Zinc- and Copper-Doped Mesoporous Borate Bioactive Glasses: Promising Additives for Potential Use in Skin Wound Healing Applications.

In this study, zinc (Zn)- and copper (Cu)-doped 13-93B3 borate mesoporous bioactive glasses (MBGs) were successfully synthesized using nitrate precursors in the presence of Pluronic P123. We benefited from computational approaches for predicting and confirming the experimental findings. The changes in the dynamic surface tension (SFT) of simulated body fluid (SBF) were investigated using the Du Noüy ring method to shed light on the mineralization process of hydroxyapatite (HAp) on the glass surface. The obtained MBGs were in a glassy state before incubation in SBF. The formation of an apatite-like layer on the SBF-incubated borate glasses was investigated by X-ray diffraction (XRD) and scanning electron microscopy (SEM). The incorporation of Zn and Cu into the basic composition of 13-93B3 glass led to changes in the glass transition temperature (Tg) (773 to 556 °C), particle size (373 to 64 nm), zeta potential (−12 to −26 mV), and specific surface area (SBET) (54 to 123 m2/g). Based on the K-means algorithm and chi-square automatic interaction detection (CHAID) tree, we found that the SFT of SBF is an important factor for the prediction and confirmation of the HAp mineralization process on the glasses. Furthermore, we proposed a simple calculation, based on SFT variation, to quantify the bioactivity of MBGs. The doped and dopant-free borate MBGs could enhance the proliferation of mouse fibroblast L929 cells at a concentration of 0.5 mg/mL. These glasses also induced very low hemolysis (<5%), confirming good compatibility with red blood cells. The results of the antibacterial test revealed that all the samples could significantly decrease the viability of Pseudomonas aeruginosa. In summary, we showed that Cu-/Zn-doped borate MBGs can be fabricated using a cost-effective method and also show promise for wound healing/skin tissue engineering applications, as especially supported by the cell test with fibroblasts, good compatibility with blood, and antibacterial properties.

Modified Sol-Gel Synthesis of Mesoporous Borate Bioactive Glasses for Potential Use in Wound Healing.

In this study, we successfully utilized nitrate precursors for the synthesis of silver (Ag)-doped borate-based mesoporous bioactive glass (MBGs) based on the 1393B3 glass formulation in the presence of a polymeric substrate (polyvinyl alcohol (PVA)) as a stabilizer of boric acid. The X-ray diffraction (XRD) analysis confirmed the glassy state of all the MBGs. The incorporation of 7.5 mol% Ag into the glass composition led to a decrease in the glass transition temperature (Tg). Improvements in the particle size, zeta potential, surface roughness, and surface area values were observed in the Ag-doped MBGs. The MBGs (1 mg/mL) had no adverse effect on the viability of fibroblasts. In addition, Ag-doped MBGs exhibited potent antibacterial activity against gram-positive and gram-negative species. In summary, a modified sol-gel method was confirmed for producing the Ag-doped 1393B3 glasses, and the primary in vitro outcomes hold promise for conducting in vivo studies for managing burns.

Hydroxyapatite Nanoparticles for Improved Cancer Theranostics.

Beyond their well-known applications in bone tissue engineering, hydroxyapatite nanoparticles (HAp NPs) have also been showing great promise for improved cancer therapy. The chemical structure of HAp NPs offers excellent possibilities for loading and delivering a broad range of anticancer drugs in a sustained, prolonged, and targeted manner and thus eliciting lower complications than conventional chemotherapeutic strategies. The incorporation of specific therapeutic elements into the basic composition of HAp NPs is another approach, alone or synergistically with drug release, to provide advanced anticancer effects such as the capability to inhibit the growth and metastasis of cancer cells through activating specific cell signaling pathways. HAp NPs can be easily converted to smart anticancer agents by applying different surface modification treatments to facilitate the targeting and killing of cancer cells without significant adverse effects on normal healthy cells. The applications in cancer diagnosis for magnetic and nuclear in vivo imaging are also promising as the detection of solid tumor cells is now achievable by utilizing superparamagnetic HAp NPs. The ongoing research emphasizes the use of HAp NPs in fabricating three-dimensional scaffolds for the treatment of cancerous tissues or organs, promoting the regeneration of healthy tissue after cancer detection and removal. This review provides a summary of HAp NP applications in cancer theranostics, highlighting the current limitations and the challenges ahead for this field to open new avenues for research.

Preparation and Characterization of Platelet Lysate (Pl)-Loaded Electrospun Nanofibers for Epidermal Wound Healing.

Skin defects are among the most prevalent and serious problems worldwide; it is necessary to provide appropriate coverage in order to reduce possible mortality risk and accelerate wound healing. In this study, we have designed a series of extracellular matrix (ECM)-mimicking nanofibrous scaffolds composed of both natural (gelatin (GEL) and chitosan (CS)) and synthetic (poly(ε-caprolactone) (PCL) and poly (vinyl alcohol) (PVA)) polymers. The 3D constructs (PCL/GEL-PVA/CS) were reinforced with 5% (w/w) of platelet lysate (PL) for promoting cells viability and mobility. The physicochemical characterizations of nanofibers confirmed suitable hydrophilicity, controlled degradability, and water uptake of 250.31 ± 62.74%, and 222.425 ± 86.37% for the PCL/GEL-PVA/CS and PCL/GEL-PVA/CS + PL nanofibers, respectively. The scanning electron microscopy (SEM) images exhibited the mean diameter of the fabricated fibers (PCL/GEL-PVA/CS) in the range of 454 ± 257 nm. The blended samples (PCL/GEL-PVA/CS) were also confirmed to have higher ultimate tensile stress (UTS) (3.71 ± 0.32 MPa). From a biological point of view, the fabricated scaffolds showed appropriate blood compatibility and great potential to avoid bacterial invasion. Altogether, the tailored fabrication of PCL/GEL-PVA/CS nanofibers may be considered a suitable construct for epidermal wound healing.

