Effects of Charge Density on Photophysics and Aggregation Behavior of Anionic Fluorene-Arylene Conjugated Polyelectrolytes.

Three anionic fluorene-based alternating conjugated polyelectrolytes (CPEs) have been synthesized that have 9,9-bis(4-phenoxy-butylsulfonate) fluorene-2,7-diyl and 1,4-phenylene (PBS-PFP), 4,4'-biphenylene (PBS-PFP2), or 4,4″-p-terphenylene (PBS-PFP3) groups, and the effect of the length of the oligophenylene spacer on their aggregation and photophysics has been studied. All form metastable dispersions in water, but can be solubilized using methanol, acetonitrile, or dioxane as cosolvents. This leads to increases in their emission intensities and blue shifts in fluorescence maxima due to break-up of aggregates. In addition, the emission maximum shifts to the blue and the loss of vibronic structure are observed when the number of phenylene rings is increased. Debsity Functional Theory (DFT) calculations suggest that this is due to increasing conformational flexibility as the number of phenylene rings increases. This is supported by increasing amplitude in the fast component in the fluorescence decay. The nonionic surfactant n-dodecylpentaoxyethylene glycol ether (C12E5) also breaks up aggregates, as seen by changes in fluorescence intensity and maximum. However, the loss in vibrational structure is less pronounced in this case, possibly due to a more rigid environment in the mixed surfactant-CPE aggregates. Further information on the aggregates formed with C12E5 was obtained by electrical conductivity measurements, which showed an initial increase in specific conductivity upon addition of surfactants, while at higher surfactant/CPE molar ratios a plateau was observed. The specific conductance in the plateau region decreased in the order PBS-PFP3 < PBS-PFP2 < PBS-PFP, in agreement with the change in charge density on the CPE. The reverse process of aggregate formation has been studied by injecting small volumes of solutions of CPEs dissolved at the molecular level in a good solvent system (50% methanol-water) into the poor solvent, water. Aggregation was monitored by changes in both fluorescence and light scattering. The rate of aggregation increases with hydrophobicity and concentration of sodium chloride but is only weakly dependent on temperature.

Solubilization of poly{1,4-phenylene-[9,9-bis(4-phenoxy-butylsulfonate)]fluorene-2,7-diyl} in water by nonionic amphiphiles.

In the presence of the nonionic alkyloxyethylene surfactant n-dodecylpentaoxyethylene glycol ether (C12E5), the anionic conjugated polyelectrolyte (CPE) poly{1,4-phenylene-[9,9-bis(4-phenoxy-butylsulfonate)]fluorene-2,7-diyl} (PBS-PFP) dissolves in water, leading to a blue shift in fluorescence and dramatic increases in fluorescence quantum yields above the surfactant critical micelle concentration (cmc). No significant changes were seen with a poly(ethylene oxide) of similar size to the surfactant headgroup, confirming that specific surfactant-polyelectrolyte interactions are important. From UV-visible and fluorescence spectroscopy, dynamic light scattering (DLS), small-angle X-ray scattering (SAXS), cryogenic transmission electron microscopy (cryo-TEM), and electrical conductivity, together with our published NMR and small-angle neutron scattering (SANS) results, we provide a coherent model for this behavior in terms of breakup of PBS-PFP clusters through polymer-surfactant association leading to cylindrical aggregates containing isolated polymer chains. This is supported by molecular dynamics simulations, which indicate stable polymer-surfactant structures and also provide indications of the tendency of C12E5 to break up polymer clusters to form these mixed polymer-surfactant aggregates. Radial electron density profiles of the cylindrical cross section obtained from SAXS results reveal the internal structure of such inhomogeneous species. DLS and cryo-TEM results show that at higher surfactant concentrations the micelles start to grow, possibly partially due to formation of long, threadlike species. Other alkyloxyethylene surfactants, together with poly(propylene glycol) and hydrophobically modified poly(ethylene glycol), also solubilize this polymer in water, and it is suggested that this results from a balance between electrostatic (or ion-dipole), hydrophilic, and hydrophobic interactions. There is a small, but significant, dependence of the emission maximum on the local environment.

Aqueous solution behavior of anionic fluorene-co-thiophene-based conjugated polyelectrolytes.

