Adsorption Efficiency of Cadmium (II) by Different Alkali-Activated Materials.

The objective of this study was to demonstrate the potential utilization of fly ash (FA), wood ash (WA), and metakaolin (MK) in developing new alkali-activated materials (AAMs) for the removal of cadmium ions from waste water. The synthesis of AAMs involved the dissolution of solid precursors, FA, WA, and MK, by a liquid activator (Na2SiO3 and NaOH). In concentrated solutions of the activator, the formation of an aluminosilicate gel structure occurred. DRIFT spectroscopy of the AAMs indicated main vibration bands between 1036 cm-1 and 996 cm-1, corresponding to Si-O-Si/Si-O-Al bands. Shifting vibration bands were seen at 1028 cm-1 to 1021 cm-1, indicating that the Si-O-Si/Si-O-Al bond is elongating, and the bond angle is decreasing. Based on the X-ray diffraction results, alkali-activated samples consist of an amorphous phase and residual mineral phases. The characteristic "hump" of an amorphous phase in the range from 20 to 40° 2θ was observed in FA and in all AWAFA samples. By the XRD patterns of the AAMs obtained by the activation of a solid three-component system, a new crystalline phase, gehlenite, was identified. The efficiency of AAMs in removing cadmium ions from aqueous solutions was tested under various conditions. The highest values of adsorption capacity, 64.76 mg/g (AWAFA6), 67.02 mg/g (AWAFAMK6), and 72.84 mg/g mg/g (AWAMK6), were obtained for materials activated with a 6 M NaOH solution in the alkali activator. The Langmuir adsorption isotherm and pseudo-second kinetic order provided the best fit for all investigated AAMs.

Microstructural Analysis of Thermally Treated Geopolymer Incorporated with Neodymium.

The following investigation presents the thermal treatment of geopolymer at 300 °C, 600 °C and 900 °C. We investigated what happens to the geopolymer base when incorporated with 1% and 5% of neodymium in the form Nd2O3. A total of six samples were synthesized. Geopolymer 1 contained 1% and geopolymer 2 contained 5% Nd2O3, and these samples were treated at 300 °C; then, samples geopolymer 3 and geopolymer 4 also had the same percentage composition of Nd2O3 and were treated at 600 °C, while samples geopolymer 5 and geopolymer 6were treated at 900 °C. Physical and chemical changes in the aluminosilicate geopolymer matrix were monitored. The incorporation of rare earths into the polymer network of aluminosilicates has been proven to disrupt the basic structure of geopolymers; however, with increased temperatures, these materials show even more unusual properties. Diffuse reflectance infrared Fourier transform (DRIFT) analysis showed that the intensity of the vibrational band decreases with the increase in temperature during thermal treatment, suggesting alterations in the chemical structure of the geopolymers. Transmission electron microscopy (TEM) analysis showed that the diameter of the nanoparticles containing Al2O3 is in the range 5-10 nm, while larger crystallites range from 30 to 80 nm. Scanning electron microscopy (SEM) analysis revealed that the temperature of the thermal treatment increases to 300 °C and 600 °C; the porosity of geopolymer increases in the form of the appearance of large pores and cracks in material. X-ray photoelectron spectroscopy (XPS) analysis was used to investigate the surface chemistry of geopolymers, including the chemical composition of the surface, the oxidation state of the elements, and the presence of functional groups. The UV/Vis spectra of the synthesized geopolymers doped with Nd3+ show interesting optical properties at 900 °C; the geopolymer matrix completely disintegrates and an amorphous phase with a rare-earth precipitate appears.

Yellow gentian root extract provokes concentration- and time-dependent response in peripheral blood mononuclear cells.

Yellow gentian (Gentiana lutea L.), a medicinal plant widely used in traditional medicine, displays multiple biological effects, ranging from beneficial to toxic. Since many promising applications have been reported so far, our aim was to evaluate its potential concentration- and time- dependent cytotoxic and genotoxic effects in vitro. To that end we exposed human peripheral blood mononuclear cells to 0.5, 1, and 2 mg/mL of yellow gentian root extract (YGRE) to determine its effects on oxidative stress parameters [pro/antioxidant balance (PAB) and lipid peroxidation], DNA damage (alkaline comet assay and chromosome aberrations), and cell viability (trypan blue exclusion test). Cell viability decreased with increasing concentrations and treatment duration. Only the lowest YGRE concentration (0.5 mg/mL) increased oxidative stress but produced minor DNA damage and cytotoxicity. At higher concentrations, redox parameters returned to near control values. The percentage of chromosome aberrations and percentage of DNA in the comet tail increased with increased YGRE concentration after 48 h and declined after 72 h of treatment. This points to the activation of DNA repair mechanism (homologous recombination), evidenced by the formation of chromosomal radial figures after 72 h of treatment with the highest YGRE concentration of 2 mg/mL. Our results suggest that YGRE, despite induction of cytotoxic and genotoxic effects, activates cell repair mechanisms that counter oxidative and DNA lesions and induce cell death in highly damaged cells. Therefore, observed protective effects of yellow gentian after longer exposure could be a result of activated repair and removal of cells with irreparable damage.

Nano-structural and compositional basis of devitalized tooth fragility.

