Influence of Epoxy Functional Chain-Extenders on the Thermal and Rheological Properties of Bio-Based Polyamide 10.10.

Bio-based polyamide 10.10 (PA 10.10) has excellent properties compared to other bio-based polymers such as polylactic acid (PLA) or polyhydroxyalkanoates (PHAs) and is therefore used in more technical applications where higher strength is required. For foam and filament extrusion, a good balance between strength and stiffness of the polymer is needed. Therefore, two commercial chain-extenders (Joncryl® ADR types) with different epoxy functionalities are used to modify the melt properties of PA 10.10. The chain-extenders are used in a concentration range up to 1.25 wt.%. The range of glass transition temperature widens with increasing Joncryl® content, and the apparent activation energy shows a maximum at a concentration of 0.5 wt.%. Furthermore, the melting temperatures are constant and the crystallinity decreases with increasing chain-extender content due to the formation of branches. During the second heating run, a bimodal melting peak appeared, consisting of α-triclinic and pseudo γ-hexagonal crystals. The weight average molar masses (Mw) measured by gel permeation chromatography (GPC) increased linearly with increasing ADR 4400 content. In contrast, the compounds containing ADR 4468 show a maximum at 0.5 wt.% and it begins to decrease thereafter. The rheological data show an increase in viscosity with increasing chain-extender content due to branch formation. ATR spectra of the compounds show a decrease at the wavelength of the primary (3301 cm-1) and secondary (1634 cm-1) (-NH stretching in PA 10.10) amine, indicating that chain-extension, e.g., branching, takes place during compounding.

Observation of new states of liquid crystal 8CB under nonlinear shear conditions as observed via a novel and unique rheology/small-angle X-ray scattering combination.

New stable states of liquid crystal 8CB could be induced by nonlinear shear conditions and observed by a newly developed rheology/X-ray scattering setup using synchrotron X-ray radiation. Nonlinear oscillatory shear created a distorted sixth order orientational structure. Even when oscillatory shear is switched off, the induced structure remains stable and can be removed only by heating the system into the isotropic state. We assume the structure to be stabilized by defects that pin the new 6-fold phase.

Structure of the human voltage-dependent anion channel.

The voltage-dependent anion channel (VDAC), also known as mitochondrial porin, is the most abundant protein in the mitochondrial outer membrane (MOM). VDAC is the channel known to guide the metabolic flux across the MOM and plays a key role in mitochondrially induced apoptosis. Here, we present the 3D structure of human VDAC1, which was solved conjointly by NMR spectroscopy and x-ray crystallography. Human VDAC1 (hVDAC1) adopts a beta-barrel architecture composed of 19 beta-strands with an alpha-helix located horizontally midway within the pore. Bioinformatic analysis indicates that this channel architecture is common to all VDAC proteins and is adopted by the general import pore TOM40 of mammals, which is also located in the MOM.

Approaching the structure of human VDAC1, a key molecule in mitochondrial cross-talk.

The voltage dependent anion-channel, VDAC, is the major constitutive protein of the outer membrane of mitochondria. Functionally, VDAC is involved in the exchange of small metabolites over the mitochondrial outer membrane and supports enzymes of the cytoplasm with energy precursors i.e. ATP. Moreover, the channel alone or in complex with proteins of the inner mitochondrial membrane or the intermembrane space provides a basis for docking of cytosolic proteins which can regulate outer membrane permeability in several ways. Structurally, this channel has a bacterial origin by evolution and partly resembles bacterial porin functions. However, the structure seems more complex as a variety of interactions on both channel sides can occur. Therefore, our work described is aiming to determine the structure of VDAC at atomic resolution and together with functional data to understand better how this channel can carry out such a variety of differing functions.

Crystallization and preliminary X-ray crystallographic studies of human voltage-dependent anion channel isoform I (HVDAC1).

The major channel by which metabolites can pass through the outer mitochondrial membrane is formed by the voltage-dependent anion-channel (VDAC) family. Functionally, VDAC is involved in the limited exchange of ATP, ADP and small hydrophilic molecules across the outer membrane. Moreover, there is compelling evidence that VDAC isoforms in mammals may act in the cross-talk between mitochondria and the cytoplasm by direct interaction with enzymes involved in energy metabolism and proteins involved in mitochondrial-induced apoptosis. To obtain a high-resolution structure of this channel, human VDAC protein isoform I was overproduced in Escherichia coli. After refolding and testing the correct fold using circular dichroism, a subsequent broad-range screening in different detergents resulted in a variety of crystals which diffracted to 3.5 A resolution. The crystal lattice belongs to the trigonal space group P321, with unit-cell parameters a = 78.9, c = 165.7 A and one monomer in the asymmetric unit.

High-level expression, refolding and probing the natural fold of the human voltage-dependent anion channel isoforms I and II.

