Effect of thermally deposited siloxane-methacrylate coating on bonding to glass fibre posts.

AIM: To evaluate the alterations promoted by a thermally deposited siloxane-methacrylate coating on the surface of glass fibre posts and their effect on the bond strength of resin-core materials to the posts. METHODOLOGY: Fibre post surfaces were treated with experimental thermally deposited siloxane-methacrylate coatings or clinically available treatments (i.e. hydrogen peroxide and methylene chloride); nontreated posts were used as controls. The contact angles formed between the post surface and the water/adhesive were measured with a tensiometer. Scanning electron microscopy and electron dispersive spectroscopy were used to examine the topographies and chemical changes in the post surfaces following treatment. Surface roughness was evaluated with laser interferometry. Core resin was bonded to the fibre posts, and microtensile bond strength testing was subsequently performed. The data were individually submitted to anova and Tukey's tests (α = 0.05). RESULTS: The water contact angle was reduced significantly (P < 0.05) by the thermally deposited siloxane-methacrylate coating. All treatments significantly increased the adhesive contact angle (P ≤ 0.016) compared to the control as well as the surface roughness (P ≤ 0.006) and the amount of Si on post surfaces. Greater percentages of Si were observed for the thermally deposited coating. The bond strength to the posts was significantly improved by the thermally deposited coating (P < 0.05), whereas the other treatments did not differ from the control. CONCLUSION: Treating the surface of glass fibre posts with a thermally deposited siloxane-methacrylate coating improved the bond strength to resin-based materials. The coating could be performed by manufacturers of glass fibre posts in order to reduce the number of clinical steps required for luting posts into root canals.

Strengthening of Porcelain Provided by Resin Cements and Flowable Composites.

This study evaluated the effect of mechanical properties of resin-based luting agents on the strength of resin-coated porcelain. The luting agents tested were two flowable resin composites (Filtek Z350 Flow and Tetric-N Flow), a light-cured resin cement (Variolink Veneer [VV]), and a dual-cured resin cement (Variolink II) in either light-cured (base paste) or dual-cured (base + catalyst pastes [VD]) mode. Flexural strength (σf) and modulus of elasticity (Ef) of the luting agents were measured in three-point bending mode (n=5). Porcelain discs (Vita VM7) were tested either untreated (control) or acid etched, silanized, and coated with the luting agents. Biaxial flexural strength (σbf) of the porcelain discs was tested using a ball-on-ring setup (n=30). The σbf of the resin-coated specimens was calculated at z-axial positions for multilayer specimens in the ball-on-ring test: position z = 0 (ceramic surface at the bonded interface) and position z = -t2 (luting agent surface above ring). The σf and Ef data were subjected to analysis of variance and the Student-Newman-Keuls test (α=0.05). A Weibull analysis was performed for σbf data. Weibull modulus (m) and characteristic strength (σ0) were calculated. Linear regression analyses investigated the relationship between mechanical properties of the luting agents and the strengthening of porcelain. VD had higher and VV had lower mechanical strength than the other materials. At z = 0, all resin-coated groups had higher σbf than the control group. No significant differences between the luting agents were observed for σbf and σ0. At z = -t2, VD had the highest σbf and σ0, whereas VV had the poorest results. No significant differences in m were observed across groups. A linear increase in flexural strength of the porcelain was associated with increased σf and Ef of the luting agents at position z = -t2. In conclusion, resin coating and use of luting agents with better physical properties generally improved the mechanical performance of porcelain.

Can the hydrophilicity of functional monomers affect chemical interaction?

The number of carbon atoms and/or ester/polyether groups in spacer chains may influence the interaction of functional monomers with calcium and dentin. The present study assessed the chemical interaction and bond strength of 5 standard-synthesized phosphoric-acid ester functional monomers with different spacer chain characteristics, by atomic absorption spectroscopy (AAS), ATR-FTIR, thin-film x-ray diffraction (TF-XRD), scanning electron microscopy (SEM), and microtensile bond strength (µTBS). The tested functional monomers were 2-MEP (two-carbon spacer chain), 10-MDP (10-carbon), 12-MDDP (12-carbon), MTEP (more hydrophilic polyether spacer chain), and CAP-P (intermediate hydrophilicity ester spacer). The intensity of monomer-calcium salt formation measured by AAS differed in the order of 12-MDDP=10-MDP>CAP-P>MTEP>2-MEP. FTIR and SEM analyses of monomer-treated dentin surfaces showed resistance to rinsing for all monomer-dentin bonds, except with 2-MEP. TF-XRD confirmed the weaker interaction of 2-MEP. Highest µTBS was observed for 12-MDDP and 10-MDP. A shorter spacer chain (2-MEP) of phosphate functional monomers induced formation of unstable monomer-calcium salts, and lower chemical interaction and dentin bond strength. The presence of ester or ether groups within longer spacer carbon chains (CAP-P and MTEP) may affect the hydrophilicity, µTBS, and also the formation of monomer-calcium salts.

