Cadmium mobility in a circular food-to-waste-to-food system and the use of a cultivated mushroom (Agaricus subrufescens) as a remediation agent.

Cadmium (Cd) and its mobility and toxicity in the food chain receives considerable public and scientific attention. Levels in soil have been increasing, partly caused by mineral fertiliser use. In many areas in the EU, intake of Cd is not far from the maximum tolerable level. Now, urban and more circular approaches to food production are being promoted, in which waste materials substitute growing media and fertilizers. Can this make the situation worse, or is it, on the contrary, possible to extract Cd from the cycle using practical microbial methods? Cd concentration, availability and accumulation in materials and crops in a closed greenhouse system was investigated first. Secondly, we tested if fungal remediation was able to remove a significant amount of Cd. A sequential extraction analysis showed how anaerobic digestion and composting changed chemical Cd availability. Cd levels in the system were comparable to agricultural soils. The vegetable crops did not accumulate Cd. However, the culture of the edible mushroom Agaricus subrufescens in the greenhouse had a strong effect on Cd mobility: It extracted 80% of the Cd from the growing medium into the mushrooms, mostly at the start of fruiting. These early Cd enriched mushrooms can be treated as special waste, while the later harvest complied with EU Cd limits for foodstuffs and can potentially be consumed. Thus, growing this mushroom species in an integrated waste-to-crop system can be a cost-efficient way to remediate Cd from the food chain.

Multielemental analysis of 20 mushroom species growing near a heavily trafficked road in Poland.

The aim of this work was to compare 10 mostly edible aboveground and 10 wood-growing mushroom species collected near a heavily trafficked road (approximately 28,000 vehicles per 24 h) in Poland with regard to their capacity to accumulate 26 trace elements (Ag, Al, As, Au, B, Ba, Bi, Cd, Co, Cr, Cu, Fe, Ga, Ge, In, Li, Mn, Ni, Pb, Re, Sb, Se, Sr, Te, Tl, and Zn) in their fruit bodies in order to illustrate mushroom diversity in element accumulation. All analyses were performed using an inductively coupled plasma optical emission spectrometry (ICP-OES) spectrometer in synchronous dual view mode. The aboveground species had significantly higher levels of 12 elements, including Ag, As, Pb, and Se, compared to the wood-growing species. An opposite relationship was observed only for Au, Ba, and Sr. The results of principal component analysis (PCA) and hierarchical cluster analysis (HCA) implied some new relationships among the analyzed species and elements. Of the analyzed mushroom species, lead content in Macrolepiota procera would seem to pose a health risk; however, at present knowledge regarding lead bioaccessibility from mushrooms is quite limited.

The XRF mapping of archaeological artefacts as the key to understanding of the past.

The article describes the X-ray fluorescence (XRF) studies on the chemical composition of archaeological artefacts. The mapping of the concentration of selected elements has been used to recognise the way of object production and the use. The obtained data allowed to obtain the new information, which is impossible to gain by use of different methods. 'The data obtained from the chemical composition of the particular parts of the objects may be used for the interpretation of the manufacturing technology or the primal form of the objects. Additionally, the knowledge obtained from the chemical composition of the different parts of the artefacts may be essential for the selection of the protection and conservation methods. The present studies can be useful to improve knowledge about the level of former craftsmanship. These knowledge allow us to exam archaeological artefacts in a new light, and these findings can also broaden the archaeological knowledge horizons and provide good bases for further detailed studies.

Assessment of iron in uterine and testicular tissues and hair of free-ranging and household cats.

Iron (Fe) represents a highly essential element for various biological processes. In spite of this very little is known as regards its status in mammalian reproductive tissues and factors that may potentially influence it. At the same time, there is an ongoing debate as to whether analyses of the Fe content in hair can provide reliable information on its tissue burden. Therefore, the aim of the present study was to investigate the content of Fe in the testicular and uterine tissues, and hair of the domestic cat (Felis catus) and how this content relates to an animal's age, weight, physical activity, inhabited environment and diet. The median Fe content in the feline reproductive tissues amounted to 50.8 ppm and in hair to 180.2 ppm. As found, free-ranging cats were characterized by a significantly higher Fe content in reproductive tissues, particularly in the uterus. Age, weight and physical activity had no effect on determined Fe levels. The type of commercial diet (wet, dry or combined) given to household cats also had no influence upon Fe status in hair and tissue although males fed exclusively on dry food had a lower Fetestis:Fehair ratio. Hair Fe level was positively correlated with that found in the reproductive tissues (Rs=0.30). This study extends the body of information on Fe distribution in felines, demonstrates the difference between free-ranging and household cats and provides evidence that Fe hair status may, at least partially, reflect the status of this element in the feline reproductive system.

