A NiO-nanostructure-based electrochemical sensor functionalized with supramolecular structures for the ultra-sensitive detection of the endocrine disruptor bisphenol S in an aquatic environment.

Herein, NiO nanoparticles (NPs) functionalized with a para-hexanitrocalix[6]arene derivative (p-HNC6/NiO) were synthesized by using a facile method and applied as a selective electrochemical sensor for the determination of bisphenol S (BPS) in real samples. Moreover, the functional interactions, phase purities, surface morphologies and elemental compositions of the synthesized p-HNC6/NiO NPs were investigated via advanced analytical tools, such as Fourier-transform infrared (FT-IR) spectroscopy, X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and energy dispersive X-ray spectroscopy (EDX). Additionally, the synthesized p-HNC6/NiO NPs were cast on the surface of a bare glassy carbon electrode (GCE) via a drop casting method, which resulted in uniform deposition of p-HNC6/NiO/GCE over the surface of the GCE. Additionally, the developed p-HNC6/NiO/GCE sensor demonstrated an outstanding electrochemical response to BPS under optimized conditions, including a supporting electrolyte, a Briton-Robinson buffer electrolyte at pH 4, a scan rate of 110 mV s-1 and a potential window of between -0.2 and 1.0 V. The wide linear dynamic range was optimized to 0.8-70 µM to obtain a brilliant linear calibration curve for BPS. The limit of detection (LOD) and limit of quantification (LOQ) of the developed sensor were estimated to be 0.0059 and 0.019 µM, respectively, which are lower than those of reported sensors for BPS. The feasibility of the developed method was successfully assessed by analyzing the content of BPS in waste water samples, and good recoveries were achieved.

Synthesis of PVP-capped trimetallic nanoparticles and their efficient catalytic degradation of organic dyes.

The study proposes a simple and efficient way to synthesize a heterogeneous catalyst that can be used for the degradation of organic dyes. A simple and fast chemical process was employed to synthesize Au: Ni: Co tri-metal nanohybrid structures, which were used as a catalyst to eliminate toxic organic dye contamination from wastewater in textile industries. The catalyst's performance was tested by degrading individual dyes as well as mixtures of dyes such as methylene blue (MB), methyl orange (MO), methyl red (MR), and Rose Bengal (RB) at various time intervals. The experimental results show the catalytic high degradation efficiency of different dyes achieving 72-90% rates in 29 s. Moreover, the material displayed excellent recycling stability, maintaining its degradation efficiency over four consecutive runs without any degradation in performance. Overall, the findings of the study suggest that these materials possess efficient catalytic properties, opening avenues toward their use in clean energy alternatives, environmental remediation, and other biological applications.

Electrophoretic Fabrication of ZnO/CuO and ZnO/CuO/rGO Heterostructures-based Thin Films as Environmental Benign Flexible Electrode for Supercapacitor.

Sustainable fabrication of flexible hybrid supercapacitor electrodes is extensively investigated during the current era to solve global energy problems. Herein, we used a cost-effective and efficient electrophoretic deposition (EPD) approach to fabricate a hybrid supercapacitor electrode. ZnO/CuO and ZnO/CuO/rGO heterostructure were prepared by sol-gel synthesis route and were electrophoretically deposited on indium tin oxide (ITO) substrate as a thin uniform layer using 1 V for 20 min at 50 mV/s. ZnO/CuO and ZnO/CuO/rGO heterostructure coated ITOs were then employed as the working electrode in a three-electrode setup for supercapacitor measurements. The fabricated electrodes have been investigated by Galvanostatic charge-discharge (GCD), electrochemical impedance spectroscopy (EIS), and cyclic voltammetry (CV) to study their charge storage properties. ZnO/CuO revealed a specific capacitance of 1945 F g-1 at 2 mV/s and 999 F g-1 at 5 A g-1. However, an increased specific capacitance of 2305 F g-1 was measured for ZnO/CuO/rGO heterostructure at 2 mV/s and 1235 F g-1 at 5 A g-1. The lower internal resistance was observed for ZnO/CuO/rGO heterostructure, indicating good conductivity of the electrode material. Thus, the overall results of the current study suggest that EPD-assisted ZnO/CuO/rGO heterostructure hybrid electrode possess a substantial potential for energy storage as a supercapacitor.

Highly selective, sensitive and simpler colorimetric sensor for Fe2+ detection based on biosynthesized gold nanoparticles.

Herein, we describe the fabrication of green bell pepper, Capsicum annuum L. extract capped gold nanoparticles (CA-AuNPs) in aqueous medium using tetrachloroaurate (HAuCl4·3H2O) as precursor salt and sodium hydroxide (NaOH) solution as accelerator as well as pH adjuster. Formation of CA-AuNPs was verified via colour change from yellowish to ruby red with further confirmation through surface plasmon resonance (SPR) band at 519 nm using ultraviolet violet-visible (UV-Vis) spectroscopy. Other characterizations techniques include, Fourier transform infra-red (FTIR) spectroscopy, atomic force microscopy (AFM), dynamic light scattering (DLS) with Zeta-potential analysis (ZPA) and X-ray diffraction (XRD) method. The resulting AuNPs were efficaciously implemented as highly sensitive colorimetric sensor for selective detection of Fe2+ in the presence of several interfering cations including Fe3+. Importantly, the fabricated CA-AuNPs based colorimetric sensor functioned linearly in the range of 0.3-7.0 ppb Fe2+, based on increasing absorption intensity with R2 value of 0.9938 using UV-Vis spectrometry. The limit of detection (LOD) and limit of quantification (LOQ) for Fe2+ were estimated as 0.036 and 0.12 ppb, respectively. Finally, the sensor was effectively tested for determination of Fe2+ in some locally collected real water samples.

Application of synthesized copper nanoparticles using aqueous extract ofZiziphus mauritiana L. leaves as a colorimetric sensor for the detection of Ag.

The presented work demonstrates the preparation of copper nanoparticles (CuNPs) via aqueous leaves extract of Ziziphus mauritiana L. ( Zm ) using hydrazine as a reducing agent. Various parameters such as volume of extract, concentration of hydrazine hydrate, concentration of copper chloride, and pH of the solution were optimized to obtain Ziziphus mauritiana L. leaves extract derived copper nanoparticles ( Zm -CuNPs). Brownish red color was initial indication of the formation of Zm -CuNPs while it was confirmed by surface plasmon resonance (SPR) band at wavelength of 584 nm using ultraviolet-visible (UV-vis) spectroscopy. Synthesized Zm -CuNPs were characterized by Fourier transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), atomic force microscopy (AFM), and X-ray diffractometry (XRD). AFM images showed that the particle size of Zm -CuNPs was from 7 to 17 nm with an average size of 11.3 nm. Fabricated sensor ( Zm -CuNPs) were used as a colorimetric sensor for the detection of Ag + at a linear range between 0.67 × 10 -6 - 9.3 × 10 -6 with R 2 value of 0.992. For real water samples, limit of quantification (LOQ) and limit of detection (LOD) for Ag + was found to be 330 × 10 -9 and 100 × 10 -9 , respectively.