Two anionic fluorene-thiophene alternating copolymers, poly[9,9-bis(4-sulfonylbutoxyphenyl)fluorene-2,7-diyl-2,5-thienylene] (PBS-PFT) and poly[9,9-bis(4-sulfonylbutoxyphenyl)fluorene-2,7-diyl-2,2'-bithiophene-5,5'-diyl] (PBS-PF2T), have been synthesized and their solution behaviors in water studied by UV-vis absorption spectroscopy, fluorescence, and electrical conductivity and compared with that of the previously studied conjugated polyelectrolyte (CPE) poly[9,9-bis(4-sulfonylbutoxyphenyl)fluorene-2,7-diyl-1,4-phenylene] (PBS-PFP). These conjugated polymers do not form solutions at the molecular level in water but instead form clusters. Information on the structure of these clusters for PBS-PF2T comes from small-angle X-ray and neutron scattering. The relative ease of dispersing the copolymers in water increases with an increase in the number of thiophene rings in these alternating copolymers. Semiempirical calculations on the structure suggest that this results from bending of the chains and increased conformational flexibility, decreasing interchain interactions. These CPEs can be dissolved in water at the molecular level using the nonionic surfactants n-dodecylpentaoxyethylene glycol ether (C12E5) or Triton X-100 to obtain systems with increased photoluminescence quantum yield and increased electrical conductivity that can be solution-processed for potential applications as components of sensory or optoelectronic devices.

Aggregation of the hairy rod conjugated polyelectrolyte poly{1,4-phenylene-[9,9-bis(4-phenoxybutylsulfonate)]fluorene-2,7-diyl} in aqueous solution: an experimental and molecular modelling study.

The aggregation of the fluorescent hairy rod, anionic conjugated polyelectrolyte poly{1,4-phenylene-[9,9-bis(4-phenoxybutylsulfonate)]fluorene-2,7-diyl} (PBS-PFP) has been studied in aqueous solutions by molecular dynamics simulations, fluorescence and light scattering. Formation of clusters leads to considerable increases in light scattering, decreases in the fluorescence quantum yields and red shifts in emission maxima. Molecular dynamics simulations considering two isolated tetramers in aqueous solution show that they rapidly form aggregates, and support experimental evidence for the association of polymer chains involving both electrostatic and hydrophobic interactions. They also provide indications for proximity of aromatic rings, which is likely to be the main factor responsible for the observed fluorescence behaviour. However, there are no indications of extensive pi-stacking. The organic co-solvents methanol, acetonitrile and dioxane break up these aggregates. From studies of the dependence of the aggregation behaviour on dielectric constant or the empirical solvent parameters E(N)(T) and B(KT) for binary mixtures with water, it can be seen that this is not simply an effect of changing solvent polarity, but is due to preferential solvation of the polymer chains. This is supported by molecular dynamic simulations on two tetramers in water-dioxane mixtures (70:30%). It is suggested that similar factors are involved in both the association behaviour and aggregate disruption with other hairy rod conjugated polyelectrolytes in water.

Interplay of electrostatic and hydrophobic effects with binding of cationic gemini surfactants and a conjugated polyanion: experimental and molecular modeling studies.

Understanding factors responsible for the fluorescence behavior of conjugated polyelectrolytes and modulation of their behavior are important for their application as functional materials. The interaction between the anionic poly{1,4-phenylene-[9,9-bis(4-phenoxy-butylsulfonate)]fluorene-2,7-diyl}copolymer (PBS-PFP) and cationic gemini surfactants alpha,omega-(CmH2m+1N+(CH3)2)2(CH2)s(Br-)2 (m-s-m; m=12, s=2, 3, 5, 6, 10, and 12) has been studied experimentally in aqueous solution. These surfactants are chosen to see whether molecular recognition and self-assembly occurs between the oppositely charged conjugated polyelectrolyte and gemini surfactant when the spacer length on the surfactant is similar to the intercharge separation on the polymer. Without surfactants, PBS-PFP exists as aggregates. These are broken up upon addition of gemini surfactants. However, as anticipated, the behavior strongly depends upon spacer length (s). Fluorescence measurements show three surfactant concentration regimes: At low concentrations (<2x10(-6) M) quenching occurs and is most marked with the small spacer 12-2-12; at intermediate concentrations (approximately 2x10(-6)-10(-3) M), fluorescence intensity is constant, with a 12-carbon spacer 12-12-12 showing the strongest fluorescence; above the critical micelle concentration (CMC; approximately 10(-3) M) increases in emission intensity are seen in all cases and are largest with the intermediate spacers 12-5-12 and 12-6-12, where the spacer length most closely matches the distance between monomer units on the polymer. With longer spacer length surfactants, surface tension measurements for concentrations below the CMC reveal the presence of polymer-surfactant aggregates at the air-water interface, possibly reflecting increased hydrophobicity. Above the CMC, small-angle neutron scattering experiments for the 12-6-12 system show the presence of spherical aggregates, both for the pure surfactant and for polyelectrolyte/gemini mixtures. Molecular dynamics simulations help rationalize these observations and show that there is a very fine balance between electrostatic and hydrophobic interactions. With the shortest spacer 12-2-12, Coulombic interactions are dominant, while for the longest spacer 12-12-12 the driving force involves hydrophobic interactions. Qualitatively, with the intermediate 12-5-12 and 12-6-12 systems, the optimum balance is observed between Coulombic and hydrophobic interactions, explaining their strong fluorescence enhancement.

