Evaluation of the potential use of a meta-population for genomic selection in autochthonous beef cattle populations.

This study investigated the potential application of genomic selection under a multi-breed scheme in the Spanish autochthonous beef cattle populations using a simulation study that replicates the structure of linkage disequilibrium obtained from a sample of 25 triplets of sire/dam/offspring per population and using the BovineHD Beadchip. Purebred and combined reference sets were used for the genomic evaluation and several scenarios of different genetic architecture of the trait were investigated. The single-breed evaluations yielded the highest within-breed accuracies. Across breed accuracies were found low but positive on average confirming the genetic connectedness between the populations. If the same genotyping effort is split in several populations, the accuracies were lower when compared with single-breed evaluation, but showed a small advantage over small-sized purebred reference sets over the accuracies of subsequent generations. Besides, the genetic architecture of the trait did not show any relevant effect on the accuracy with the exception of rare variants, which yielded slightly lower results and higher loss of predictive ability over the generations.

Genomic differentiation between Asturiana de los Valles, Avileña-Negra Ibérica, Bruna dels Pirineus, Morucha, Pirenaica, Retinta and Rubia Gallega cattle breeds.

The Spanish local beef cattle breeds have most likely common origin followed by a process of differentiation. This particular historical evolution has most probably left detectable signatures in the genome. The objective of this study was to identify genomic regions associated with differentiation processes in seven Spanish autochthonous populations (Asturiana de los Valles (AV), Avileña-Negra Ibérica (ANI), Bruna dels Pirineus (BP), Morucha (Mo), Pirenaica (Pi), Retinta (Re) and Rubia Gallega (RG)). The BovineHD 777K BeadChip was used on 342 individuals (AV, n=50; ANI, n=48; BP, n=50; Mo, n=50; Pi, n=48; Re, n=48; RG, n=48) chosen to be as unrelated as possible. We calculated the fixation index (F ST ) and performed a Bayesian analysis named SelEstim. The output of both procedures was very similar, although the Bayesian analysis provided a richer inference and allowed us to calculate significance thresholds by generating a pseudo-observed data set from the estimated posterior distributions. We identified a very large number of genomic regions, but when a very restrictive significance threshold was applied these regions were reduced to only 10. Among them, four regions can be highlighted because they comprised a large number of single nucleotide polymorphisms and showed extremely high signals (Kullback-Leiber divergence (KLD)>6). They are located in BTA 2 (5 575 950 to 10 152 228 base pairs (bp)), BTA 5 (17 596 734 to 18 850 702 bp), BTA 6 (37 853 912 to 39 441 548 bp) and BTA 18 (13 345 515 to 15 243 838 bp) and harbor, among others, the MSTN (Myostatin), KIT-LG (KIT Ligand), LAP3 (leucine aminopeptidase 3), NAPCG (non-SMC condensing I complex, subunit G), LCORL (ligand dependent nuclear receptor corepressor-like) and MC1R (Melanocortin 1 receptor) genes. Knowledge on these genomic regions allows to identify potential targets of recent selection and helps to define potential candidate genes associated with traits of interest, such as coat color, muscle development, fertility, growth, carcass and immunological response.

Performance of genomic selection under a single-step approach in autochthonous Spanish beef cattle populations.

This study evaluated different strategies for implementing a single-step genomic selection programme in two autochthonous Spanish beef cattle populations (Pirenaica-Pi and Rubia Gallega-RG). The strategies were compared in terms of accuracy attained under different scenarios by simulating genomic data over the known genealogy. Several genotyping approaches were tested, as well as, other factors like marker density, effective population size, mutation rate and heritability of the trait. The results obtained showed gains in accuracy with respect to pedigree BLUP evaluation in all cases. The greatest benefit was obtained when the candidates to selection had their genotypes included in the evaluation. Moreover, genotyping the individuals with the most accurate predictions maximized the gains but other suboptimal strategies also yielded satisfactory results. Furthermore, the gains in accuracy increased with the marker density reaching a plateau at around 50,000 markers. Likewise, the effective population size and the mutation rate have also shown an effect, both increasing the accuracy with decreasing values of these population parameters. Finally, the results obtained for the RG population showed greater gains compared to the Pi population, probably attributed to the wider implantation of artificial insemination.

Linkage disequilibrium, persistence of phase, and effective population size in Spanish local beef cattle breeds assessed through a high-density single nucleotide polymorphism chip.

Linkage disequilibrium (LD) and persistence of phase are fundamental approaches for exploring the genetic basis of economically important traits in cattle, including the identification of QTL for genomic selection and the estimation of effective population size () to determine the size of the training populations. In this study, we have used the Illumina BovineHD chip in 168 trios of 7 Spanish beef cattle breeds to obtain an overview of the magnitude of LD and the persistence of LD phase through the physical distance between markers. Also, we estimated the time of divergence based on the persistence of the LD phase and calculated past from LD estimates using different alternatives to define the recombination rate. Estimates of average (as a measure of LD) for adjacent markers were close to 0.52 in the 7 breeds and decreased with the distance between markers, although in long distances, some LD still remained (0.07 and 0.05 for markers 200 kb and 1 Mb apart, respectively). A panel with a lower boundary of 38,000 SNP would be necessary to launch a successful within-breed genomic selection program. Persistence of phase, measured as the pairwise correlations between estimates of in 2 breeds at short distances (10 kb), was in the 0.89 to 0.94 range and decreased from 0.33 to 0.52 to a range of 0.01 to 0.08 when marker distance increased from 200 kb to 1 Mb, respectively. The magnitude of the persistence of phase between the Spanish beef breeds was similar to those found in dairy breeds. For across-breed genomic selection, the size of the SNP panels must be in the range of 50,000 to 83,000 SNP. Estimates of past showed values ranging from 26 to 31 for 1 generation ago in all breeds. The divergence among breeds occurred between 129 and 207 generations ago. The results of this study are relevant for the future implementation of within- and across-breed genomic selection programs in the Spanish beef cattle populations. Our results suggest that a reduced subset of the SNP panel would be enough to achieve an adequate precision of the genomic predictions.

Non-linear recursive models for growth traits in the Pirenaica beef cattle breed.

One of the main goals of selection schemes in beef cattle populations is to increase carcass weight at slaughter. Live weights at different growth stages are frequently used as selection criteria under the hypothesis that they usually have a high and positive genetic correlation with weight at slaughter. However, the presence of compensatory growth may bias the prediction ability of early weights for selection purposes. Recursive models may represent an interesting alternative for understanding the genetic and phenotypic relationship between weight traits during growth. For the purposes of this study, the analysis was performed for three different set of data from the Pirenaica beef cattle breed: weight at 120 days (W120) and at 210 days (W210); W120 and carcass weight at slaughter at 365 days (CW365); W210 and CW365. The number of records for each analysis was 8592, 4648 and 3234, respectively. A pedigree composed of 56323 individuals was also included. The statistical model comprised sex, year-season of birth, herd and slaughterhouse, plus a non-linear recursive dependency between traits. The dependency was modeled as a polynomial up to the 4th degree and models were compared using a Logarithm of Conditional Predictive Ordinates. The results of model comparison suggest that the best models were the 3rd degree polynomial for W120-W210 and W120-CW365 and the 2nd degree polynomial for W210-CW365. The posterior mean estimates for heritabilities ranged between 0.29 and 0.44 and the posterior mean estimates of the genetic correlations were null or very low, indicating that the relationship between traits is fully captured by the recursive dependency. The results imply that the predictive ability of the performance of future growth is low if it is only based on records of early weights. The usefulness of slaughterhouse records in beef cattle breeding evaluation is confirmed.