The Development of a Measuring System for Intraoral SpO2.

Blood oxygen saturation (SpO2) is an essential indicator of a patient's general condition. However, conventional measurement methods have some issues such as time delay and interference by ambient light. Improved measurement methods must be developed, and there are no reports on intraoral measurements of SpO2 using wearable devices. Therefore, we aimed to establish an intraoral SpO2 measurement method for the first time. Twelve healthy adults participated in this study. The following steps were taken: (1) to identify the optimal measurement location, mid-perfusion index (PI) values were measured at six places on the mucosa of the maxilla, (2) to validate the optimal measurement pressure, PI values were obtained at different pressures, and (3) using the proposed mouthpiece device, SpO2 values in the oral cavity and on the finger were analyzed during breath-holding. The highest PI values were observed in the palatal gingiva of the maxillary canine teeth, with high PI values at pressures ranging from 0.3 to 0.8 N. In addition, changes in SpO2 were detected approximately 7 s faster in the oral cavity than those on the finger, which is attributed to their proximity to the heart. This study demonstrates the advantage of the oral cavity for acquiring biological information using a novel device.

Verification of mechanical load generated by functional orthodontic appliances.

Functional appliances are widely used for promoting mandibular growth by utilizing a construction bite position. We aimed to measure the mechanical load generated by movement of functional appliances and determine the factors influencing this load. Thirteen patients aged 8-12 years were selected for the study, and the load was measured using a previously developed measurement device. To investigate the factors affecting the load, the temporomandibular joint morphology and muscles related to the mandible were examined using cone-beam computed tomography. The standard regression coefficients of the factors affecting the load per millimeter of movement distance were 0.64 and 0.66 for (a) the inclination of the articular eminence and (b) the angle between occlusal plane and posterior temporalis, respectively. Measurement of the occlusal plane to the posterior temporalis and the inclination of the articular eminence were significantly different (p < 0.05). The angle of inclination of the articular eminence emerged as a strong influencing factor. Similarly, the influence of measurements from the occlusal plane to the posterior temporalis was considerable since the posterior temporalis muscle is the most active when the mandible is extended forward. We also found a possible relationship between the occlusal force and load at the construction bite position. To our knowledge, this is the first study to determine the actual load associated with the angle of the temporalis muscle to the occlusal plane, inclination angle of the articular eminence, angle between the occlusal plane and the Frankfort plane, and the angle between the geniohyoid muscle and the occlusal plane. Therefore, mechanical considerations need to be more accurate to facilitate safe orthodontic treatment.