The microwave induced plasma with optical emission spectrometry (MIP-OES) in 23 elements determination in geological samples.

The article presents the optimisation, validation and application of the microwave induced plasma optical emission spectrometry (MIP-OES) dedicated for a routine determination of Ag, Al, B, Ba, Bi, Ca, Cd, Cr, Cu, Fe, Ga, In, K, Li, Mg, Mn, Mo, Na, Ni, Pb, Sr, Tl, Zn, in the geological samples. The three procedures of sample preparation has been proposed: sample digestion with the use of hydrofluoric acid for determination of total concentration of elements, extraction by aqua regia for determination of the quasi-total element concentration and extraction by hydrochloric acid solution to determine contents of the elements in acid leachable fraction. The detection limits were on the level 0.001-0.121 mg L(-1) (from 0.010-0.10 to 1.2-12 mg kg(-1) depend on the samples preparation procedure); the precision: 0.20-1.37%; accuracy 85-115% (for recovery for certified standards materials analysis and parallel analysis by independent analytical techniques: X-ray fluorescence (XRF) and flame absorption spectrometry (FAAS)). The conformity of the results obtained by MIP-OES analytical procedures with the results obtained by XRF and FAAS analysis allows to propose the procedures for studies of elemental composition of the fraction of the geological samples. Additionally, the MIP-OES technique is much less expensive than ICP techniques and much less time-consuming than AAS techniques.

Selected arsenic species: As(III), As(V) and dimethylarsenic acid (DMAA) in Xerocomus badius fruiting bodies.

The aim of the study was to determine the content of As(III), As(V) and DMAA (dimethylarsinic acid) in Xerocomus badius fruiting bodies collected from selected Polish forests from areas subjected to very low or high anthropopressure and some commercially available samples obtained from the Polish Sanitary Inspectorate. The arsenic species determination was provided by two independent HPLC-HG-AAS hyphenated systems. The results show high levels (up to 27.1, 40.5 and 88.3 mg kg(-1) for As(III), As(V) and DMAA, respectively) of arsenic and occurrence of different species in mushrooms collected from areas subjected to high anthropopressure and two commercially available samples. For mushroom samples collected from areas not subjected to high anthropopressure and two commercially available samples the arsenic species level was below 0.5 mg kg(-1) for each arsenic form. Therefore, the accumulation of arsenic by mushrooms may lead to high (toxic for humans) arsenic concentrations, and arsenic species levels should be monitored in mushroom foodstuffs.

Biological properties of carbon powders synthesized using chemical vapour deposition and detonation methods.

Carbon powders can be synthesized using variety of CVD and detonation methods. Several interesting properties of carbon powder particles make them a very attractive material examined in many laboratories all over the world. However there is a lack of information discussing investigation of carbon powders directed to its application in pharmaceutical-cosmetic industry and medicine. Earlier investigation results proved that diamond powders present properties fighting free radicals. Presented work discusses the influence of carbon powder particles manufactured using MW/RF PACVD, RF PACVD and detonation methods onto hydro-lipid skin coat. Before the biological examinations physicochemical properties of carbon powders were determined. Grain size, shape and chemical composition of carbon powders were determined using the scanning electron microscopy. Surface functional groups were characterized by IR Fourier-transform spectroscopy and X-ray photoelectron spectroscopy. Structure and phase composition were investigated by means of the Raman spectroscopy. Results of allergy tests performed on laboratory mice proved that carbon powder particles synthesized using different methods do not cause allergy. In the following stage, the group of 20 patients applied the formula including carbon powder on their face skin. The influence of carbon powder onto hydro-lipid skin coat was determined by measurement of such parameters as: pH reaction, skin temperature, lipid fotometry and level of hydration. Additionally, macro pictures of places where the cream had been applied were registered. As the result of the investigation it was found that powders synthesized using various methods present different physicochemical properties which may individually affect the face skin parameters. The noticeable improvement of hydro-lipid skin coat kilter was observed.

Biological properties of different type carbon particles in vitro study on primary culture of endothelial cells.