OBJECTIVE: Increased tooth fragility after devitalization is commonly observed but there is no definite mechanistic explanation for such phenomenon. Therefore, it is important to analyze more profoundly structural and compositional properties of this altered form of dentin. The present study investigates the differences between normal and devitalized dentin using advanced techniques. METHODS: Atomic force microscopic imaging (AFM), energy dispersive X-ray analysis (EDX) and micro-Raman spectroscopy were performed on 16 dentin specimens, eight vital and eight that underwent root-canal treatment at least two years before extraction and had no infection in root canals before or after devitalization. RESULTS: The mean size of mineral crystals showed by AFM was larger in devitalized than in healthy dentin in the same age category. AFM phase shifts in devitalized cases revealed altered mechanical characteristics and suggested differences in composition of material between devitalized teeth and healthy controls. No significant difference in Ca/P ratio between vital and devitalized teeth was found using EDX. However, micro-Raman analyses showed that in devitalized teeth, apart from hydroxyapatite, dentin contained significant amounts of apatite phases with lower calcium content: octacalcium phosphate, dicalcium phosphate dihydrate and tricalcium phosphate. SIGNIFICANCE: Differences between vital and devitalized dentin bring new insights into the basis of devitalized tooth fragility. Larger mineral crystals could account for decreased mechanical strength in devitalized teeth. Moreover, calcium-phosphate phases with lower Ca content have lower material strength, and the presence of these phases in devitalized teeth may explain their increased fragility.

Atomic force microscopy characterization of the external cortical bone surface in young and elderly women: potential nanostructural traces of periosteal bone apposition during aging.

On the basis of the suggestion that bone nanostructure bears "tissue age" information and may reflect surface deposition/modification processes, we performed nanoscale characterization of the external cortical bone surface at the femoral neck in women using atomic force microscopy (AFM). The specific aims were to assess age-related differences in bone nanostructure and explore the existence of nanostructural traces of potential bone apposition at this surface. Our findings revealed that the external cortical surface represents a continuous phase composed of densely packed mineral grains. Although the grains varied in size and shape, there was a domination of small grains indicative of freshly deposited bone (mean grain size: young, 35 nm; old, 37 nm; p > 0.05). Advanced quantitative analysis of surface morphological patterns revealed comparable roughness and complexity of the surface, suggesting a similar rate of mineral particle deposition at the surface in both groups. Calcium/phosphorus ratio, a measure of bone tissue age, was within the same range in both groups. In summary, our AFM analyses showed consistent nanostructural and compositional bone features, suggesting existence of new bone at the periosteal bone surface in both young and elderly women. Considering observed age-related increase in the neck diameter, AFM findings may support the theory of continuous bone apposition at the periosteal surface.

Age-related deterioration in trabecular bone mechanical properties at material level: nanoindentation study of the femoral neck in women by using AFM.

Despite general belief that the mechanical properties of bone material contribute to whole bone strength, it is still obscure what the age effects are on mechanical behavior of the bone material, particularly in the case of the femoral neck trabeculae. In this study, atomic force microscopy was used for imaging and measuring the size of mineral grains, as well as nano-scale mechanical characterization (nanoindentation) of the bone mineralized matrix of trabeculae, with the aim to explore the age effects on bone elasticity and give new insight into age-related bone fragility. The bone samples in this study comprised trabecular bone specimens of the femoral neck region, collected from eight skeletal healthy women (five young adults: 27-38yrs., three elderly: 83-94yrs.) at autopsy. Bone trabeculae in the elderly displayed a higher modulus and nanohardness, signifying a decreased amount of energy that can be accommodated by the bone tissue during loading. Regression analysis revealed that nearly 65% of variability in the bone matrix elastic modulus can be statistically explained by the changes in size of the matrix mineral grains. This study revealed that the bone trabeculae of elderly women express less elastic behavior at the material level, which makes them more vulnerable to unusual impact loads originating from a fall. The observed age-related structural and mechanical alteration at the bone material level adds new evidence for understanding why hip fractures are more frequent in elderly women.

Nanostructure and mineral composition of trabecular bone in the lateral femoral neck: implications for bone fragility in elderly women.

Despite interest in investigating age-related hip fractures, the determinants of decreased bone strength in advanced age are not clear enough. Hitherto it has been obscure how the aging process affects the femoral neck nanostructure and composition, particularly in the lateral subregion of the femoral neck, which is considered as a fracture-initiating site. The femoral bone samples used in this study were obtained at autopsy in 10 women without skeletal disease (five younger: aged 20-40 years, and five elderly: aged 73-94 years). Atomic force microscopy (AFM) was applied to explore the mineral grain size in situ in young vs. old trabecular bone samples from the lateral femoral neck. The chemical compositions of the samples were determined using inductively coupled plasma optical emission spectroscopy and direct current argon arc plasma optical emission spectrometry. Our AFM study revealed differences in trabecular bone nanostructure between young and elderly women. The mineral grain size in the trabeculae of the old women was larger than that in the young (median: 95 vs. 59nm), with a particular bimodal distribution: 45% were small grains (similar to the young) and the rest were larger. Since chemical analyses showed that levels of calcium and phosphorus were unchanged with age, our study suggests that during aging the existing bone mineral is reorganized and forms larger aggregates. Given the mechanical disadvantage of large-grained structures (decreased material strength), the observed nanostructural differences contribute to our understanding of the increased fragility of the lateral femoral neck in aged females. Moreover, increasing data on mineral grains in natural bone is essential for advancing calcium-phosphate ceramics for bone tissue replacement.