Early impairment of cartilage poroelastic properties in an animal model of ACL tear.

BACKGROUND: In more than 50% of cases, anterior cruciate ligament (ACL) lesions lead to post-traumatic osteoarthritis. Ligament reconstruction stabilizes the joint, but the tear seems to impair the poroelasticity of the cartilage: synovial membrane fluid inflammation is observed 3 weeks after tearing. There have been some descriptions of visible cartilage changes, but poroelasticity has never been analyzed at this early stage. The present animal study aimed to determine (1) whether cartilage showed early poroelastic deterioration after ACL tear; (2) whether an impairment correlated with macroscopic changes; and (3) whether cartilage poroelasticity deteriorated over time. HYPOTHESIS: In the days following trauma, cartilage poroelasticity is greatly impaired, without macroscopically visible change. MATERIAL AND METHODS: ACL tear was surgically induced in 18 New-Zealand rabbits. Cartilage poroelasticity was assessed on indentation-relaxation test in 3 groups: "early", at 2 weeks postoperatively (n=6), "mid-early" at 6 weeks (n=6) and in a non-operated control group ("non-op"). Macroscopic changes were scored in the same groups. RESULTS: Poroelastic impairment was greatest at the early time-point (2 weeks). Permeability ranged from a mean 0.08±0.05×10-15 m4/Ns (range, 0.028-0.17) in the "non-op" group to 1.03±0.60×10-15 m4/Ns (range, 0.24-2.15) in the "early" group (p=0.007). Shear modulus ranged from 0.53±0.11MPa (range, 0.36-0.66) to 0.23±0.10MPa (range, 0.12-0.43), respectively (p=0.013). Macroscopic deterioration, on the other hand, differed significantly only between the "mid-early" and the "non-op" groups: p=0.011 for cartilage deterioration and p=0.008 for osteophyte formation. At the "mid-early" time point, poroelastic deterioration was less marked, with 0.33±0.33×10-15 m4/Ns permeability (range, 0.06-1.06) and shear modulus 0.30±0.10MPa (range, 0.13-0.41: respectively p=0.039 and p=0.023 compared to the "non-op" group. DISCUSSION: The severe rapid deterioration in poroelasticity following ACL tear in an animal model, as notably seen in increased permeability, corresponds to changes in cartilage microstructure, with easier outflows of interstitial fluid. This mechanical degradation may underlie onset of microcracks within the cartilage, leading to physiological loading that the cartilage by its nature is unable to repair. Further investigations are needed to correlate these experimental data with clinical findings. LEVEL OF EVIDENCE: III; comparative study with control group.

Predictive model for tensile strength of pharmaceutical tablets based on local hardness measurements.

In the pharmaceutical field, tablets are the most common dosage forms for oral administration. During the manufacture of tablets, measures are taken to assure that they possess a suitable mechanical strength to avoid crumbling or breaking when handling while ensuring disintegration after administration. Accordingly, the tensile strength is an essential parameter to consider. In the present study, microscopic hardness and macroscopic tensile strength of binary tablets made from microcrystalline cellulose and caffeine in various proportions were measured. A relationship between these two mechanical properties was found for binary mixture. The proposed model was based on two physical measurements easily reachable: hardness and tablet density. Constants were determined from the two extreme compositions of this given system. This model was validated with experimental results, and a comparison was made with the one developed by Wu et al. (2005). Both models are relevant for this studied system. Nonetheless, with this model, the tablet tensile strength can be connected with a tablet characteristic at microscopic scale in which porosity is not needed.

Numerical Study of Granular Scaffold Efficiency to Convert Fluid Flow into Mechanical Stimulation in Bone Tissue Engineering.

Controlling the mechanical environment in bioreactors represents a key element in the reactors' optimization. Positive effects of fluid flow in three-dimensional bioreactors have been observed, but local stresses at cell scale remain unknown. These effects led to the development of numerical tools to assess the micromechanical environment of cells in bioreactors. Recently, new possible scaffold geometry has emerged: granular packings. In the present study, the primary goal was to compare the efficiency of such a scaffold to the other ones from literature in terms of wall shear stress levels and distributions. To that aim, three different types of granular packings were generated through discrete element method, and computational fluid dynamics was used to simulate the flow within these packings. Shear stress levels and distributions were determined. A linear relationship between shear stress and inlet velocity was observed, and its slope was similar to published data. The distributions of normalized stress were independent of the inlet velocity and were highly comparable to those of widely used porous scaffolds. Granular packings present similar features to more classical porous scaffolds and have the advantage of being easy to manipulate and seed. The methods of this work are generalizable to the study of other granular packing configurations.