Mineralization of Poly(vinyl alcohol) by Ozone Microbubbles under a Wide Range of pH Conditions.

Poly(vinyl alcohol) (PVA) is a well-known recalcitrant pollutant that threatens ecological systems and human health. In this study, ozone-microbubble treatment was evaluated as a physicochemical method to mineralize PVA in solution for wastewater treatment. Microbubbles are very small bubbles (<50 µm in diameter) and shrink in water because of the rapid dissolution of the interior gas. Ozone microbubbles were generated by a hybrid microbubble generator in PVA solutions with pH conditions of 2, 7, and 10. Ordinary ozone bubbling was also performed as control tests. The change in the total-organic-carbon content was measured to evaluate the efficiency of the system for wastewater treatment. Ordinary ozone bubbling was not able to mineralize aqueous PVA solutions under nonalkaline conditions, and approximately 30% of the total organic carbon remained at pH 2 and 7. Conversely, ozone microbubbles effectively mineralized PVA in aqueous solution to almost 0% in total organic carbon regardless of the pH condition. Effective mineralization of PVA, a recalcitrant organic chemical, demonstrates the potential of ozone-microbubble systems for physicochemical wastewater treatment.

Simple and rapid synthesis of magnetite/hydroxyapatite composites for hyperthermia treatments via a mechanochemical route.

This paper presents a simple method for the rapid synthesis of magnetite/hydroxyapatite composite particles. In this method, superparamagnetic magnetite nanoparticles are first synthesized by coprecipitation using ferrous chloride and ferric chloride. Immediately following the synthesis, carbonate-substituted (B-type) hydroxyapatite particles are mechanochemically synthesized by wet milling dicalcium phosphate dihydrate and calcium carbonate in a dispersed suspension of magnetite nanoparticles, during which the magnetite nanoparticles are incorporated into the hydroxyapatite matrix. We observed that the resultant magnetite/hydroxyapatite composites possessed a homogeneous dispersion of magnetite nanoparticles, characterized by an absence of large aggregates. When this material was subjected to an alternating magnetic field, the heat generated increased with increasing magnetite concentration. For a magnetite concentration of 30 mass%, a temperature increase greater than 20 K was achieved in less than 50 s. These results suggest that our composites exhibit good hyperthermia properties and are promising candidates for hyperthermia treatments.