Interaction between the conjugated polyelectrolyte poly{1,4-phenylene[9,9-bis(4-phenoxybutylsulfonate)]fluorene-2,7-diyl} copolymer and the lecithin mimic 1-O-(l-Arginyl)-2,3-O-dilauroyl-sn-glycerol in aqueous solution.

In this paper, the interaction between the water-soluble conjugated polyelectrolyte poly{1,4-phenylene[9,9-bis(4-phenoxybutylsulfonate)]fluorene-2,7-diyl} copolymer and the amino acid glyceride conjugate 1-O-(L-arginyl)-2,3-O-dilauroyl-sn-glycerol dichlorohydrate (a mimic for the phospholipid lecithin) has been studied in aqueous solution by electronic spectroscopy (absorption and fluorescence) and small-angle neutron scattering (SANS). A significant increase in the polymer fluorescence and blue shift in its emission are observed on association with the surfactant. This is suggested to be due to breakup of polymer aggregates. In addition, the spectroscopic and photophysical data suggest this is followed by the vesicle to ribbon transition characteristic of this surfactant, leading to incorporation of single chains of the polymer within mixed polymer-surfactant aggregates. Support for this comes from preliminary SANS measurements, from which evidence for polymer dissolution and formation of two-dimensional structures has been obtained.

Solubilization of polyelectrolytic hairy-rod polyfluorene in aqueous solutions of nonionic surfactant.

We report on the solubilization, phase behavior, and self-organized colloidal structure of a ternary water-polyfluorene-surfactant (amphiphile) system comprised of polyelectrolytic poly{1,4-phenylene[9,9-bis(4-phenoxybutylsulfonate)]fluorene-2,7-diyl} (PBS-PFP) in nonionic pentaethylene glycol monododecyl ether (C12E5) at 20 degrees C. We show in particular how a high amount (milligrams per milliliter) of polyfluorene can be solubilized by aqueous C12E5 via aggregate formation. The PBS-PFP and C12E5 concentrations of 0.31 x 10(-4)-5 x 10(-4) M and 2.5 x 10(-4)-75 x 10(-4) M, respectively, were used. Under the studied conditions, the photoluminescence (PL), surface tension, static contact angle, and (pi-A) isotherm measurements imply that D2O-PBS-PFP(C12E5)x realizes three phase regimes with an increasing molar ratio of surfactant over monomer unit (x). First, for x < or = 0.5, the mixture is cloudy. In this regime polymer is only partially dissolved. Second, for 1 < or = x < or = 2, the solution is homogeneous. In this regime polymer is dissolved down to the colloidal level. Small-angle neutron scattering (SANS) patterns indicate rigid elongated (polymer-surfactant) aggregates with a diameter of 30 A and mean length of approximately 900 A. The ratio between contour length and persistence length is less than 3. Third, for x > or = 4, the solution is homogeneous and there is cooperative binding between polymer and surfactant. Surface tension, contact angle, and surface pressure remain essentially constant with increasing x. A PL spectrum characteristic of single separated polyfluorene molecules is observed. SANS curves show an interference maximum at q approximately 0.015 A(-1), indicating an ordered phase. This ordering is suggested to be due to the electrostatic repulsion between polymer molecules adsorbed on or incorporated into the C12E5 aggregates (micelles). On dilution the distance between micelles increases via 3-dimensional packing. In this regime the polymer is potentially dissolved down to the molecular level. We show further that the aggregates (x = 2) form a floating layer at the air-water interface and can be transferred onto hydrophilic substrates.

Removal of nickel from aqueous solutions using crab shells.

Partially converted crab shell waste, which contains chitosan, was used to remove nickel from water. The chelating ability of chitosan makes it an excellent adsorbent for removing pollutants. Advantages of chitosan in crab shells include availability, low cost, and high biocompatibility. The metal uptake by partially converted crab shell waste was successful and rapid. The sorption occurred primarily within 5 min. The sorption mechanism appears to be quite complicated and cannot be adequately described by either the Langmuir or Freundlich theories. Various anions, including chloride, bromide, fluoride, acetate, sulfate, nitrate, and phosphate, were found to have a very small effect on the capacity of the crab shells for uptake of nickel. The effect of pH was also found not to be prominent.