Prevalence and associated risk factors for mental health problems among young adults in Fiji Island during COVID-19: a cross-sectional study.

Introduction: The COVID-19 pandemic has had a significant impact on mental health globally. To understand the impact of the pandemic on mental health in Fiji, this study aimed to investigate the prevalence of anxiety disorder and depression among the young adults. Method: An online survey was conducted to assess the prevalence of anxiety disorder and depression among the general population in Suva, Fiji during the COVID-19 pandemic. A total of 1,119 Fiji adults participated in the study. The study was conducted between May 20 to June 30, 2022, using a snowball sampling via social media platforms. The Generalized Anxiety Disorder (GAD-7) and Patient Health Questionnaire (PHQ-9) scales were used to measure anxiety and depression, respectively. The COVID-19 related stressors was evaluated using the adapted SARS stressors assessment. Univariate and multivariate logistic regression analysis was performed to determine the factors influencing mental health among respondents. Results: The result shows that a significant portion of individuals experienced each of the stressors, with the highest prevalence seen for hearing information about the severity of COVID-19. The prevalence of anxiety and depression was found to be 45% and 49%, respectively. Being female, having pre-existing illness and COVID-19 stressors were a risk factor to develop anxiety and depression. On the other hand, employed individuals and having high BMI was a protective factor against developing depression during COVID-19 lockdown. Conclusion: These findings highlight the importance of addressing the mental health needs of the Fijian population during the COVID-19 pandemic and beyond.

Practice, benefits, and impact of personal protective equipment (PPE) during COVID-19 pandemic: Envisioning the UN sustainable development goals (SDGs) through the lens of clean water sanitation, life below water, and life on land in Fiji.

BACKGROUND: The outbreak of coronavirus disease (COVID-19) highlights the global health emergency. To limit the rate of COVID-19 transmission to health care workers, adequate personal protective equipment (PPE) are required. Emerging reports indicate that the widespread usage of PPE during the COVID-19 outbreak has exacerbated plastic contamination in the ocean. PURPOSE: This paper attempts to understand the influence of practice, benefits, and impact of PPE during the COVID-19 crisis on clean water sanitation, life below water, and life on land (SDGs 6, 14, and 15 respectively) in Fiji and assess the effectiveness of measurements taken to deal with this crisis. Fiji is a small Pacific Island Country (PIC) and the global crisis of COVID-19 entered the Fijian border on 19th, March 2020. The second wave of COVID-19 was reported on 18th, April 2021, which began at a managed quarantine facility after contact between a couple returning from India to Fiji and a soldier. Since then the number of cases has been increasing daily and posing a risk to the public. MATERIALS AND METHOD: A personal observation was made to collect the PPE pollution on the streets, near roads, car parks, markets, and towns. RESULTS: Widespread PPE pollution was noticed, and the common PPE found on the Vesivesi road in Suva, Fiji were facemasks (61.36%) and hand gloves (38.64%), as it is mostly used by the public, police officers, municipal waste management, shopping malls workers, and medical care workers. Face shield littering was limited due to fewer users. CONCLUSIONS: In response to the COVID-19 pandemic, this study stresses a great concern on enabling SDGs 6, 14, and 15 and how the use of PPE during this period has impacted the natural environment. It is critical to remember that managing PPE waste during a contagious pandemic should be treated as an emergency and handled quickly.

A Prototype of an Electromagnetic Induction Sensor for Non-Destructive Estimation of the Presence of Corrosive Chemicals Ensuing Concrete Corrosion.

The corrosion of steel reinforcement in concrete often leads to huge unbudgeted expenses for maintaining, monitoring and renovating an infrastructure. This is mainly due to the presence of salts or chemical chlorides that pose a danger to the concrete structures. The determination of the existence of these corrosive salts is vital for defining the service life of concrete. This research looked at developing an electromagnetic induction (EMI) sensor for the detection of corrosive salts. The first design adopted a single-loop coil (SLC) concept, and the second was based on a multiple-loop coil (MLC) one using copper wire. Tests were conducted on these two techniques, and with the results obtained, the latter seemed more promising; thus, a prototype sensor was developed using the MLC concept. As this new prototype sensor was able to detect the manifestation of chemical contents in a concrete structure, it could be used as a non-destructive evaluation (NDE) technique for the detection of corrosive chemicals in concrete and has the further possibility of detecting corrosion in concrete.