RESUMO
Comprehensive two-dimensional liquid chromatography (LC × LC) is an attractive separation technique that allows achieving high peak capacities and information on chemical correlations. Unfortunately, its application in industrial practice is still not widespread due to limiting factors such as complex method development, tedious method optimization and solvent-incompatibility (such as solvent-strength mismatch or immiscibility experienced during fraction transfer). A severe case of solvent-incompatibility is encountered in the comprehensive coupling of normal-phase LC and reversed-phase LC (NPLC × RPLC). NPLC × RPLC is considered a desirable LC × LC system, especially for the characterization of synthetic polymers, due to the high orthogonality of the two retention mechanisms. However, its experimental realization often suffers from solvent-injection effects in the RPLC dimension, such as peak-deformation, peak-splitting, or even unretained elution ("breakthrough") of sample components. Such a decrease in performance or loss of retention is highly dependent on the types of solvents used. To explore the boundaries of solvent compatibility, we applied large-volume injections (LVI) of reference analytes (e.g. alkyl benzenes; ethoxylate and propoxylate polymers) dissolved in water-immiscible sample solvents, such as dichloromethane, n-hexane, and isooctane in fast water-based gradient RPLC separations (using methanol or acetonitrile as eluent). It was found that, when using highly aqueous initial gradient conditions, hydrophobic sample diluents were retained and eluted during the applied gradient. Depending on the relative retention of the retained diluent and the sample analytes, good chromatograms for LVI of immiscible solvents were obtained, comparable with injections under ideal conditions. The conclusions from injection experiments in aqueous RPLC were verified by coupling an NPLC system with a gradient from isooctane to tetrahydrofuran and an RPLC system with a gradient from water to acetonitrile in an online comprehensive NPLC × RPLC separation of a mixture of propoxylate polymers. The separation provided separation of the polymers based on their number of hydroxyl end-groups (NPLC) and oligomer chain-length (RPLC), without suffering from significant band-broadening effects due to solvent-mismatch upon injection in the second-dimension RPLC system.
Assuntos
Cromatografia de Fase Reversa , Água , Interações Hidrofóbicas e Hidrofílicas , Polímeros , SolventesRESUMO
Understanding the relation between chemical characteristics and properties of synthetic polymers is one of the challenges faced by analytical chemists in industry. This is a complex task, as polymers are not synthesized as single molecule, but are populations of chemically similar compounds with distributions over several properties. The latter include, for example, molecular weight, nature of end-groups (functionality), and chemical composition. In this paper, comprehensive two-dimensional liquid chromatography was used to determine the combined functionality-type and molecular-weight distributions of hydroxyfunctionalized propoxylates. Propoxylates derived from different initiators (one up to eight terminal hydroxyl groups) were separated in the first dimension using a gradient normal-phase LC separation (NPLC). In the second dimension ultra-high pressure size-exclusion chromatography separation (UHPSEC), further speciating distributions based on molecular size. The developed NPLC × SEC method with evaporative light-scattering detection can be used for the fast screening (< 30 min) of mutually dependent functionality-type and molecular-weight distributions of unknown propoxylates.
Assuntos
Polímeros , Cromatografia em Gel , Cromatografia Líquida , Peso MolecularRESUMO
Polyether polyols are often used in formulated systems, but their complete characterization is challenging, because of simultaneous heterogeneities in chemical composition, molecular weight and functionality. One-dimensional liquid chromatography-mass spectrometry is commonly used to characterize polyether polyols. However, the separation power of this technique is not sufficient to resolve the complexity of such samples entirely. In this study, comprehensive two-dimensional liquid chromatography hyphenated with high-resolution mass spectrometry (LC × LC-HRMS) was used for the characterization of (i) castor oil ethoxylates (COEs) reacted with different mole equivalents of ethylene oxide and (ii) a blended formulation consisting of glycerol ethoxylate, glycerol propoxylate and glycerol ethoxylate-random-propoxylate copolymers. Retention in the first (hydrophilic-interaction-chromatography) dimension was mainly governed by degree of ethoxylation, while the second reversed-phase dimension resolved the samples based on degree of propoxylation (blended formulation) or alkyl chain length (COEs). For different COE samples, we observed the separation of isomer distributions of various di-, tri- and tetra-esters, and such positional isomers were studied by tandem mass spectrometry (LC-MS/MS). This revealed characteristic fragmentation patterns, which allowed discrimination of the isomers based on terminal or internal positioning of the fatty-acid moieties and provided insight in the LC × LC retention behavior of such species.
