Exploring Spin Distribution and Electronic Properties in FeN4-Graphene Catalysts with Edge Terminations.

Understanding the spin distribution in FeN4-doped graphene nanoribbons with zigzag and armchair terminations is crucial for tuning the electronic properties of graphene-supported non-platinum catalysts. Since the spin-polarized carbon and iron electronic states may act together to change the electronic properties of the doped graphene, we provide in this work a systematic evaluation using a periodic density-functional theory-based method of the variation of spin-moment distribution and electronic properties with the position and orientation of the FeN4 defects, and the edge terminations of the graphene nanoribbons. Antiferromagnetic and ferromagnetic spin ordering of the zigzag edges were considered. We reveal that the electronic structures in both zigzag and armchair geometries are very sensitive to the location of FeN4 defects, changing from semi-conducting (in-plane defect location) to half-metallic (at-edge defect location). The introduction of FeN4 defects at edge positions cancels the known dependence of the magnetic and electronic proper-ties of undoped graphene nanoribbons on their edge geometries. The implications of the reported results for catalysis are also discussed in view of the presented electronic and magnetic properties.

P-block single-metal-site tin/nitrogen-doped carbon fuel cell cathode catalyst for oxygen reduction reaction.

This contribution reports the discovery and analysis of a p-block Sn-based catalyst for the electroreduction of molecular oxygen in acidic conditions at fuel cell cathodes; the catalyst is free of platinum-group metals and contains single-metal-atom actives sites coordinated by nitrogen. The prepared SnNC catalysts meet and exceed state-of-the-art FeNC catalysts in terms of intrinsic catalytic turn-over frequency and hydrogen-air fuel cell power density. The SnNC-NH3 catalysts displayed a 40-50% higher current density than FeNC-NH3 at cell voltages below 0.7 V. Additional benefits include a highly favourable selectivity for the four-electron reduction pathway and a Fenton-inactive character of Sn. A range of analytical techniques combined with density functional theory calculations indicate that stannic Sn(IV)Nx single-metal sites with moderate oxygen chemisorption properties and low pyridinic N coordination numbers act as catalytically active moieties. The superior proton-exchange membrane fuel cell performance of SnNC cathode catalysts under realistic, hydrogen-air fuel cell conditions, particularly after NH3 activation treatment, makes them a promising alternative to today's state-of-the-art Fe-based catalysts.

The effect of Pd ensemble structure on the O2 dissociation and CO oxidation mechanisms on Au-Pd(100) surface alloys.

The reactivity of various Pd ensembles on the Au-Pd(100) alloy catalyst toward CO oxidation was investigated by using density functional theory (DFT). This study was prompted by the search for efficient catalysts operating at low temperature for the CO oxidation reaction that is of primary environmental importance. To this aim, we considered Pd modified Au(100) surfaces including Pd monomers, Pd dimers, second neighboring Pd atoms, and Pd chains in a comparative study of the minimum energy reaction pathways. The effect of dispersion interactions was included in the calculations of the O2 dissociation reaction pathway by using the DFT-D3 scheme. The addition of the dispersion interaction strongly improves the adsorption ability of O2 on the Au-Pd surface but does not affect the activation energy barriers of the Transitions States (TSs). As for O2 to dissociate, it is imperative that the TS has lower activation energy than the O2 desorption energy. DFT-D3 is found to favor, in some cases, O2 dissociation on configurations being identified from uncorrected DFT calculations as inactive. This is the case of the second neighboring Pd configuration for which uncorrected DFT predicts positive Gibbs free energy (ΔG) of the O2 adsorption, therefore an endergonic reaction. With the addition of D3 correction, ΔG becomes negative that reveals a spontaneous O2 adsorption. Among the investigated Au-Pd (100) ensembles, the Pd chain dissociates most easily O2 and highly stabilizes the dissociated O atoms; however, it has an inferior reactivity toward CO oxidation and CO2 formation. Indeed, CO strongly adsorbs on the palladium bridge sites and therefore poisoning the surface Pd chain. By contrast, the second neighboring Pd configuration that shows somewhat lower ability to dissociate O2 turns out to be more reactive in the CO2 formation step. These results evidence the complex effect of Pd ensembles on the CO oxidation reaction. Associative CO oxidation proceeds with high energy barriers on all the considered Pd ensembles and should be excluded, in agreement with experimental observations.

Investigation of finite-size effects in chemical bonding of AuPd nanoalloys.

In this paper, the size-dependent changes in energetic, vibrational, and electronic properties of C-O gas molecule interacting with surface Pd atom of a variety of AuPd nanoalloy structures are investigated by means of first principles calculations. The variation in C-O adsorption energies, C-O vibration frequencies (νC-O), and Pd d-bond centers (εd) on a series of non-supported Aun-1-Pd1 nanoparticles (with n varying from 13 to 147) and on two semi-finite surfaces are inspected with cluster size. We demonstrate for the first time that, with small AuPd bimetallic three-dimensional clusters as TOh38, one can reach cluster size convergence even for such a sensitive observable as the adsorption energy on a metal surface. Indeed, the results show that the adsorbate-induced perturbation is extremely local and it only concerns the isolated Pd interacting with the reactive gas molecule. Except for 13 atom clusters, in which molecular behaviour is predominant, no finite-size effects are observed for surface Pd atom substituted in AuPd free nanoclusters above 38 atoms.