstring load (p < 0.02, p < 0.04), potentially consistent with CBLO aims of mild residual instability. CBLO resulted in percentage gliding characteristics not significantly different to intact joints (p > 0.08). Qualitative improvements in ICR path and percentage gliding quantities and variability suggest that hamstring loading positively influences joint biomechanics and that further investigation of this role ex vivo and clinically is warranted.

Objective and owner-reported outcomes after modified cranial closing wedge ostectomy: a case series.

Immediate and longer-term outcomes of a cranial closing wedge ostectomy variant for management of canine cranial cruciate ligament disease were assessed in this single-center retrospective consecutive study. Records and radiographs were retrieved and assessed by three independent observers to evaluate tibial plateau angle, anatomical-mechanical axis angle, tibial tuberosity distalization, and mechanical axis length before and after surgery. Kinetic gait analysis and owner questionnaires were used to assess clinical outcomes. Seventeen stifles from fifteen dogs were evaluated radiographically. Mean error from target tibial plateau angle was 0.4 degrees. Anatomical-mechanical axis angles reduced from mean 2.9 degrees preoperatively to mean - 0.9 degrees postoperatively. Tibial tuberosity distalization was mean 5.0% of mechanical axis length, and mean reduction in mechanical axis length was 0.1%. Increased tibial plateau angles were noted in 8/17 stifles, with a mean of 9.6 degrees at short-term follow-up. Major complications were observed in 9/17 stifles. Long term follow-up (mean 832 days) was obtained with gait analysis in 8/15 dogs and with questionnaire in 11/15. Most dogs (9/11) were weakly to moderately affected by osteoarthritis symptoms. All values for peak vertical force and vertical impulse normalized to body weight exceeded local lower reference limits for normal dogs, indicating acceptable limb use. Satisfactory immediate and long-term clinical outcomes appear to be possible with this technique, but the high incidence of shorter-term complications may caution against the technique or the fixation and management described here.

Cranial closing wedge ostectomies for management of canine cranial cruciate ligament insufficiency: Comparison and geometric modelling of errors.

Variants of the cranial closing wedge ostectomy (CCWO) may be used to manage cranial cruciate ligament deficient stifles by reduction of the tibial plateau angle (TPA). Concerns have been raised about predictability of achieving target TPA, limb shortening, axis shift, and distalization of the tibial tuberosity. Landmarks derived from tibial radiographs (n = 50) by 5 observers, along with outlines of the cranial and caudal proximal tibial cortices, were used to simulate six CCWO variants. Tested variants were Slocum-type (n = 2), modified (n = 2), isosceles, and anatomical-mechanical axis (AMA)-based CCWO. Observer specific landmarks were used to model pre- and postoperative errors in TPA measurement. Mean landmarks were used to compare key outcome variables between the variants, as well as modelling errors in positioning the wedge apex. Variants differed markedly in TPA, axis shift, mechanical axis length changes, and tibial tuberosity distalization, with more proximally positioned wedges performing better than distally positioned wedges. Errors in TPA identification appeared partially self-correcting due to altered axis shifts. Craniocaudal shifts in wedge apex position had the most severe effects on outcome variables, especially in shorter tibiae with greater initial TPA values. Recent CCWO variants are likely to achieve a satisfactory postoperative TPA with limited axis shift. The AMA-based CCWO technique appears to influence MA length and tibial tuberosity position the least, and apart from the effect on TPA where no advantage could be discerned, it appeared more robust in the face of wedge apex positioning errors than the other techniques.

Ideal Anchor Points for Patellar Anti-rotational Sutures for Management of Medial Patellar Luxation in Dogs: A Radiographic Survey.

OBJECTIVE: The aim of this study was to identify the ideal anchor point for patellar anti-rotational sutures for adjunctive stabilization of medial patellar luxation in both small and large breed dogs. STUDY DESIGN: Retrospective radiographic survey was performed on 110 stifles from 101 dogs. Radiographs were grouped based on patient weight (≤15 kg; >15 kg) and diagnosis (medial patellar luxation, cranial cruciate ligament rupture, and normal joints). Radiographic measurements included: the proximal, middle, and distal points of the trochlear ridge, the caudal aspect of Blumensaat's line (roof of the intercondylar notch), the centre of the lateral fabella, as well as the "best-fit" centre of a circle overlying the trochlea. These landmark coordinates were used to calculate radii for comparison, and for scaling between joints. RESULTS: Use of the fabellar centre resulted in larger radii (corrected p <0.001) than those from the best-fit circle centre for all but one combination of patient group and trochlear end point locations. Using the best-fit circle centre, radius variation was less marked than with the fabellar centre. Significant differences in location for centres of the best-fit circle and fabella were seen across all patient categories (Pillai's trace p <0.001). CONCLUSION: The fabella is unlikely to be the best choice for anchoring a patellar anti-rotational suture. Use of the best-fit circle centre to place a suture anchor should be preferred to maximise suture isometry during joint flexion and extension in large and small breed dogs.