Mesoporous Silica Nanoparticles and Mesoporous Bioactive Glasses for Wound Management: From Skin Regeneration to Cancer Therapy.

Exploring new therapies for managing skin wounds is under progress and, in this regard, mesoporous silica nanoparticles (MSNs) and mesoporous bioactive glasses (MBGs) offer great opportunities in treating acute, chronic, and malignant wounds. In general, therapeutic effectiveness of both MSNs and MBGs in different formulations (fine powder, fibers, composites etc.) has been proved over all the four stages of normal wound healing including hemostasis, inflammation, proliferation, and remodeling. The main merits of these porous substances can be summarized as their excellent biocompatibility and the ability of loading and delivering a wide range of both hydrophobic and hydrophilic bioactive molecules and chemicals. In addition, doping with inorganic elements (e.g., Cu, Ga, and Ta) into MSNs and MBGs structure is a feasible and practical approach to prepare customized materials for improved skin regeneration. Nowadays, MSNs and MBGs could be utilized in the concept of targeted therapy of skin malignancies (e.g., melanoma) by grafting of specific ligands. Since potential effects of various parameters including the chemical composition, particle size/morphology, textural properties, and surface chemistry should be comprehensively determined via cellular in vitro and in vivo assays, it seems still too early to draw a conclusion on ultimate efficacy of MSNs and MBGs in skin regeneration. In this regard, there are some concerns over the final fate of MSNs and MBGs in the wound site plus optimal dosages for achieving the best outcomes that deserve careful investigation in the future.

Improved osteogenesis and angiogenesis of theranostic ions doped calcium phosphates (CaPs) by a simple surface treatment process: A state-of-the-art study.

Surface treatment of biomaterials could enable reliable and quick cellular responses and accelerate the healing of the host tissue. Here, a series of calcium phosphates (CaPs) were surface treated by hydrogen peroxide (H2O2) and the treatment effects were physicochemically and biologically evaluated. For this aim, as-synthesized CaPs doped with strontium (Sr2+), iron (Fe2+), silicon (Si4+), and titanium (Ti4+) ions were sonicated in H2O2 media. The results showed that the specific surface area and zeta potential values of the surface-treated CaPs were increased by ~50% and 25%, respectively. Moreover, the particle size and the band-gap (Eg) values of the surface-treated CaPs were decreased by ~25% and ~2-10%, respectively. The concentration of oxygen vacancies was increased in the surface-treated samples, which was confirmed by the result of ultraviolet (UV), photoluminescence (PL), Commission Internationale de l'éclairage (CIE 1931), and X-ray photoelectron spectroscopy (XPS) analyses. In vitro cellular assessments of surface-treated CaPs exhibited an improvement in cytocompatibility, reactive oxygen species generation (ROS) capacity, bone nodule formation, and the migration of cells up to ~8%, 20%, 35%, and 13%, respectively. Based on the obtained data, it can be stated that improved physicochemical properties of H2O2-treated CaPs could increase the ROS generation and subsequently enhance the biological activities. In summary, the results demonstrate the notable effect of the H2O2 surface treatment method on improving surface properties and biological performance of CaPs.

Inflammatory and immune response genes: A genetic analysis of inhibitor development in Iranian hemophilia A patients.

A major problem of hemophilia A (HA) treatment is the development of factor VIII (FVIII) inhibitor, which usually occurs shortly after initiating replacement therapy. Several studies showed the correlation between inhibitor development and polymorphisms in inflammatory and immune response genes of HA patients; however, literature data are not available to prove this association in Iranian population. The aim of this study was to investigate a possible association between FVIII inhibitor formation and the polymorphisms of 16 inflammatory and immune response genes in Iranian severe HA patients (FVIII activity < 1%). This case-control study was performed on 55 patients with severe HA inhibitors and 45 samples without inhibitors from Iranian Comprehensive Hemophilia Care center. After extraction of whole genomic DNA from blood samples and design of primers for 16 genes, the genotyping was performed by Tetra primer ARMS PCR, and the validation of single nucleotide polymorphisms was determined by DNA sequencing. The data indicated that there was a significant association between inhibitor development, and F13A1 (TT), DOCK2 (CC& CT), and MAPK9 (TT) genotypes. Moreover, a considerably increased inhibitor risk carrying T, C, and T allele for F13A1, DOCK2, and MAPK9 genes was observed in patients with inhibitors, respectively. In contrast, there was no statistically significant difference between the genotypic and allelic frequencies for other genes in patients with inhibitors compared to patients without inhibitors. These results demonstrate that only polymorphisms in F13A1, DOCK2, and MAPK9 genes are associated with the risk of developing FVIII inhibitors in Iranian HA patients.