Assuntos
Cromatografia Líquida/métodos , Éter/química , Polímeros/química , Espectrometria de Massas em Tandem/métodos , Óleo de Rícino/química , Cromatografia de Fase Reversa , Interações Hidrofóbicas e Hidrofílicas , Isomerismo , Espalhamento de RadiaçãoRESUMO
Polymer separations under non-conventional conditions have been explored to obtain a separation of long-chain branched polymers from linear polymers with identical hydrodynamic size. In separation media with flow-through channels of the same order as the size of the analyte molecules in solution, the separation and the elution order of polymers are strongly affected by the flow rate. At low flow rates, the largest polymers are eluted last. At high flow rates, they are eluted first. By tuning the channel size and flow rate, conditions can be found where separation becomes independent of molar mass or size of linear polymers. Long-chain branched polymers did experience lower migration rates under these conditions and can be separated from linear polymers. This type of separation is referred to as molecular-topology fractionation (MTF) at critical conditions. Separation by comprehensive two-dimensional molecular-topology fractionation and size-exclusion chromatography (MTF×SEC) was used to study the retention characteristics of MTF. Branching selectivity was demonstrated for three- and four-arm "star" polystyrenes of 3-5×10(6)g/mol molar mass. Baseline separation could be obtained between linear polymer, Y-shaped molecules, and X-shaped molecules in a single experiment at constant flow rate. For randomly branched polymers, the branching selectivity inevitably results in an envelope of peaks, because it is not possible to fully resolve the huge numbers of different branched and linear polymers of varying molar mass. It was concluded that MTF involves partial deformation of polymer coils in solution. The increased coil density and resistance to deformation can explain the different retention behavior of branched molecules.
Assuntos
Cromatografia em Gel , Polímeros/química , Polímeros/isolamento & purificação , Fracionamento Químico , Hidrodinâmica , Peso Molecular , Poliestirenos/química , SoluçõesRESUMO
Methods based on capillary electrophoresis (CE) have been developed to obtain the molar mass distribution (MMD) of glycerin-based polyols and details on the presence of mono- and difunctional byproducts in technical samples. Prior to the analyses the hydroxy end-groups of the trifunctional polyols were converted to chargeable and UV-active moieties with phthalic anhydride (PhAH) as the derivatization reagent. With a method of capillary zone electrophoresis (CZE) samples of glycerin-based polyols with average molar masses up to 6000 were separated according to their charge-to-size ratio. The separations were carried out with a buffer solution containing 50% (v/v) acetonitrile and 10 mM sodium tetraborate, and for detection UV absorption at 220 nm was measured. An approximately linear relation between the reciprocal of the effective mobilities and the degree of polymerisation of the glycerin-based polyols was found. Therefore, the proposed CZE system could be used to determine the degree of polymerisation and polydispersity of technical glycerin-based polyol samples. The effect of the presence of sodium dodecyl sulfate (SDS) in the buffer solution on the CE separation of linear polyethylene glycols (PEGs), polypropylene glycols (PPGs) and ethylene oxide-propylene oxide (EO-PO) copolymers with different molar masses was investigated. The interaction between the charged polymer derivatives and SDS ions in solution increased strongly with the degree of polymerisation and the amount PO in the chain of the polymeric compounds. This behaviour made it possible to invert the migration order of EO-PO containing polymers of different size. With a background electrolyte (BGE) composition of 10mM SDS and 25% (v/v) acetonitrile in borate buffer mono- and difunctional byproducts were separated from the main glycerin-based polyols based on their number of end-groups. Accurate quantities for the mono- and difunctional impurities in technical glycerin-based polyol products were determined.