Optimal acceleration voltage for near-atomic resolution imaging of layer-stacked 2D polymer thin films.

Despite superb instrumental resolution in modern transmission electron microscopes (TEM), high-resolution imaging of organic two-dimensional (2D) materials is a formidable task. Here, we present that the appropriate selection of the incident electron energy plays a crucial role in reducing the gap between achievable resolution in the image and the instrumental limit. Among a broad range of electron acceleration voltages (300 kV, 200 kV, 120 kV, and 80 kV) tested, we found that the highest resolution in the HRTEM image is achieved at 120 kV, which is 1.9 Å. In two imine-based 2D polymer thin films, unexpected molecular interstitial defects were unraveled. Their structural nature is identified with the aid of quantum mechanical calculations. Furthermore, the increased image resolution and enhanced image contrast at 120 kV enabled the detection of functional groups at the pore interfaces. The experimental setup has also been employed for an amorphous organic 2D material.

Oriented Growth of Thin Films of Covalent Organic Frameworks with Large Single-Crystalline Domains on the Water Surface.

It has been a longstanding challenge to rationally synthesize thin films of organic two-dimensional (2D) crystals with large single-crystalline domains. Here, we present a general strategy for the creation of 2D crystals of covalent organic frameworks (COFs) on the water surface, assisted by a charged polymer. The morphology of the preorganized monomers underneath the charged polymer on the water surface and their diffusion were crucial for the formation of the organic 2D crystals. Thin films of 2D COFs with an average single-crystalline domain size of around 3.57 ± 2.57 µm2 have been achieved, and their lattice structure, molecular structure, and grain boundaries were identified with a resolution down to 3 Å. The swing of chain segments and lattice distortion were revealed as key factors in compensating for the misorientation between adjacent grains and facilitating error corrections at the grain boundaries, giving rise to larger single-crystalline domains. The generality of the synthesis method was further proved with three additional 2D COFs. The oriented single-crystalline domains and clear grain boundaries render the films as model materials to study the dependence of the vertical conductivity of organic 2D crystals on domain sizes and chemical structures, and significant grain boundary effects were illustrated. This study presents a breakthrough in the controlled synthesis of organic 2D crystals with structural control at the molecular level. We envisage that this work will inspire further investigation into the microstructure-intrinsic property correlation of 2D COFs and boost their application in electronics.

Tungsten Oxide/Reduced Graphene Oxide Aerogel with Low-Content Platinum as High-Performance Electrocatalyst for Hydrogen Evolution Reaction.

Designing cost-effective, highly active, and durable platinum (Pt)-based electrocatalysts is a crucial endeavor in electrochemical hydrogen evolution reaction (HER). Herein, the low-content Pt (0.8 wt%)/tungsten oxide/reduced graphene oxide aerogel (LPWGA) electrocatalyst with excellent HER activity and durability is developed by employing a tungsten oxide/reduced graphene oxide aerogel (WGA) obtained from a facile solvothermal process as a support, followed by electrochemical deposition of Pt nanoparticles. The WGA support with abundant oxygen vacancies and hierarchical pores plays the roles of anchoring the Pt nanoparticles, supplying continuous mass transport and electron transfer channels, and modulating the surface electronic state of Pt, which endow the LPWGA with both high HER activity and durability. Even under a low loading of 0.81 µgPt cm-2 , the LPWGA exhibits a high HER activity with an overpotential of 42 mV at 10 mA cm-2 , an excellent stability under 10000-cycle cyclic voltammetry and 40 h chronopotentiometry at 10 mA cm-2 , a low Tafel slope (30 mV dec-1 ), and a high turnover frequency of 29.05 s-1 at η = 50 mV, which is much superior to the commercial Pt/C and the low-content Pt/reduced graphene oxide aerogel. This work provides a new strategy to design high-performance Pt-based electrocatalysts with greatly reduced use of Pt.

Cellulose Nanocrystals as Template for Improving the Crystallinity of Two-Dimensional Covalent Organic Framework Films.

Despite the rapid development of two-dimensional covalent organic frameworks (2D COFs) in recent years, it remains a great challenge to synthesize highly crystalline COF materials. Here, a CNC-assisted approach was adopted to synthesize high crystallinity COF materials. A series of 2D COF films were synthesized at the air-water interface by using cellulose nanocrystals (CNCs) as the template. The occurrence of Schiff reactions based on the imine bond was demonstrated by Raman spectroscopy and Fourier transform infrared spectroscopy (FTIR). Scanning electron microscopy (SEM) exhibited the appearances of 2D COF films were flower-like. When CNCs were added to a certain extent, the size of a single petal in the flowers gradually increased with the amount of CNCs. The film with large petals was characterized by Ultraviolet-Visible diffuse reflectance spectroscopy (UV-Vis DRS), X-ray photoelectron spectroscopy (XPS), transmission electron microscopy (TEM), and selected area electron diffraction (SAED). In UV-Vis DRS curves, the S-band of COF-366 film was red-shifted by 24 nm compared with that of 5,10,15,20-tetrakis(4-aminophenyl)-21H,23H-porphyrin (TAPP), confirming the existence of extended conjugation in COF-366 film. XPS was used to identify the surface composition of the sample. The N1s signal of the film indicated that each TAPP formed four imine bonds with 2,5-dihydroxyterephthalaldehyde (DHTA) in COF-366 film. TEM images showed that CNCs had an influence on the crystal size. It was observed from SAED that the crystallinity of the film with CNCs was higher than the film without CNCs. This work provided a new template for improving the crystallinity of 2D COF films.