Engineering electrode interfaces for telecom-band photodetection in MoS2/Au heterostructures via sub-band light absorption.

Transition metal dichalcogenide (TMD) layered semiconductors possess immense potential in the design of photonic, electronic, optoelectronic, and sensor devices. However, the sub-bandgap light absorption of TMD in the range from near-infrared (NIR) to short-wavelength infrared (SWIR) is insufficient for applications beyond the bandgap limit. Herein, we report that the sub-bandgap photoresponse of MoS2/Au heterostructures can be robustly modulated by the electrode fabrication method employed. We observed up to 60% sub-bandgap absorption in the MoS2/Au heterostructure, which includes the hybridized interface, where the Au layer was applied via sputter deposition. The greatly enhanced absorption of sub-bandgap light is due to the planar cavity formed by MoS2 and Au; as such, the absorption spectrum can be tuned by altering the thickness of the MoS2 layer. Photocurrent in the SWIR wavelength range increases due to increased absorption, which means that broad wavelength detection from visible toward SWIR is possible. We also achieved rapid photoresponse (~150 µs) and high responsivity (17 mA W-1) at an excitation wavelength of 1550 nm. Our findings demonstrate a facile method for optical property modulation using metal electrode engineering and for realizing SWIR photodetection in wide-bandgap 2D materials.

Exciton Transfer at Heterointerfaces of MoS2 Monolayers and Fluorescent Molecular Aggregates.

Integration of distinct materials to form heterostructures enables the proposal of new functional devices based on emergent physical phenomena beyond the properties of the constituent materials. The optical responses and electrical transport characteristics of heterostructures depend on the charge and exciton transfer (CT and ET) at the interfaces, determined by the interfacial energy level alignment. In this work, heterostructures consisting of aggregates of fluorescent molecules (DY1) and 2D semiconductor MoS2 monolayers are fabricated. Photoluminescence spectra of DY1/MoS2 show quenching of the DY1 emission and enhancement of the MoS2 emission, indicating a strong electronic interaction between these two materials. Nanoscopic mappings of the light-induced contact potential difference changes rule out the CT process at the interface. Using femtosecond transient absorption spectroscopy, the rapid interfacial ET process from DY1 aggregates to MoS2 and a fourfold extension of the exciton lifetime in MoS2 are elucidated. These results suggest that the integration of 2D inorganic semiconductors with fluorescent molecules can provide versatile approaches to engineer the physical characteristics of materials for both fundamental studies and novel optoelectronic device applications.

Transient Strain-Induced Electronic Structure Modulation in a Semiconducting Polymer Imaged by Scanning Ultrafast Electron Microscopy.

Understanding the optoelectronic properties of semiconducting polymers under external strain is essential for their applications in flexible devices. Although prior studies have highlighted the impact of static and macroscopic strains, assessing the effect of a local transient deformation before structural relaxation occurs remains challenging. Here, we employ scanning ultrafast electron microscopy (SUEM) to image the dynamics of a photoinduced transient strain in the semiconducting polymer poly(3-hexylthiophene) (P3HT). We observe that the photoinduced SUEM contrast, corresponding to the local change of secondary electron emission, exhibits an unusual ring-shaped profile. We attribute the observation to the electronic structure modulation of P3HT caused by a photoinduced strain field owing to its low modulus and strong electron-lattice coupling, supported by a finite-element analysis. Our work provides insights into tailoring optoelectronic properties using transient mechanical deformation in semiconducting polymers and demonstrates the versatility of SUEM to study photophysical processes in diverse materials.

Light-Switchable and Self-Healable Polymer Electrolytes Based on Dynamic Diarylethene and Metal-Ion Coordination.

Self-healing polymer electrolytes are reported with light-switchable conductivity based on dynamic N-donor ligand-containing diarylethene (DAE) and multivalent Ni2+ metal-ion coordination. Specifically, a polystyrene polymer grafted with poly(ethylene glycol-r-DAE)acrylate copolymer side chains was effectively cross-linked with nickel(II) bis(trifluoromethanesulfonimide) (Ni(TFSI)2) salts to form a dynamic network capable of self-healing with fast exchange kinetics under mild conditions. Furthermore, as a photoswitching compound, the DAE undergoes a reversible structural and electronic rearrangement that changes the binding strength of the DAE-Ni2+ complex under irradiation. This can be observed in the DAE-containing polymer electrolyte where irradiation with UV light triggers an increase in the resistance of solid films, which can be recovered with subsequent visible light irradiation. The increase in resistance under UV light irradiation indicates a decrease in ion mobility after photoswitching, which is consistent with the stronger binding strength of ring-closed DAE isomers with Ni2+. 1H-15N heteronuclear multiple-bond correlation nuclear magnetic resonance (HMBC NMR) spectroscopy, continuous wave electron paramagnetic resonance (cw EPR) spectroscopy, and density functional theory (DFT) calculations confirm the increase in binding strength between ring-closed DAE with metals. Rheological and in situ ion conductivity measurements show that these polymer electrolytes efficiently heal to recover their mechanical properties and ion conductivity after damage, illustrating potential applications in smart electronics.

Redox-Active Polymeric Ionic Liquids with Pendant N-Substituted Phenothiazine.

