Role of Alkali Metal in BiVO4 Crystal Structure for Enhancing Charge Separation and Diffusion Length for Photoelectrochemical Water Splitting.

Alkali metal (Na or K) doping in BiVO4 was examined systematically for enhancing bulk charge separation and transport in addition to improving charge transfer from the surface. The alkali metal-doped BiVO4 thin film photoanodes having nanostructured porous grain surface morphology exhibited better photocurrent density than pristine BiVO4. In particular, Na:BiVO4/Fe:Ni/Co-Pi photoanode showed a significantly improved photocurrent of 3.2 ± 0.15 mA·cm-2 in 0.1 M K2HPO4 electrolyte at 1.23 VRHE under 1 sun illumination. The depth-dependent Doppler broadening spectroscopy measurements confirmed the significant reduction in Bi- and V-based defect density with Na metal doping, and this led to a higher bulk diffusion length of charge pairs (four times that of the pristine one). Na doping led to reduced surface defects resulting in improved surface charge transfer based on cyclic voltammetry experiments. The density functional theory calculations confirmed the improved performance in Na-doped BiVO4 photoanodes achieved through interband formation and reduction in the band gap.

PMMA-TiO2 Fibers for the Photocatalytic Degradation of Water Pollutants.

Titanium dioxide (TiO2) is a promising photocatalyst that possesses a redox potential suitable for environmental remediation applications. A low photocatalytic yield and high cost have thus far limited the commercial adoption of TiO2-based fixed-bed reactors. One solution is to engineer the physical geometry or chemical composition of the substrate to overcome these limitations. In this work, porous polymethyl methacrylate (PMMA) substrates with immobilized TiO2 nanoparticles in fiber forms were fabricated and analyzed to demonstrate the influence of contaminant transport and light accessibility on the overall photocatalytic performance. The influences of (i) fiber porosity and (ii) fiber architecture on the overall photocatalytic performance were investigated. The porous structure was fabricated using wet phase inversion. The core-shell-structured fibers exhibited much higher mechanical properties than the porous fibers (7.52 GPa vs. non-testability) and maintained the same degradation rates as porous structures (0.059 vs. 0.053/min) in removing methylene blue with comparable specific surface areas. The highest methylene blue (MB) degradation rate (kMB) of 0.116 min-1 was observed due to increases of the exposed surface area, pointing to more efficient photocatalysis by optimizing core-shell dimensions. This research provides an easy-to-manufacture and cost-efficient method for producing PMMA/TiO2 core-shell fibers with a broad application in water treatment, air purification, and volatile sensors.

Photoelectrochemical Solar Water Splitting: The Role of the Carbon Nanomaterials in Bismuth Vanadate Composite Photoanodes toward Efficient Charge Separation and Transport.

Photoelectrochemical performance of bismuth vanadate (BiVO4) photoanode is limited by poor charge separation and transport properties. The roles of carbon nanotube, reduced graphene oxide, or graphitic carbon nitride in BiVO4 composite photoanode were investigated toward enhancing light absorption and reducing overall impedance during photoelectrochemical water oxidation process. X-ray diffraction and Tauc analysis showed that BiVO4 retains its monoclinic phase, n-type semiconductor nature, and band gap in all carbon nanomaterials-incorporated composite photoanodes. It was observed that the carbon nanomaterials incorporation in BiVO4 film increases its surface porosity, ultimately leading to enhanced light absorption. The BiVO4 photoanode with reduced graphene oxide and graphitic carbon nitride showed same bulk charge separation efficiency, whereas the latter showed better charge transfer. It was found that the graphitic carbon nitride formed composite with BiVO4 to provide enhanced light absorption efficiency, i.e., 89% in 350-505 nm range. The BiVO4 with graphitic carbon nitride photoanode showed the best performance with a photocurrent of 2.2 mA cm-2, charge separation efficiency of 67%, and photocurrent of 4.0 mA cm-2 with cobalt-phosphate surface catalyst at 1.23 VRHE for water oxidation under 1 sun illumination. The Mott-Schottky and impedance measurements confirmed the shift of conduction band position toward hydrogen reduction potential and reduction in film resistance, respectively, with carbon nanomaterials addition, and the shift was most significant for graphitic carbon nitride. It is concluded that by concomitant formation of junction during photoanode fabrication between carbon nanomaterials, BiVO4, and fluorine-doped tin oxide glass substrate, better charge separation, transport, and light absorption can be achieved.