High levels of donor CCL2/MCP-1 predict graft-related complications and poor graft survival after kidney-pancreas transplantation.

In this study we analyzed the role of CCL2, a member of the chemokine family, in early graft damage. Using simultaneous kidney-pancreas transplantation (SPK) as a model, we showed that brain death significantly increases circulating CCL2 levels in humans. We found that in such situations, high donor CCL2 levels (measured before organ recovery and at the onset of cold preservation) correlate with increased postreperfusion release of CCL2 by both the graft and recipient throughout the week following transplantation (n = 28). In a retrospective study of 77 SPK recipients, we found a significant negative association between high donor levels of CCL2 and graft survival. Decreased survival in these patients is related to early posttransplant complications, including a higher incidence of pancreas thrombosis and delayed kidney function. Taken together our data indicate that high CCL2 levels in the donor serum predict both an increase in graft/recipient CCL2 production and poor graft survival. This suggests that the severity of the inflammatory response induced by brain death influences the posttransplant inflammatory response, independent of subsequent ischemia and reperfusion.

Effect of the catechol-O-methyltransferase val(158)met genotype on children's early phases of facial stimuli processing.

The ability to process and identify human faces matures early in life, is universal and is mediated by a distributed neural system. The temporal dynamics of this cognitive-emotional task can be studied by cerebral visual event-related potentials (ERPs) that are stable from midchildhood onwards. We hypothesized that part of individual variability in the parameters of the N170, a waveform that specifically marks the early, precategorical phases of human face processing, could be associated with genetic variation at the functional polymorphism of the catechol-O-methyltransferase (val(158)met) gene, which influences information processing, cognitive control tasks and patterns of brain activation during passive processing of human facial stimuli. Forty-nine third and fourth graders underwent a task of implicit processing of other children's facial expressions of emotions while ERPs were recorded. The N170 parameters (latency and amplitude) were insensitive to the type of expression, stimulus repetition, gender or school grade. Although limited by the absence of met- homozygotes among boys, data showed shorter N170 latency associated with the presence of 1-2 met158 alleles, and family-based association tests (as implemented in the PBAT version 2.6 software package) confirmed the association. These data were independent of the serotonin transporter promoter polymorphism and the N400 waveform investigated in the same group of children in a previous study. Some electrophysiological features of face processing may be stable from midchildhood onwards. Different waveforms generated by face processing may have at least partially independent genetic architectures and yield different implications toward the understanding of individual differences in cognition and emotions.

Modulation by muscarinic antagonists of the response to carbon dioxide challenge in panic disorder.

BACKGROUND: Panic attacks can be induced in persons with panic disorder by inhalation of carbon dioxide. Hypercapnia also elicits a reflex hyperventilation, which is controlled in part by cholinergic mechanisms. This study investigated whether the exaggerated response to carbon dioxide in panic disorder (PD) can be modulated by antagonists of muscarinic cholinergic receptors. METHODS: Twelve patients with PD received biperiden hydrochloride (a muscarinic antagonist that crosses the blood-brain barrier), pirenzepine hydrochloride (a muscarinic antagonist that does not cross the blood-brain barrier), or placebo 2 hours before a 35% carbon dioxide-65% oxygen respiratory challenge (vs air as a placebo) on 3 separate days, in a double-blind, random crossover design. RESULTS: According to patients' self-ratings of subjective anxiety, inhalation of the carbon dioxide/oxygen mixture provoked a significant and intense response after treatment with pirenzepine and placebo. After biperiden treatment, however, hypercapnia elicited a response profile similar to that elicited by air, whereby subjective anxiety remained similar to preinhalation levels. CONCLUSIONS: Consistent with the hypothesis of the study, a centrally active muscarinic antagonist can block the response to carbon dioxide commonly observed in subjects with PD.