RESUMO
Domain antibodies (dAbs) are single immunoglobulin domains that form the smallest functional unit of an antibody. This study investigates the behavior of these small proteins when covalently attached to the polyethylene glycol (PEG) moiety that is necessary for extending the half-life of a dAb. The effect of the 40 kDa PEG on hydrodynamic properties, particle behavior, and receptor binding of the dAb has been compared by both ensemble solution and surface methods [light scattering, isothermal titration calorimetry (ITC), surface Plasmon resonance (SPR)] and single-molecule atomic force microscopy (AFM) methods (topography, recognition imaging, and force microscopy). The large PEG dominates the properties of the dAb-PEG conjugate such as a hydrodynamic radius that corresponds to a globular protein over four times its size and a much reduced association rate. We have used AFM single-molecule studies to determine the mechanism of PEG-dependent reductions in the effectiveness of the dAb observed by SPR kinetic studies. Recognition imaging showed that all of the PEGylated dAb molecules are active, suggesting that some may transiently become inactive if PEG sterically blocks binding. This helps explain the disconnect between the SPR, determined kinetically, and the force microscopy and ITC results that demonstrated that PEG does not change the binding energy.
Assuntos
Anticorpos/química , Bioensaio/métodos , Polietilenoglicóis/química , Meia-Vida , Cinética , Microscopia de Força Atômica/métodos , Ligação Proteica/efeitos dos fármacos , Proteínas/química , Ressonância de Plasmônio de Superfície/métodosRESUMO
A robust, economical process should leverage proven technology, yet be flexible enough to adopt emerging technologies which show significant benefit. Antibody and Fc-fusion processes may capitalize on the high selectivity of an affinity capture step by reducing the total number of chromatographic steps to 2. Risk associated with this approach stems from the potentially increased time frame needed for process development as well as unforeseen changes in impurity profile during first scale-up of drug substance (DS) for animal toxicology and clinical phase I trials (FIH) production, which could challenge a two-step process to the point of failure. Two different purification strategies were pursued during process development for an FIH process of a dAB-Fc fusion protein. A two-step process was compared to a three-step process. The two-step process leveraged additives to maximize impurity reduction during affinity capture. While wash additives in combination with a mixed mode chromatography met all impurity reduction requirements, HCP levels were still higher as compared to the three-step process. The three-step process was implemented for manufacture of clinical material to mitigate risk.
Assuntos
Cromatografia Líquida/métodos , Fragmentos Fc das Imunoglobulinas/isolamento & purificação , Proteínas Recombinantes de Fusão/isolamento & purificação , Animais , Células CHO , Cricetulus , Fragmentos Fc das Imunoglobulinas/genética , Proteínas Recombinantes de Fusão/genéticaRESUMO
Cleaning-in-place (CIP) for column chromatography plays an important role in therapeutic protein production. A robust and efficient CIP procedure ensures product quality, improves column life time and reduces the cost of the purification processes, particularly for those using expensive affinity resins, such as MabSelect protein A resin. Cleaning efficiency, resin compatibility, and facility compatibility are the three major aspects to consider in CIP process design. Cleaning MabSelect resin with 50mM sodium hydroxide (NaOH) along with 1M sodium chloride is one of the most popular cleaning procedures used in biopharmaceutical industries. However, high concentration sodium chloride is a leading cause of corrosion in the stainless steel containers used in large scale manufacture. Corroded containers may potentially introduce metal contaminants into purified drug products. Therefore, it is challenging to apply this cleaning procedure into commercial manufacturing due to facility compatibility and drug safety concerns. This paper reports a safe, effective and environmental and facility-friendly cleaning procedure that is suitable for large scale affinity chromatography. An alternative salt (sodium sulfate) is used to prevent the stainless steel corrosion caused by sodium chloride. Sodium hydroxide and salt concentrations were optimized using a high throughput screening approach to achieve the best combination of facility compatibility, cleaning efficiency and resin stability. Additionally, benzyl alcohol is applied to achieve more effective microbial control. Based on the findings, the recommended optimum cleaning strategy is cleaning MabSelect resin with 25 mM NaOH, 0.25 M Na2SO4 and 1% benzyl alcohol solution every cycle, followed by a more stringent cleaning using 50 mM NaOH with 0.25 M Na2SO4 and 1% benzyl alcohol at the end of each manufacturing campaign. A resin life cycle study using the MabSelect affinity resin demonstrates that the new cleaning strategy prolongs resin life time and consistently delivers high purity drug products.
Assuntos
Anticorpos Monoclonais/isolamento & purificação , Cromatografia de Afinidade/instrumentação , Cromatografia de Afinidade/métodos , Animais , Células CHO , Cricetinae , Cricetulus , Eletroforese em Microchip , Reutilização de Equipamento , Ensaios de Triagem em Larga Escala/instrumentação , Ensaios de Triagem em Larga Escala/métodos , Proteínas/isolamento & purificaçãoRESUMO
Introduced in the late 1980s as a reducing reagent, Tris (2-carboxyethyl) phosphine (TCEP) has now become one of the most widely used protein reductants. To date, only a few studies on its side reactions have been published. We report the observation of a side reaction that cleaves protein backbones under mild conditions by fracturing the cysteine residues, thus generating heterogeneous peptides containing different moieties from the fractured cysteine. The peptide products were analyzed by high performance liquid chromatography and tandem mass spectrometry (LC/MS/MS). Peptides with a primary amine and a carboxylic acid as termini were observed, and others were found to contain amidated or formamidated carboxy termini, or formylated or glyoxylic amino termini. Formamidation of the carboxy terminus and the formation of glyoxylic amino terminus were unexpected reactions since both involve breaking of carbon-carbon bonds in cysteine.
Assuntos
Cromatografia Líquida de Alta Pressão/métodos , Cisteína/química , Fragmentos de Peptídeos/química , Fosfinas/química , Proteínas/química , Espectrometria de Massas em Tandem/métodos , Cisteína/metabolismo , Concentração de Íons de Hidrogênio , Fragmentos de Peptídeos/metabolismo , Proteínas/metabolismoRESUMO
S-thiolation is a reversible post-translational modification in which thiol metabolites of low molecular masses are linked to protein sulfhydryl groups through disulfide bonds. This modification is commonly observed in recombinant proteins secreted from E. coli cells. Since it can alter protein functions and introduce molecular heterogeneity, S-thiolation is undesirable for recombinant protein production. To date, few published studies have characterized thiol modifiers or investigated the mechanism of S-thiolation in recombinant proteins. In this work, reversed-phase liquid chromatography and mass spectrometry were used to characterize four of the most abundant thiol modifiers on recombinant proteins secreted from E. coli BL21 (DE3) strain. These thiol modifiers have been identified as glutathione, 4-phosphopantetheine, gluconoylated glutathione, and dephosphorylated coenzyme A. S-thiolation by these thiol modifiers increases protein mass by 305, 356, 483, and 685 Da, respectively. These specific mass increases can be used as markers for identifying S-thiolation in recombinant proteins.