Effect of center of rotation of angulation-based leveling osteotomy on ex vivo stifle joint stability following cranial cruciate ligament transection and medial meniscal release with and without a hamstring load.

OBJECTIVE: To evaluate the effect of center of rotation of angulation (CORA)-based leveling osteotomy (CBLO) and hamstring load on stifle stability following cranial cruciate ligament transection (CCLx) and medial meniscal release (MMR). STUDY DESIGN: Ex vivo experimental study. SAMPLE POPULATION: Cadaver hind limb preparations (n = 7). METHODS: After instrumentation, constant quadriceps and gastrocnemius loads with an optional hamstring load in a 3:1:0.6 ratio were applied, and stifles were extended from fully flexed using an electrical motor during fluoroscopic recording. The recording process was repeated after each of CCLx, MMR and CBLO and the extracted landmark coordinates were used for calculation of cranial tibial translation (CTT) and patellar ligament angle (PTA). RESULTS: Mean initial tibial plateau angle was 28.1°: post-CBLO the mean was 9.7°. Cranial tibial translation developed from 50° and 75° with CCLx and MMR respectively (p < .04, < .02) without hamstring loading. Hamstring loading mitigated CTT due to CCLx and delayed CTT until 120° for MMR (P < .02) in this model. CBLO prevented CTT, except at 140° without hamstring loading (P = .01). Similar results were seen for PTA, but CBLO curves were parallel to and lower than intact values at all tested angles (P < .04), consistent with induced effective joint flexion. CONCLUSION: CBLO to a target tibial plateau angle of 10° largely eliminated CTT induced by CCLx and MMR. Hamstring loads of 20% quadriceps load improved stifle stability in this model. IMPACT: Stifle stability following CBLO appears to be multifactorial and depends on meniscal integrity, joint angle, and hamstring strength.

Neurobehavioral toxicity of carbon nanotubes in mice.

OBJECTIVES: The aim of this study was to evaluate neurobehavioral toxicity of single-walled (SWNTs) and multiwalled carbon nanotubes (MWNTs) in mice. METHODS: Male NMRI mice were randomized into 5 groups ( n = 10 each): Normal control (NC) group was injected intraperitoneally (i.p.) with phosphate-buffered saline (PBS) solution (pH 7.8; ca. 1 mL), MW80 and MW800 groups were injected with either i.p. 80 or 800 mg kg-1 MWNTs suspended in 1 mL of PBS and SW80 and SW800 groups were injected with either i.p. 80 or 800 mg kg-1 SWNTs suspended in 1 mL of PBS. After 2 weeks, five mice from each group were evaluated for brain-derived neurotrophic factor (BDNF) messenger RNA expression and protein content of brain tissues. Locomotion, anxiety, learning and memory, and depression were measured by open field test (OFT), elevated plus-maze (EPM), object recognition test (ORT), and forced swimming test (FST), respectively. RESULTS: Ambulation time and center arena time in the OFT did not change among groups. In the EPM paradigm, SWNTs (800 mg kg-1) and MWNTs (80 and 800 mg kg-1) showed an anxiogenic effect. In ORT, MWNTs (80 mg kg-1) increased the discrimination ratio while in FST, MWNTs showed a depressant effect as compared to vehicle. The BDNF gene expression in mice treated with 80 and 800 mg kg-1 SWNTs or 80 mg kg-1 MWNTs decreased as compared to NC mice although BDNF gene expression increased in mice that were treated with 800 mg kg-1 MWNTs. The whole brain BDNF protein content did not change among groups. CONCLUSION: Our study showed that i.p. exposure to carbon nanotubes (CNTs) may result in behavioral toxicity linked with expression of depression or anxiety that depends on the type of CNTs. In addition, exposure to CNTs changed BDNF gene expression.