Detection of Dibutyl Phthalate in Surface Water by Fluorescence Polarization Immunoassay.

Dibutyl phthalate (DBP) is widely used as a plasticizer in the production of polymeric materials to give them flexibility, strength and extensibility. However, due to its negative impact on human health, in particular reproductive functions and fetal development, the content of DBP must be controlled in food and the environment. The present study aims to develop a sensitive, fast and simple fluorescence polarization immunoassay (FPIA) using monoclonal antibodies derived against DBP (MAb-DBP) for its detection in open waters. New conjugates of DBP with various fluorescein derivatives were obtained and characterized: 5-aminomethylfluorescein (AMF) and dichlorotriazinylaminofluorescein (DTAF). The advantages of using the DBP-AMF conjugate in the FPIA method are shown, the kinetics of binding of this chemical with antibodies are studied, the analysis is optimized, and the concentration of monoclonal antibodies is selected for sensitivity analysis-16 nM. The calibration dependence of the fluorescence polarization signal for the detection of DBP was obtained. The observed IC50 (DBP concentration at which a 50% decrease in the fluorescence polarization signal occurs, 40 ng/mL) and the limit of detection (LOD, 7.5 ng/mL) values were improved by a factor of 45 over the previously described FPIA using polyclonal antibodies. This technique was tested by the recovery method, and the high percentage of DBP discovery in water ranged from 85 to 110%. Using the developed method, real water samples from Lake Onega were tested, and a good correlation was shown between the results of the determination of DBP by the FPIA method and GC-MS. Thus, the FPIA method developed in this work can be used to determine DBP in open-water reservoirs.

Estimating population-level of alcohol, tobacco and morphine use in a small Russian region using wastewater-based epidemiology.

INTRODUCTION: Alcohol, tobacco and illicit drug use combined are the largest modifiable health risk factors. Wastewater-based epidemiology (WBE) is a complementary approach for monitoring substance use in the population. In this study we applied WBE technique to a community in the Moscow region to estimate population-level consumption of alcohol, tobacco and morphine. METHODS: Wastewater sampling was carried out over 47 days, in 2018 and 2019, including the New Year period. Analysis of the samples for consumption biomarkers (ethyl sulphate, cotinine and morphine) were undertaken using liquid chromatography tandem mass spectrometry (LC-MS/MS). Daily consumption estimates were then compared with sales/production/prescription data and between different days of the week using Mann-Whitney U test. RESULTS: Alcohol consumption was significantly higher on Sundays and during the New Year and Russian Christmas period compared to weekdays and Saturdays. Tobacco consumption estimates were largely consistent throughout the week. Morphine was detected by WBE during the monitoring period but was inconsistent with prescription record data. DISCUSSION AND CONCLUSIONS: This study provides evidence for the feasibility of conducting WBE in Russia. Estimates of alcohol consumption derived from WBE were higher than average alcohol sales data for the country. The estimated consumption of nicotine is generally consistent with the production data, with estimates higher than in most other countries. Our results also suggest potential illegal use of opioids (morphine-based) in the population. Given the considerable health and economic costs of substance use in Russia, more extensive WBE testing is recommended to inform and evaluate public health policies.

A novel simple and sensitive approach for determination of 1,1-dimethylhydrazine in aqueous samples by high performance liquid chromatography with ultraviolet and tandem mass spectrometric detection after derivatization with unsubstituted aromatic aldehydes.

In this work, simple, rapid and highly sensitive method of hazardous chemical 1,1-dimethylhydrazine (unsymmetrical dimethylhydrazine, UDMH) determination based on pre-column derivatization with unsubstituted aromatic aldehydes and reversed-phase high performance liquid chromatography-ultraviolet-tandem mass spectrometry (RP HPLC-UV-MS/MS) has been developed. Along with benzaldehyde, commercially available aromatic aldehydes, namely: 2-naphthaldehyde, 2-pyridinecarboxaldehyde, and 2-quinolinecarboxaldehyde, were used as derivatizing reagents in the analysis of hydrazines for the first time. The reactions were studied in a wide pH range by varying reaction time and other conditions. A slightly alkaline pH 9 was shown to be optimal for the derivatization of UDMH by aromatic aldehydes. The quantitative yield of derivatization products under the established conditions was confirmed by HPLC analysis with amperometric detection. For all studied reagents, wide linear ranges of concentrations (0.01-1000 µg/L) in natural water samples were observed. The limits of detection for UDMH in natural water were in the 3.7-130 ng/L range. 2-Quinolinecarboxaldehyde was selected as the most appropriate reagent for HPLC-UV-MS/MS determination of UDMH. In case of using this reagent, the accuracy was in the range of 97-102%, and precision, expressed as RSD was less than 8%. The developed approach does not require laborious stages of pre-concentration and isolation of UDMH from natural water components.

Effect of monomer mixture composition on structure and chromatographic properties of poly(divinylbenzene-co-ethylvinylbenzene-co-2-hydroxyethyl methacrylate) monolithic rod columns for separation of small molecules.

