Bio-based dispersants for fuel oil spill remediation based on the Hydrophilic-Lipophilic Deviation (HLD) concept and Box-Behnken design.

The high density and viscosity of fuel oil leads to its prolonged persistence in the environment and causes widespread contamination. Dispersants with a low environmental impact are necessary for fuel oil spill remediation. This study aimed to formulate bio-based dispersants by mixing anionic biosurfactant (lipopeptides from Bacillus subtilis GY19) with nonionic oleochemical surfactant (Dehydol LS7TH). The synergistic effect of the anionic-nonionic surfactant mixture produced a Winsor Type III microemulsion, which promoted petroleum mobilization. The hydrophilic-lipophilic deviation (HLD) equations for ionic and nonionic surfactant mixtures were compared, and it was found that the ionic equation was applicable for the calculation of lipopeptides and Dehydol LS7TH concentrations. The best formula contained 6.6% w/v lipopeptides and 11.9% w/v Dehydol LS7TH in seawater, and its dispersion effectiveness for bunker fuels A and C was 92% and 78%, respectively. The application of bio-based dispersants in water sources was optimized by Box-Behnken design. The efficiency of the bio-based dispersant was affected by the dispersant-to-oil ratios (DORs) but not by the water salinity. A suitable range of DORs for different oil contamination levels could be identified from the response surface plot. The dispersed fuel oil was further degraded by adding an oil-degrading bacterial consortium to the chemically enhanced water accommodated fractions (CEWAFs). After 7 days of incubation, the concentration of fuel oil was reduced from 3692 mg/L to 356 mg/L (88% removal efficiency). On the other hand, the abiotic control removed less than 40% fuel oil from the CEWAFs. This bio-based dispersant had an efficiency comparable to that of a commercial dispersant. The process of dispersant formulation and optimization could be applied to other surfactant mixtures.

Reuse of Immobilized Weissella cibaria PN3 for Long-Term Production of Both Extracellular and Cell-Bound Glycolipid Biosurfactants.

Lactic acid bacteria (LABs) are generally recognized as safe (GRAS), and therefore, LAB biosurfactants are beneficial with negligible negative impacts. This study aims to maintain the biosurfactant producing activity of an LAB strain, Weissella cibaria PN3, by immobilizing the bacterial cells on a commercial porous carrier. For biosurfactant production, 2% soybean oil was used as the carbon source. After 72 h, immobilized cells were reused by replacing production medium. The extracellular and cell-bound biosurfactants were extracted from the resulting cell-free broth and cell pellets, respectively. SEM images of used immobilizing carriers showed increased surface roughness and clogged pores over time. Thus, the immobilizing carriers were washed in PBS buffer (pH 8.0) before reuse. To maintain biosurfactant production activity, immobilized cells were reactivated every three production cycles by incubating the washed immobilizing carriers in LB medium for 48 h. The maximum yields of purified extracellular (1.46 g/L) and cell-bound biosurfactants (1.99 g/L) were achieved in the 4th production cycle. The repeated biosurfactant production of nine cycles were completed within 1 month, while only 2 g of immobilized cells/L were applied. The extracellular and cell-bound biosurfactants had comparable surface tensions (31 - 33 mN/m); however, their CMC values were different (1.6 and 3.2 g/L, respectively). Both biosurfactants had moderate oil displacement efficiency with crude oil samples but formed emulsions well with gasoline, diesel, and lavender, lemongrass and coconut oils. The results suggested that the biosurfactants were relatively hydrophilic. In addition, the mixing of both biosurfactants showed a synergistic effect, as seen from the increased emulsifying activity with palm, soybean and crude oils. The biosurfactants at 10 - 16 mg/mL showed antimicrobial activity toward some bacteria and yeast but not filamentous fungi. The molecular structures of these biosurfactants were characterized by FTIR as different glycolipid congeners. The biosurfactant production process by immobilized Weissella cibaria PN3 cells was relatively cheap given that two types of biosurfactants were simultaneously produced and no new inoculum was required. The acquired glycolipid biosurfactants have high potential to be used separately or as mixed biosurfactants in various products, such as cleaning agents, food-grade emulsifiers and cosmetic products.