Effect of non-thermal atmospheric plasma on the dentin-surface topography and composition and on the bond strength of a universal adhesive.

This study investigated the effect of application of non-thermal atmospheric plasma (NTAP) on the topography and composition of the dentin surface, as well as the microtensile bond strength (µTBS) of a universal adhesive to NTAP-treated dentin. Exposed flat dentin surfaces from human third molars were either treated with NTAP for 10 and 30 s or untreated (control). The dentin-surface topography and chemical composition were characterized by atomic force microscopy (n = 3) and Raman confocal spectroscopy (n = 5), respectively. The µTBS (n = 8) of Scotchbond Universal to dentin was determined after storage for 24 h and 1 yr, either by direct water exposure or under simulated pulpal pressure. In-situ zymography was used to evaluate the influence of NTAP on the dentin-enzymatic activity. Non-thermal atmospheric plasma produced no remarkable topographical or chemical alterations at the dentin surface; only the amount of phosphate decreased following 10 s of treatment with NTAP. After 1 yr of direct water exposure, the µTBS of NTAP-treated specimens did not differ statistically significantly from that of untreated controls, whereas simulated pulpal pressure-aging resulted in a significantly higher µTBS for NTAP-treated dentin. The dentin-enzymatic activity appeared to be treatment-dependent, but the untreated controls showed more intense fluorescence within the hybrid layer. Scotchbond Universal maintained its µTBS strength after 1 yr of direct water exposure and simulated pulpal pressure, although remarkable statistical differences between treatments were observed depending on the aging condition.

Monomer conversion, microhardness, internal marginal adaptation, and shrinkage stress of bulk-fill resin composites.

OBJECTIVE: To evaluate degree of conversion (DC), Knoop microhardness (KHN), internal marginal adaptation (IA), and polymerization shrinkage stress (PS) of one conventional and four bulk-fill composites. METHODS: Bulk-fill composites tested were Surefil SDR (SDR), Filtek Bulk-Fill (FBF), Tetric EvoCeram Bulk-Fill (TEC), and EverX Posterior (EXP). The conventional composite Herculite Classic (HER) was tested using both incremental and bulk-fill insertion techniques. Standardized Class I preparations (4-mm-depth) were made in extracted molars and restored with each product system (N=5). After 1-week wet storage, restorations were cross-sectioned and DC and KHN were evaluated at four depths (1, 2, 3, and 4mm) using confocal Raman spectroscopy and KHN techniques, respectively. Epoxy resin replicas of restorations were evaluated using scanning electron microscopy for IA. PS was determined using composite bonded to acrylic rods attached to a universal testing machine (N=5). RESULTS: Within bulk-fill products, only SDR and FBF demonstrated similar DC at all depths, and KHN values did not statistically differ among depths, except for TEC. Neither placement method nor depth affected KHN or DC, except the DC of HER bulk-fill at 4mm. Incrementally layered HER, and bulk-fills SDR and TEC demonstrated the lowest proportion of internal gaps. Highest and lowest PS values were measured for EXP and TEC, respectively. SIGNIFICANCE: DC with depth was not uniform among all bulk-fill materials, although no difference in KHN was found. Higher PS correlated positively with higher proportion of interfacial gaps. The incremental technique using conventional composite showed reduced gap formation.