In vitro effects of water-soluble metals present in UK particulate matter.

The water-soluble metal content of 1950s London smogs and modern particulate matter (PM) are associated with adverse health effects. This study aimed to elucidate the bioreactivity of these metals alone and in mixtures and to investigate the comparative bioreactivities of a surrogate mixture and a PM sample. These revealed similar bioreactivities. A bioreactivity hierarchy of these metals was established: Fe2+ > Cu2+ > Fe3+ > VO2+ > Zn2+ > As3+ = Pb2+ = Mn2+ = VO3-. Secondary components (i.e., chlorides, sulfates, nitrates) did not affect metal bioreactivity, whereas oxidation state was important. Synergism was observed between zinc and various metal ions (Cu2+, Fe3+, VO2+). In conclusion, low-valence transition metals are key to PM bioreactivity.

Variations in the source, metal content and bioreactivity of technogenic aerosols: a case study from Port Talbot, Wales, UK.

Atmospheric aerosol samples were collected during different prevailing wind directions from a site located close to a busy motorway, a major steelworks, and the town of Port Talbot (Wales, UK). A high-volume collector was used (1100 l/min), enabling relatively large amounts of particulate matter (PM(10-2.5) and PM(2.5)) samples to be obtained on a polyurethane foam [PUF, H(2)N-C(O)O-CH(2)CH(3)] substrate over periods of 2-7 days. Four samples were chosen to exemplify different particle mixtures: SE- and NE-derived samples for particles moving along and across the motorway, a NW-derived sample from the town, and a mixed SW/SE-derived sample containing a mixture of particles from both steelworks and motorway. The latter sample showed the highest average collection rate (0.9 mg/h, 13 microg/m(3)) and included a prominent pollution episode when rainy winds were blowing from the direction of the steelworks. Both NW and SE samples were collected under dry conditions and show the same collection rate (0.7 mg/h, 10 microg/m(3)), whereas the NE sample was collected during wetter weather and shows the lowest rate (0.3 mg/h, 5 microg/m(3)). Scanning electron microscopy (SEM) and energy-dispersive X-ray microanalysis system (EDX) analyses show all samples are dominated by elemental and organic carbon compounds (EOCC) and nitrates, with lesser amounts of sulphates, felsic silicates, chlorides and metals. ICP-MS analyses show the SW/SE sample to be richest in metals, especially Fe, Zn, Ni, and Mn, these being attributed to an origin from the steelworks. The SE sample, blown along the motorway corridor, shows enhanced levels of Pb, V, Ti, As, and Ce, these metals being interpreted as defining a traffic-related chemical fingerprint. The NW sample shows a very low metal content. DNA plasmid assay data on the samples show TM(50) values varying from 66 to 175 microg/ml for the adjusted whole sample and 89 to 203 microg/ml for the soluble fraction. The SW/SE-mixed metalliferous sample is the most bioreactive (both whole and soluble) and the soluble fraction of the metal-depleted NW sample is the least bioreactive. The metal content of the aerosol samples, especially soluble metals such as Zn, is suggested to be the primary component responsible for oxidative damage of the DNA, and therefore most implicated in any health effects arising from the inhalation of these particulate cocktails.