The voltage-dependent anion channel (VDAC) is the major protein found in the outer membrane of mitochondria. The channel is responsible for the exchange of ATP/ADP and the translocation of ions and other small metabolites over the membrane. In order to obtain large amounts of pure and suitably folded human VDAC for functional and structural studies, the genes of the human isoforms I and II (HVDAC1 and HVDAC2) were cloned in Escherichia coli. High-level expression led to inclusion body formation. Both proteins could be refolded in vitro by adding denatured protein to a solution of zwitterionic or nonionic detergents. A highly efficient and fast protocol for refolding was developed that yielded more than 50 mg of pure human VDACs per liter of cell culture. The native and functional state of the refolded porins was probed by Fourier transform infrared spectroscopy to determine the secondary structure composition and by electrophysiological measurements, demonstrating the pore-forming activity of HVDAC1. Furthermore, binding of HVDAC1 to immobilized ATP was demonstrated. Limited proteolysis of HVDAC1 protein embedded in detergent micelles in combination with matrix-assisted laser desorption ionization mass spectrometric analysis was applied to identify micelle-exposed regions of the protein and to develop an improved topology model. Our analysis strongly suggests a 16-stranded, antiparallel beta-barrel with one large and seven short loops and turns. Initial crystallization trials of the protein yielded crystals diffracting to 8 Angstrom resolution.

Correct folding of the beta-barrel of the human membrane protein VDAC requires a lipid bilayer.

Spontaneous membrane insertion and folding of beta-barrel membrane proteins from an unfolded state into lipid bilayers has been shown previously only for few outer membrane proteins of Gram-negative bacteria. Here we investigated membrane insertion and folding of a human membrane protein, the isoform 1 of the voltage-dependent anion-selective channel (hVDAC1) of mitochondrial outer membranes. Two classes of transmembrane proteins with either alpha-helical or beta-barrel membrane domains are known from the solved high-resolution structures. VDAC forms a transmembrane beta-barrel with an additional N-terminal alpha-helix. We demonstrate that similar to bacterial OmpA, urea-unfolded hVDAC1 spontaneously inserts and folds into lipid bilayers upon denaturant dilution in the absence of folding assistants or energy sources like ATP. Recordings of the voltage-dependence of the single channel conductance confirmed folding of hVDAC1 to its active form. hVDAC1 developed first beta-sheet secondary structure in aqueous solution, while the alpha-helical structure was formed in the presence of lipid or detergent. In stark contrast to bacterial beta-barrel membrane proteins, hVDAC1 formed different structures in detergent micelles and phospholipid bilayers, with higher content of beta-sheet and lower content of alpha-helix when inserted and folded into lipid bilayers. Experiments with mixtures of lipid and detergent indicated that the content of beta-sheet secondary structure in hVDAC1 decreased at increased detergent content. Unlike bacterial beta-barrel membrane proteins, hVDAC1 was not stable even in mild detergents such as LDAO or dodecylmaltoside. Spontaneous folding of outer membrane proteins into lipid bilayers indicates that in cells, the main purpose of membrane-inserted or associated assembly factors may be to select and target beta-barrel membrane proteins towards the outer membrane instead of actively assembling them under consumption of energy as described for the translocons of cytoplasmic membranes.

A functional Ni-Ni-[4Fe-4S] cluster in the monomeric acetyl-CoA synthase from Carboxydothermus hydrogenoformans.

In anaerobic microorganisms employing the acetyl-CoA pathway, acetyl-CoA synthase (ACS) and CO dehydrogenase (CODH) form a complex (ACS/CODH) that catalyzes the synthesis of acetyl-CoA from CO, a methyl group, and CoA. Previously, a [4Fe-4S] cubane bridged to a copper-nickel binuclear site (active site cluster A of the ACS component) was identified in the ACS(Mt)/CODH(Mt) from Moorella thermoacetica whereas another study revealed a nickel-nickel site in the open form of ACS(Mt), and a zink-nickel site in the closed form. The ACS(Ch) of the hydrogenogenic bacterium Carboxydothermus hydrogenoformans was found to exist as an 82.2-kDa monomer as well as in a 1:1 molar complex with the 73.3-kDa CODHIII(Ch). Homogeneous ACS(Ch) and ACS(Ch)/CODHIII(Ch) catalyzed the exchange between [1-(14)C]acetyl-CoA and (12)CO with specific activities of 2.4 or 5.9 micromol of CO per min per mg, respectively, at 70 degrees C and pH 6.0. They also catalyzed the synthesis of acetyl-CoA from CO, methylcobalamin, corrinoid iron-sulfur protein, and CoA with specific activities of 0.14 or 0.91 micromol of acetyl-CoA formed per min per mg, respectively, at 70 degrees C and pH 7.3. The functional cluster A of ACS(Ch) contains a Ni-Ni-[4Fe-4S] site, in which the positions proximal and distal to the cubane are occupied by Ni ions. This result is apparent from a positive correlation of the Ni contents and negative correlations of the Cu or Zn contents with the acetyl-CoA/CO exchange activities of different preparations of monomeric ACS(Ch), a 2.2-A crystal structure of the dithionite-reduced monomer in an open conformation, and x-ray absorption spectroscopy.