Evaluation of wetting ability of five new saliva substitutes on heat-polymerized acrylic resin for retention of complete dentures in dry mouth patients: a comparative study.

INTRODUCTION: The aim of this study was to evaluate & compare the wetting ability of five saliva substitutes & distilled water on heat-polymerized acrylic resin. Contact angle of the saliva substitute on denture base can be taken as an indicator of wettability. Good wetting of heat-polymerized acrylic resin is critical for optimum retention of complete dentures. METHODS: Two hundred & forty samples of heat-polymerized acrylic resin were fabricated using conventional method. 240 samples divided into 6 groups with 40 samples in each group. Advancing & Receding contact angles were measured using Contact Angle Goniometer & DSA4 software analysis. RESULTS: Anova test was carried out to test the significance in difference of contact angle values in the six groups. The mean of advancing angle values & mean of receding angle values of all the six groups has shown statistically significant difference between the groups. The mean of angle of hysteresis values of all the six groups are statistically not significant between the groups. A multiple comparison using Bonferroni's test was carried out to verify the significance of difference between the contact angles in a pair of groups. Statistically significant difference was seen when Aqwet (Group II) was compared to Distilled water (Group I), Wet Mouth (Group III), E-Saliva (Group IV), Biotene (Group V), and Moi-Stir (Group VI). CONCLUSION: The contact angles of five saliva substitutes and distilled water were measured and compared. Group II (AQWET) has the lowest advancing and receding contact angle values and the highest angle of hysteresis on heat-polymerized acrylic resin. Based on contact angle values, Group II (AQWET) has the best wetting ability on heat-cured acrylic resins. The ability of saliva to wet the denture surface is one of the most important properties for complete denture retention in dry mouth cases.

Aloe vera for Dry Mouth Denture Patients - Palliative Therapy.

INTRODUCTION: Xerostomia (dry mouth) is dryness of the mouth which is due to reduced salivary flow. Lack of adequate saliva causes discomfort in denture wearing patients and decreases retention of dentures. The ability of saliva to wet the tissue surface is one of the most important properties for oral comfort and retention of complete denture in dry mouth patients. AIM: This study was conducted to evaluate and compare the wetting ability of therapeutic Aloe vera saliva substitute and commercially available Aqwet saliva substitute on heat-polymerized acrylic resin. Contact angle of liquid saliva substitute was considered as an indicator of wettability. MATERIALS AND METHODS: Aloe vera liquid (Aloe vera - Group I) and Aqwet saliva substitute (Aqwet - Group II) were compared in terms of their wetting ability. Forty samples of heat-polymerized acrylic resin were fabricated and divided into two groups with 20 samples in each. Advancing, receding contact angles and angle of hysteresis were measured using contact angle goniometer and DSA4 software analysis. Mann-Whitney U test was applied for statistical analysis of the study. RESULTS: The mean advancing angle and receding angle of Group I (Aloe vera) was smaller than Group II (Aqwet). Mean angle of hysteresis of Group I (Aloe vera) was higher than Group II (Aqwet). Mann-Whitney U test revealed that there is no significant difference in contact angles between the two groups. CONCLUSION: Wetting ability of Group I (Aloe vera) saliva substitute was found to be better compared to Group II (Aqwet) on heat-polymerized acrylic resin.

Bruxism: a literature review.

Parafunctional activities associated with the stomatognathic system include lip and cheek chewing, nail biting, and teeth clenching. Bruxism can be classified as awake or sleep bruxism. Patients with sleep bruxism are more likely to experience jaw pain and limitation of movement, than people who do not experience sleep bruxism. Faulty occlusion is one of the most common causes of bruxism that further leads to temporomandibular joint pain. Bruxism has been described in various ways by different authors. This article gives a review of the literature on bruxism since its first description.