RESUMO
AIM: To assess the possibility of vertical alveolar ridge augmentation by means of activation of the periosteum. MATERIALS AND METHODS: Six adult male Beagle dogs were used for the study. All premolars and first molars were extracted, and one vertical saucer-shaped bony defect was created on each side of the mandible. After 3 months of healing, full-thickness muco-periosteal flaps were elevated, and one distraction device was placed on each side of the mandible. The distraction plate was left submerged, and the activation mechanism connected to the distraction rod was exposed intra-orally. The protocol of periosteal activation (PP: periosteal 'pumping') was initiated after a latency of 7 days. The alternation of activation and relaxation at the rate of 0.35 mm/12 h during 5 days was followed by the sole activation of 0.35 mm/12 h for 5 days (PP group). Devices were left inactivated on the contralateral control side of the mandible (C group). All animals were euthanized after 8 weeks of consolidation. Samples were analysed histologically and by means of micro-CT. RESULTS: New mature lamellar bone was formed over the pristine bone in all groups. More intensive signs of bone modelling and remodelling were observed in the PP group compared to the C group. Mean new bone, bone marrow, connective tissue and total volumetric densities were greater in the PP group (p < 0.001, p = 0.001, p = 0.003 and p < 0.001, respectively). No differences were observed in the relative area parameters. Total tissue volume and bone volume were higher in the PP group (p = 0.031 and p = 0.076, respectively), while the bone mineral densities were higher in the C group (p = 0.041 and p = 0.003, respectively). Trabecular number, trabecular thickness and trabecular separation values were similar between the two groups. CONCLUSIONS: Regeneration of vertical alveolar bone ridge defects may be enhanced by activation of the periosteum, without the application of bone grafting materials.
RESUMO
BACKGROUND: Insufficient bone volume around an implant is a common obstacle when dental implant treatment is considered. Limited vertical or horizontal bone dimensions may lead to exposed implant threads following placement or a gap between the bone and implant. This is often addressed by bone augmentation procedures prior to or at the time of implant placement. This study evaluated bone healing when a synthetic TiO2 block scaffold was placed in circumferential peri-implant defects with buccal fenestrations. METHODS: The mandibular premolars were extracted and the alveolar bone left to heal for 4 weeks prior to implant placement in six minipigs. Two cylindrical defects were created in each hemi-mandible and were subsequent to implant placement allocated to treatment with either TiO2 scaffold or sham in a split mouth design. After 12 weeks of healing time, the samples were harvested. Microcomputed tomography (MicroCT) was used to investigate defect fill and integrity of the block scaffold. Distances from implant to bone in vertical and horizontal directions, percentage of bone to implant contact and defect fill were analysed by histology. RESULTS: MicroCT analysis demonstrated no differences between the groups for defect fill. Three of twelve scaffolds were partly fractured. At the buccal sites, histomorphometric analysis demonstrated higher bone fraction, higher percentage bone to implant contact and shorter distance from implant top to bone 0.5 mm lateral to implant surface in sham group as compared to the TiO2 group. CONCLUSIONS: This study demonstrated less bone formation with the use of TiO2 scaffold block in combination with implant placement in cylindrical defects with buccal bone fenestrations, as compared to sham sites.