Enhanced Photoelectrochemical Water Splitting with Er- and W-Codoped Bismuth Vanadate with WO3 Heterojunction-Based Two-Dimensional Photoelectrode.

A novel two-dimensional (2D) heterojunction photoelectrode composed of WO3 and (Er,W):BiVO4 is proposed for water oxidation with efficient photoinduced charge carrier separation and transfer. Er stoichiometric along with W nonstoichiometric codoping was introduced to simultaneously manage vacancy creation during substitutional doping, enhance light absorption, and reduce overall impedance. It was found that Er3+ is substituted at the Bi3+ sites in the BiVO4 lattice to provide expanded light absorption from 400 to 680 nm. The fabricated WO3/(Er,W):BiVO4 electrode shows photocurrent densities of 4.1 and 7.2 mA cm-2 at 1.23 and 2.3 V (vs reversible hydrogen electrode, RHE), respectively, under a 1 sun illumination in K2HPO4 electrolyte. This electrode has shown remarkably high charge separation efficiency of 93% at 1.23 V (vs RHE). With the addition of a standard surface catalyst (i.e., Co-Pi), the WO3/(Er,W):BiVO4/Co-Pi electrode exhibits the highest photocurrent of 5.6 ± 0.3 mA cm-2 at 1.23 V (vs RHE), nearing the theoretical limit (i.e., 7.5 mA cm-2) while retaining 98% of the photoelectrochemical cell performance after 3 h. By concomitantly doping the Bi3+ and V5+ sites to enhance absorption, this study demonstrates for the first time a planar WO3/BiVO4 heterojunction that reaches 88% of the record-high performance of its nanostructured counterpart. Through a detailed characterization of the electrodes, it is concluded that the stoichiometric Er and nonstoichiometric W codoping extend light absorption region and improve charge separation efficiency by reducing bulk resistance. The photoactive materials with 2D morphology were synthesized using a facile ultrasonic spray-coating technique without any complex process steps and thus it can be scaled for commercial development.

Evaluation of myofibroblasts in oral submucous fibrosis and oral squamous cell carcinoma: The pathogenesis and correlation.

BACKGROUND: Oral submucous fibrosis (OSMF) is a chronic debilitating disease of the oral cavity having premalignant potential and unclear pathogenesis. Recently, myofibroblast has been postulated to play an important role in its pathogenesis and in the process of carcinogenesis. The purpose of this study was to evaluate and compare the presence of myofibroblasts in normal mucosa, different grades of OSMF, and oral squamous cell carcinoma (OSCC). MATERIALS AND METHODS: The present in vitro cross-sectional descriptive study sample consisted of three groups, including 40 OSCCs, 40 OSMF, and 10 sections of normal oral epithelium taken as control group. Alpha-smooth muscle actin was used to identify myofibroblasts using immunohistochemical technique. P < 0.05 was taken as statistically significant. RESULTS: The presence of myofibroblasts was significantly higher in OSMF cases when compared with normal epithelium specimens. The presence of myofibroblasts was significantly higher in OSCC compared to OSMF cases. A significant difference was not observed between the different grades of OSCC. CONCLUSION: These findings favor the possibility that OSMF actually represents an abnormal healing process in response irritation caused by areca nut. A significant increase in myofibroblasts in OSCC as compared to OSMF also highlights the possible role it may play in the malignant transformation of OSMF.

A Decision Tree Analysis of Diabetic Foot Amputation Risk in Indian Patients.

