RESUMO
STATEMENT OF PROBLEM: Applying stains to the intaglio surface of computer-aided design and computer-aided manufacturing (CAD-CAM) monolithic ceramic restorations has been proposed as an option to help mask darkened substrates. However, little is known about the effects of this procedure on the adhesion between the resin cement and the ceramic. PURPOSE: The purpose of this in vitro study was to evaluate the effect of intaglio surface staining on the microshear bond strength between 2 CAD-CAM ceramics and a resin cement. MATERIAL AND METHODS: Lithium disilicate (Gmax) and leucite-reinforced (Gpress) ceramic blocks were sectioned, crystalized when indicated, and polished. They received either none, 1, or 2 layers of ceramic stains and a glaze liquid mixture followed by a firing cycle. The surfaces of groups Gmax0, Gmax1, and Gmax2 were etched with 9% hydrofluoric acid etching (HF) for 20 seconds, and those of groups Gpress0 and Gpress1 were etched for 60 seconds. After rinsing and drying, a ceramic primer was applied and air-dried. Resin cement rods (n=24 per group) were built from a silicone mold. Specimens were stored in distilled water for 24 hours before microshear bond testing. Failure mode was observed under a digital microscope. Data were analyzed by using the Kruskal-Wallis and Mann-Whitney nonparametric tests (α=.05). RESULTS: Intaglio staining negatively affected the microshear bond strength for both ceramics. A significant difference was observed between Gmax1 (3.5 ±1.73 MPa) and Gmax2 (3.7 ±2.1 MPa) when compared with Gmax0 (14.2 ±4.4 MPa) and also between GPress0 (25.7 ±5.1 MPa) and Gpress1 (1.8 ±2.7 MPa). No difference was observed between 1 and 2 stain layers for Gmax. Most failures were adhesive for Gmax0, mixed for Gpress, and cohesive within the stain layer for experimental groups. CONCLUSIONS: Intaglio surface staining with a stain and glaze mixture caused a significant reduction in bond strength between resin cement and both ceramics tested.