Electronic structure dynamics in a low bandgap polymer studied by time-resolved photoelectron spectroscopy.

Means to measure the temporal evolution following a photo-excitation in conjugated polymers are a key for the understanding and optimization of their function in applications such as organic solar cells. In this paper we study the electronic structure dynamics by direct pump-probe measurements of the excited electrons in such materials. Specifically, we carried out a time-resolved photoelectron spectroscopy (TRPES) study of the polymer PCPDTBT by combining an extreme ultraviolet (XUV) high harmonic generation source with a time-of-flight spectrometer. After excitation to either the 1st excited state or to a higher excited state, we follow how the electronic structure develops and relaxes on the electron binding energy scale. Specifically, we follow a less than 50 fs relaxation of the higher exited state and a 10 times slower relaxation of the 1st excited state. We corroborate the results using DFT calculations. Our study demonstrates the power of TRPES for studying photo-excited electron energetics and dynamics of solar cell materials.

Versatile high-repetition-rate phase-locked chopper system for fast timing experiments in the vacuum ultraviolet and x-ray spectral region.

A novel light chopper system for fast timing experiments in the vacuum-ultraviolet (VUV) and x-ray spectral region has been developed. It can be phase-locked and synchronized with a synchrotron radiation storage ring, accommodating repetition rates in the range of ~8 to ~120 kHz by choosing different sets of apertures and subharmonics of the ring frequency (MHz range). Also the opening time of the system can be varied from some nanoseconds to several microseconds to meet the needs of a broad range of applications. Adjusting these parameters, the device can be used either for the generation of single light pulses or pulse packages from a microwave driven, continuous He gas discharge lamp or from storage rings which are otherwise often considered as quasi-continuous light sources. This chopper can be utilized for many different kinds of experiments enabling, for example, unambiguous time-of-flight (TOF) multi-electron coincidence studies of atoms and molecules excited by a single light pulse as well as time-resolved visible laser pump x-ray probe electron spectroscopy of condensed matter in the valence and core level region.

Molecular-scale interface engineering of nanocrystalline titania by co-adsorbents for solar energy conversion.

The use of mixed self-assembled monolayers, combining hydrophobic co-adsorbents with the sensitizer, has been demonstrated to enhance the efficiency of dye-sensitized solar cells (DSCs). Herein, the influence of the anchoring groups of the co-adsorbents on the performance of the DSCs is carefully examined by selecting two model molecules: neohexyl phosphonic acid (NHOOP) and bis-(3,3-dimethyl-butyl)-phosphinic acid (DINHOP). The effect of these co-adsorbents on the photovoltaic performance (J-V curves, incident photon-to-electron conversion efficiency) is investigated. Photoelectron spectroscopy and electrochemical impedance spectroscopy are performed to assess the spatial configuration of adsorbed dye and co-adsorbent molecules. The photoelectron spectroscopy studies indicate that the ligands of the ruthenium complex, containing thiophene groups, point out away from the surface of TiO(2) in comparison with the NCS group.

Energy alignment and surface dipoles of rylene dyes adsorbed to TiO2 nanoparticles.

The energy loss in dye-sensitized solar cells calculated from the energy difference between the lowest electronic transition of the dye and the obtained open-circuit voltage is often 1 eV or even more. To minimize this loss, it is important to accurately determine the energy alignment at the TiO(2)/dye/redox-mediator interface. In this study, we compared the results from electrochemistry and photoelectron spectroscopy for determining the energy alignment of three rylene dyes, two of which absorb relatively far in the red. The trends observed with the methods were different, as in the former, the energy alignment is measured relative to an external reference and includes contributions from solvent reorganization energies, while in the latter, it is measured relative to the energetics of the TiO(2) and is lacking such contributions. The influence of the dyes' dipole moments on the energetics of the TiO(2) was also measured and explained some of the differences in trends. Finally, we compared the injection efficiencies of the two red-absorbing dyes and found that the differences in injection efficiencies can be better explained using the energy alignment determined from photoelectron spectroscopy. This shows that the method for measuring the energetics of a DSC should be chosen according to what process one intends to study.

Mapping the frontier electronic structures of triphenylamine based organic dyes at TiO2 interfaces.

The frontier electronic structures of a series of organic dye molecules containing a triphenylamine moiety, a thiophene moiety and a cyanoacrylic acid moiety have been investigated by photoelectron spectroscopy (PES), X-ray absorption spectroscopy (XAS), X-ray emission spectroscopy (XES) and resonant photoelectron spectroscopy (RPES). The experimental results were compared to electronic structure calculations on the molecules, which are used to confirm and enrich the assignment of the spectra. The approach allows us to experimentally measure and interpret the basic valence energy level structure in the dye, including the highest occupied energy level and how it depends on the interaction between the different units. Based on N 1s X-ray absorption and emission spectra we also obtain insight into the structure of the excited states, the molecular orbital composition and dynamics. Together the results provide an experimentally determined energy level map useful in the design of these types of materials. Included are also results indicating femtosecond charge redistribution at the dye/TiO(2) interface.

Electronic and molecular structures of organic dye/TiO(2) interfaces for solar cell applications: a core level photoelectron spectroscopy study.

The electronic and molecular properties of three organic dye molecules with the general structure donor-linker-anchor have been investigated using core level photoelectron spectroscopy (PES). The molecules contain a diphenylaniline donor unit, a thiophene linker unit, and cyanoacrylic acid or rhodanine-3-acetic acid anchor units. They have been investigated both in the form of a multilayer and adsorbed onto nanoporous TiO(2) and the experimental results were also compared with DFT calculations. The changes at the dye-sensitized TiO(2) surface due to the modification of either the donor unit or the anchor unit was investigated and the results showed important differences in coverage as well as in electronic and molecular surface properties. By measuring the core level binding energies, the sub-molecular properties were characterized and the result showed that the adsorption to the TiO(2) influences the energy levels of the sub-molecular units differently.