Polymers that are elastic while supporting charge transport are desirable for flexible and soft electronics. Many polymers with bulky and conjugated redox-active pendant units have high glass transition temperatures (Tg) in their neutral form that will not lead to elasticity at room temperature. Their behavior in charged form in the solid state without an electrolyte has not been extensively studied. Here, the design strategy of polymeric ionic liquid where two weakly interacting ionic groups are used to maintain a low Tg is shown to lead to flexible redox active polymers. The use of a flexible ethylene backbone and redox-active phenothiazine (PTZ)-based pendant group resulted in polymers with relatively low Tg that are electrically conductive. PTZ that was N-substituted with 2-(2-ethoxyethoxy)ethoxy)ethyl was found to promote solubility of the polymer and lower the Tg of the neutral polymer by ∼150 °C relative to that of the Tg of a variant without the N-substituent. Doping with trifluoromethanesulfonimide leads to an electrically conductive polymer without significantly increasing the Tg. Physical characterization by UV-vis-NIR spectroscopy, electron spin resonance spectroscopy, and impedance spectroscopy verified that the molecular design leads to an efficient charge hopping between the PTZ groups.

Long-Range Order Self-Assembly of Conjugated Block Copolymers at Inclined Air-Liquid Interfaces.

Here, we report that long-range order, direction-controlled, ultrathin conjugated polymer films can be formed by the self-assembly of conjugated block copolymers (i.e., poly(3-hexylthiophene)-block-poly(ethylene glycol)) at inclined air-water interfaces. Structure analyses revealed well-aligned nanowire arrays of poly(3-hexylthiophene) with a dramatically increased ordered domain size compared to the polymer films formed on a flat water surface. The improved degree of order was attributed to the flow field created by the enhanced solvent evaporation at the top of the water contact line. Note that it is challenging to prepare such well-ordered and molecularly thin films of conjugated polymers by conventional fabrication methods. The long-range order polymer film showed hole mobility an order of magnitude higher than polymer films formed on a flat interface when implemented as an active layer of field-effect transistor devices. This study demonstrates that a simple interface modification can significantly impact the self-assembly process, structure, and function of polymer films formed at the air-liquid interface.

Binary Self-Assembly of Conjugated Block Copolymers and Quantum Dots at the Air-Liquid Interface into Ordered Functional Nanoarrays.

Controlling the nanoscale morphology of conducting polymer/nanoparticle hybrid films is a highly desired but challenging task. Here, we report that such functional hybrid films with unprecedented structural order can be formed through the self-assembly of conjugated block copolymers and CdSe quantum dots at the air-water interface. The one-step assembly of quantum dots and block copolymers composed of polythiophene and polyethylene glycol (P3HT-b-PEG) at the fluidic interface generated a highly ordered assembly structure of P3HT nanowires and one-dimensional quantum dot arrays. Structure analyses revealed a unique self-assembly behavior and size dependency, which are distinct from the conventional self-assembly of coil-type polymers on solid substrates. Interestingly, hydrophobic quantum dots reside at the interface between P3HT and PEG domains without disrupting the P3HT packing structure, which is advantageous for the optoelectronic properties. Furthermore, large particles bridge the P3HT nanowires at both ends, while small particles decorate each P3HT/PEG interfaces, thus forming tight p-n junctions for a broad size range of nanoparticles. The nanoparticle-incorporated hybrid films showed more than an order of magnitude higher photocurrent and light sensitivity compared to polymer-only films, consistent with the assembly structure with close contact between the organic and inorganic semiconductors.

Air-Liquid Interfacial Self-Assembly of Non-Amphiphilic Poly(3-hexylthiophene) Homopolymers.

Here, we demonstrate that the self-assembly of poly(3-hexylthiophene) (P3HT) at the air-water interface can lead to free-standing films of densely packed P3HT nanowires. Interfacial self-assembly on various liquid subphases, such as water, diethylene glycol, and glycerol, indicates that the viscosity of the subphase is an important factor for the formation of well-ordered nanostructures. The thin-film morphology is also sensitive to the concentration of P3HT, its molecular weight (MW), and the presence of oxidative defects. The densely packed nanowire films can be easily transferred to solid substrates for device applications. The ultrathin films of P3HT prepared by the interfacial assembly showed significantly higher hole mobility (∼3.6 × 10-2 cm2/V s) in a field-effect transistor than comparably thin spin-cast films. This work demonstrates that the air-liquid interfacial assembly is not limited to amphiphilic polymers and can, under optimized conditions, be applied to fabricate ultrathin films of widely used conjugated polymers with controlled morphologies.

Proteomic analysis of liver in miniature pigs according to developmental stages using two-dimensional electrophoresis and matrix-assisted laser desorption/ionization-time of flight mass spectrometry.

Due to the shortage of human organ donors for transplant, various studies of xenotransplantation, or the use of animal organs instead of human organs, have been carried out. The organs of porcine are thought to be safer and of a more suitable size for xenotransplantationthan those of nonhuman primates. Understanding the levels of expression of proteins, and their post-translational regulation, would be very practical between different species and among developing stages, though the molecular profiling for xenotransplantation has been rarely studied for porcine, while that of human and rodent is well known. Here, in this present study, we report protein regulation of the developing stages of liver (4-day old neonate, 19-day old piglet and 14-month old adult miniature pigs) using 2-DE and MALDI-TOF. From images of the three different stages, a total of 8 spotswhich were differently regulated were identified, and 5 spots were identified with MALDI-TOF MS. The data presented within this study provides critical direction relating to the development of livers of miniature pigs, which will assist future proteome analysis of the liver, and advance our understanding of the hurdles facing xenotransplantaion.