A study on the sensitivity of the measurement of liquid density at different scattering angles using a gamma scattering technique.

This study aims to evaluate the sensitivity of the measurement of liquid density at different scattering angles using a gamma scattering technique. To perform this, the linear calibration curves of the ratio R (R is the ratio of the area under a single scattering peak for a liquid relative to that for water) versus the liquid density were constructed at different scattering angles. The sensitivity of the measurement is defined as the slope coefficient of these linear calibration curves. The results obtained from the Monte Carlo simulation data showed that the sensitivity of the measurement at different scattering angles including 70°, 80°, 90°, 100°, 110°, 120°, 130°, and 140° changes in the range from 0.44 to 0.48. Also, the results obtained from the experiment when performing the measurements at scattering angles of 90°, 100°, 110°, and 120° ranged from 0.46 to 0.48. This confirms that the dependence of the sensitivity of the measurement on scattering angle is insignificant. Besides, for every experimental dataset, we used each of 8 above-obtained calibration curves, in turn, to determine the densities of 8 liquids which yield the relative deviation between the measured density and the reference one is mostly less than 5%, the relative deviation of remaining cases (64 of 256 measurements) is in the range of 5.0%-9.9%.

A revision of the virtual point detector model for calculating Nai(Tl) detector efficiency.

In present work, the validity of the virtual point detector (VPD) model for the NaI(Tl) detectors is studied and confirmed in the photon energy range of 60-1408 keV. The full energy peak efficiency (FEPE) of two NaI(Tl) detectors, which have scintillation crystal dimensions of 5.08 × 5.08 cm and 7.62 × 7.62 cm respectively, is measured for "point-like" radioactive sources on the symmetry axis with source-to-detector distances in the range of 2-40 cm. It is found that the VPD model is valid to fit too well to the experimental FEPE for the two surveyed NaI(Tl) detectors. The dependence of the VPD position on the incident photon energy for the NaI(Tl) detectors with different scintillation crystal dimensions is shown based on experimental data. A semi-empirical equation involving incident photon energy and source-to-detector distance is proposed to calculate the FEPE for the NaI(Tl) detectors. The calculated results for the two surveyed NaI(Tl) detectors by this equation are in a good agreement with experimental results for photon energies in the range of 344-1408 keV. However, the difference between experimental and calculated results is quite significant for source-to-detector close geometries for photon energies lower than 344 keV.

Estimating thickness of the inner dead-layer of n-type HPGe detector.

In this study, a procedure to estimate thickness of the inner dead-layer of an n-type coaxial HPGe detector is described. Experimental measurements are carried out with standard point sources: (54)Mn, (57)Co, (60)Co, (88)Y, (109)Cd, (134)Cs, (137)Cs, and (152)Eu at distances of 5 and 10cm from source to detector. Shape and dimensions of a high-purity germanium (HPGe) detector are determined by radiography to characterize the geometry accurately for Monte Carlo simulation. The role of thickness of the inner dead-layer on full energy peak efficiency is illustrated by MCNP5 code, and it is observed that slope coefficient of efficiency curve has a linear relationship with thickness of the dead-layer. The adjustment of dead-layer yields good agreement, with relative deviation of ≤3%, between experimental efficiency and simulated efficiency in the energy range of 88-1836keV.