Porous poly(divinylbenzene-co-ethylvinylbenzene-co-2-hydroxyethyl methacrylate) monoliths were synthesized via thermally initiated free-radical polymerization in confines of surface-vinylized glass columns (150 mm × 3 mm i.d.) and applied to the reversed-phase separation of low-molecular-weight aromatic compounds. In order to compensate for the polymer shrinkage during the synthesis and prevent the monolith from detachment from the column wall, polymerization was conducted under nitrogen pressure. The reaction proceeded at 60°C for 22 h. 2,2'-Azo-bis-isobutironitrile was used as the initiator and 1-dodecanol was used as the porogen. A series of monoliths with different monomer ratios were obtained. All the monoliths had high specific surface areas ranging from 370 to 490 m(2)/g. In the studied range of monomer mixture compositions, the mechanical stability of the stationary phase in water/acetonitrile eluents was found to be high enough and practically insensitive to the fraction of 2-hydroxyethyl methacrylate (HEMA). Increasing the molar fraction of HEMA from 10.5% to 14.7% resulted in the decrease of column permeability by two orders of magnitude (from 1.1×10(-12) to 1.8×10(-14) m(2)) and led to weaker retention of alkylbenzenes. The higher HEMA content was shown to reduce the plate height of the columns in the separation of small molecules from 160-490 µm to 40-76 µm. This was attributed mainly to the decrease of the domain size of the monoliths leading to lower eddy dispersion and mass transfer resistance in the column.

The selectivity in MEKC of pseudo-stationary phases based on polyelectrolyte complexes: I. Composition of the complex.

Polyelectrolyte-surfactant complexes (PSC) of polycarboxylic acids with alkyl-trimethylammonium salts look very promising as a new type of pseudo-stationary phase in micellar electrokinetic chromatography. PSC produce an intramolecular micellar phase, and the morphology of the micelles is significantly different from that of the corresponding "typical" surfactant micelles. Pseudo-stationary phases based on PSC have unique selectivity. In this paper, the effect of the composition (phi) of the PSC of polyacrylic acid (PAA) M(W) 130,000 with dodecyltrimethylammonium bromide (DTAB) and of the PSC of PAA M(W) 450,000 with DTAB on the separation of DNS-amino acids and phenol derivatives in these systems was investigated. Relative retention and relative selectivity were used to describe the electrophoretic behavior of the amino acids and phenol derivatives. The main advantage of PSC pseudo-phases is that the nature and the structure of micelle-like units, and hence the selectivity of electrophoretic separation, could easily be modified by changing the composition of the complex.

Micellar electrokinetic chromatography with polyelectrolyte complexes as micellar pseudo-stationary phases.

The separation of dansyl (DNS-AAs) and carbobenzoxy (CBZ-AAs) amino acids using micellar electrokinetic chromatography employing polyelectrolyte-surfactant complexes (PSC) formed in the reaction between polyacrylic acid (PAA) and dodecyltrimethylammonium bromide (DTAB) as pseudo-stationary phases was described. The PSCs were stabilized by hydrophobic interactions of alkyl chains of the surfactant ions and converted to an intramolecular micellar-like phase. The running buffer was a 50mM solution of sodium phosphate (pH 6.0) containing 4.6-20.2mM PSC, in which a part of carboxyl groups of PAA was blocked by aliphatic amines. For the systems with 7.9mM of PAA/DTAB complex (phi=0.30, phi-composition of water-soluble polyelectrolyte complex) as a pseudo-stationary phase, the peaks of six dansyl amino acids (DNS-AAs) were baseline resolved. The separation in this case is based on a complex distribution mechanism of the dansyl derivatives between the free buffer and the intramolecular micellar-like phase of the water-soluble PSC. On the other hand, the additives of PAA/DTAB complex (phi=0.30) to the running buffer does not essentially affect on the electrophoretic behaviour of the CBZ-AAs, the variant MEKC is not realized. The influence of the concentration of the complex of PAA/DTAB on the electrophoretic behaviour of analytes was investigated. Relative retentions and relative selectivities were used for describing electrophoretic behaviour of the amino acid derivatives.

Sulfonated and sulfoacylated poly(styrene-divinylbenzene) copolymers as packing materials for cation chromatography.

Three different types of cation exchangers were produced from four basic poly(styrene-divinylbenzene) substrates with different properties. Porous PS-DVB resin beads were functionalized by sulfonation and sulfoacylation under various conditions to produce sulfonated resins with exchange capacities of 0.03-1.80 mM g(-1). The matrix with 50% of cross-linking is most suitable for updating by the proposed technique. Sulfuric and chlorosulfonic acids were used as the reagents for sulfonation. The sulfonating conditions, capacities, and the technique of the synthesis are given. The effects of parameters of the sulfonation reaction and the composition of the reactionary mixture on ion-exchange capacity of the sorbents were investigated. Selectivity and efficiency of the separation of some inorganic cations and derivatives of amines and hydrazines on the resins obtained are compared by ion chromatography with conductometric detection. As a result, the sulfoacylated resin was proved more efficient for the separation of these analytes. The resolution of the analytes strongly depends on the degree of functionalization. The best performance about 19,000 plates m(-1) was obtained using the sulfopropionylated beads with an ion-exchange capacity of 0.3 mM g(-1). The prepared sulfoacylated cation exchanger was compared with the commercially available Dionex CS-12 packing material. It was found that the separation of alkaline ions and 1,1-dimethylhydrazine (UDMH) were much better that those for the commercial material.