Hybrid collagen-based hydrogels with embedded montmorillonite nanoparticles.

Montmorillonite nanoparticles have been physically incorporated within a crosslinked collagen/poly(N-isopropyl acrylamide) network in order to adjust the properties of the stimuli-responsive hybrid systems. The research underlines both the influence of hydrogel composition and nanoparticle type on hybrid hydrogel properties. The dispersion of the montmorillonite nanoparticles in polymeric matrix have been visualized by SEM, TEM and AFM techniques and quantitatively and qualitatively estimated using near infrared chemical imaging. The electrical charge of the nanoparticles influenced the polymeric chain arrangement and the pore size. The morphologies of the nanoparticulated layers are partially exfoliated or intercalated and uniformly dispersed through the polymeric semi-interpenetrated network based on collagen and poly(N-isopropyl acrylamide). The hybrid hydrogels exhibit pseudoplastic behavior and the addition of nanoparticles has resulted in the increase of the complex viscosity. The adhesion capacity was affected mainly by the presence of organically modified montmorillonites.

Immunoglobulin G immobilization on PVDF surface.

Immobilization of antibody molecules onto hydrophobic polymeric surfaces with disordered orientation is something unwanted in many applications. To overcome this drawback, controlled immunoglobulin G (IgG) immobilization onto poly(vinylidene fluoride) surface was investigated in this paper. A two-step process involving radiofrequency plasma pretreatment for polymer surface functionalization, followed by coupling reaction was developed, after which immunoglobulin G was immobilized onto the surface directly or via protein-A. IR and XPS data proved that the process is more efficient when the radiofrequency plasma pretreatment was performed using N2 and N2/H2 as discharge gases. NIR-CI, AFM and XPS surface evaluation revealed that immobilization of IgG onto N2/H2 plasma-treated PVDF via grafted protein-A was achieved with an ends-on orientation, leaving available the antigen binding sites of IgG. This procedure could be a promising route for the preparation of oriented IgG assembly onto PVDF, useful in biomedical, membranes or sensors applications. QCM results showed a better antibody-antigen interaction when IgG immobilization onto PVDF substrate is mediated by protein A.

In vitro and in vivo theophylline release from cellulose/chondroitin sulfate hydrogels.

In vitro and in vivo release of the theophylline, loaded in mixed polysaccharidic cellulose/chondroitin sulfate (C/CS) hydrogels has been evaluated. The C/CS hydrogels in various mixing ratios obtained by a crosslinking technique were supplementary characterized by swelling studies in a pH 2.2 acidic solution at 37 °C, simulating the gastrointestinal medium, as in vivo theophylline delivery was done by oral administration. The hydrogels loading degree with theophylline was evaluated by near infrared chemical imaging (NIR-CI) technique and confirmed also by FT-IR spectroscopy. Based on PLS-DA (partial least squares-discriminate analysis) prediction, the drug loading was found up to 92.5%. The in vitro release profiles of theophylline from C/CS hydrogels showed that an increase of chondroitin sulfate leads to a decreased theophylline percent released, increased half release time and time to reach maximum percent released. During in vivo test, the raw theophylline was rapidly, absorbed, distributed, and eliminated. Comparatively with raw drug administration, the t1/2 and AUC0-72 value were 4 times higher for theophylline loaded into 50/50 C/CS hydrogel. A good in vitro-in vivo correlation was found. A retarded release, controlled by CS content can be achieved by using mixed hydrogels as carriers.

Synthesis of hydrogels based on poly(NIPAM) inserted into collagen sponge.

The study presents the preparation of a semi-synthetic hydrogel based on poly(N-isopropyl acrylamide-co-diethylene glycol diacrylate) inserted onto the collagen porous membrane. The synthesis of the hydrogels was performed through radical copolymerization of N-isopropyl acrylamide (NIPAM) with diethylene glycol diacrylate (DEGDA) also as crosslinking agent, using ammonium persulfate as initiator and N,N,N',N'-tetramethylethylene diamine as activator, and it was achieved in the presence of the collagen matrix. The prepared hydrogels were characterized by Attenuated Total Reflectance-Fourier Transform Infrared Spectroscopy and Scanning Electron Microscopy. The swelling behaviour of the semi-interpenetrated polymer network related on the hydrogel composition, it was also evaluated. The pore sizes of the synthesized hydrogels, much larger than the typical mesh size of a conventional hydrogel, allow to consider the hybrid hydrogel based on the inserted poly(NIPAM-co-DEGDA) onto collagen fibrils as a super-porous hydrogel.