Carbon powders have extended surface of carbon layers, which is of significant biomedical importance since the powders are employed to cover implants material. Carbon Powder Particles are produced by different methods: by a detonation method, by RF PACVD (Radio Frequency Plasma Activated Chemical Vapour Deposition) or MW/RF PCVD (Microwave/Radio Frequency Plasma Activated Chemical Vapour Deposition) and others. Our previous data showed that Carbon Powder Particles may act as antioxidant and/or anti-inflammatory factor. However the mechanism of such behavior has been not fully understood. The aim of the work was tested influence carbon powders manufactured by Radio Frequency Plasma Activated Chemical Vapour Deposition RFPACVD method and detonation method on selected parameters of human endothelial cells, which play a crucial role in the regulation of the circulation and vascular wall homeostasis. Graphite powder was used as a control substance. Endothelial cells are actively involved in a wide variety of processes e.g., inflammatory responses to a different type of stimuli (ILs, TNF-alpha) or regulating vasomotor tone via production of vasorelaxants and vasocontrictors. Biological activation is dependent on the type and quantity of chemical bonds on the surface of the powders. The effect of powders on the proliferation of HUVECs (Human Umbilical Vein Endothelial Cells) was determined by MTT (3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide) reduction assay. We found decreased cell proliferation after 72 h treatment with graphite as well as Carbon Powder Particles.

Microtrace metalloids speciation in lakes water samples (Poland).

This paper presents the results of the determination of arsenic, antimony and selenium concentrations of inorganic speciation in surface water samples from Gniezno city (western Poland) and its neighborhood. The concentration of elements were up to 1.85 ng/ml for arsenic, 1.61 ng/ml for antimony and 0.45 ng/ml for selenium (detection limits: 0.04 ng/ml for As and Sb and 0.03 ng/ml for Se). A variety of concentrations for the determined elements has been obtained in waters from Gniezno city's neighborhood and in water from down-town reservoirs which are under strong anthropogenic pressure.

The application of nanocrystaline diamond coatings in medicine.

The search for an endoprosthesis with the longest possible durability has been in progress for many years. In spite of three decades of intensive development of implant materials, contemporary endoprosthesis are still far from satisfactory. In an environment as corrosive as the human body, even the best metal alloys release ions: Co, Cr and Mo all dissolve at a rate of approximately 50 ng per year. The biocompatibility of an implants is directly by the extent of corrosion. Tests in vivo have shown that Ni, Co and Cr ions are bound to the body's own proteins, predominantly albumins, which can then transfer them to other ergans, thus disturbing their functions.
Facing this challenge, a new, entirely cementless endoprosthesis for the coxofemoral joint, comprised of a pin, a head and two bushings, has been constructed in a cooperative project involving three research centers: ECAM in Lyons, the Technical University of Bratislava, and the Thin Film Division of the Technical University of Lodz. Both the pin and the outer bushing are made of a titanium alloy, coated with a nanocrystalline diamond film. The heads is made of corundum ceramics, and the inner bushing is made if high molecular weight polyethylene. The shape of the pin has been designed in compliance with all biomechanical requirements.
As of this writing these endoprostheses have been implanted in test animals, and remain under continous biological monitoring. To this point all the test results have been postitive.

Malignant humeral bone tumors in children: excision and reconstruction with the use of rotated clavicle.

The application of intensive multimodality therapy has made possible salvage surgery in bone tumors. Reconstruction of the removed part of bone is the great problem, especially in fast-growing children. In three patients (two osteosarcomas and one Ewing's sarcoma), the tumor was confined to the proximal half part of humerus, without invasion of shoulder joint. After induction chemotherapy, reduction of tumor size was observed both clinically and radiologically. During the operation, wide resection of the tumor together with a 12- to 14-cm-long fragment of humerus, was performed. Afterward, the clavicle was rotated in the place of the removed bone, with preservation of the coracoacromial ligament. The humeral stump and clavicle were fixed with the use of metal plate. Adjuvant chemotherapy was used a few days following surgery. After 3 months, the osteosynthesis had healed. The movements in shoulder joint are limited, but functions of elbow joint remained normal. All children are alive and disease free. Reconstruction of humerus with clavicle rotation is possible when the proximal bone loss is not longer than 10-14 cm. This method seems to be an alternative to allogeneic grafts and endoprostheses.