AIM: The aim of this study is to create an evidence-based tool that guides the risk of amputation in diabetic foot patients. MATERIALS AND METHODS: Hospital records of 301 diabetic foot patients were examined retrospectively for explanatory variables of foot amputation decisions. The study included all patients with a lower limb ulcer with a known history of diabetes mellitus or those diagnosed post-admission. The dataset was analyzed, and a risk scoring system was constructed using the decision tree algorithm, C5.0. Two classifiers, one simple and another complex, were constructed for predicting amputation outcome. RESULTS AND DISCUSSION: Based on our evaluation, the most influential predictors for a decision to amputate are Doppler flow measurements and the Wagner grading of the ulceration. The simple classifier uses just these two parameters in determining risk. The results obtained show an accuracy of 96.4% in the primary group and an accuracy of 94% in the test group. The second classifier is a more complex computer-derived construct that showed 100% accuracy in the principle group and an accuracy of 96% during testing. CONCLUSION: In the present era of precision medicine, these two classifiers act as an accurate guide to the prognosis of the limb in patients with diabetic foot and can predict the risk of future amputation.

Can Feulgen Stain be a Reliable Biomarker over PAP Stain for Estimation of Micronuclei Score?

INTRODUCTION: Malignant transformation of the Potentially Malignant Lesions (PML) in the oral cavity is associated with elevated mortality rate because of its aggressive and exceedingly invasive nature. Meticulous diagnosis and prompt therapy of PML may help prevent malignant conversion in oral lesions. Carcinogenic insult to oral cells results in chromosomal damage and formation of Micronuclei (Mn), before the development of clinical symptoms. AIM: To determine the genotoxic effect of smoking and chewing tobacco on target tissue using Mn assay and to evaluate the prevalence of other nuclear anomalies associated with it and to determine the reliability of feulgen stain for Mn assay over Papaincolau (PAP) stain. MATERIALS AND METHODS: PAP and feulgen staining was done to study Mn in individuals who were having tobacco habits (smoking and chewing) without lesion (n=30), individuals who were having tobacco habit (smoking and chewing) with PML (n=30) and apparently healthy subjects (n=30). Data was analysed for statistical significance using SPSS 17.0 by Kruskal - Wallis Test and Bonferronii test. RESULTS: Tobacco habits in the form of smoking and chewing have mutagenic effects on human chromosomes which is indicated by increased frequency of Mn in oral exfoliative cells. The mean Mn frequency using feulgen stain was found to be 12.27 with lesion, 10.23 with without lesion and 3.87 in controls. Whereas, metanucleated analysis revealed no significant correlation with the formation of Mn. Non-specific DNA stain (PAP) showed high numbers of Mn cells in all the groups compared to feulgen. Statistically significant difference (p<0.0001) was observed when both the stains were compared for Mn numbers. CONCLUSION: These findings indicate that the individuals having tobacco habits (smoking and chewing) with lesion have high number of Mn cells, thus supporting the assay to be used as a reliable biomarker to assess the genotoxic effect of tobacco in the oral mucosa. The reason for almost twice as high Mn in PAP stained smears is suggestive of cell injury which is collimated by formation of keratin bodies, resulting in its misinterpretation as Mn, leading to false positive results. Hence, it was concluded that PAP stain can be used to identify abnormal cytological changes resulting from mutagenic agent but not to interpret Mn.

Recurrent pyogenic granuloma with a satellite lesion.

Pyogenic granuloma (PG) is a tumorlike growth of the oral mucosa or skin that is considered to be an exaggerated conditioned response to minor trauma. It usually is painless, bleeds easily, and is considered to be nonneoplastic in nature. Pyogenic granuloma predominantly occurs in the second decade of life, mostly among young adult females. Clinically, it is a smooth or lobulated exophytic lesion manifesting as small, red, erythematous papules on a pedunculated or sometimes sessile base that usually is hemorrhagic. We report the case of 30-year-old woman who presented with a PG in the anterior palatal region during pregnancy that recurred with a satellite lesion 1 year following surgical excision.

Gingival enlargement and mesiodens associated with generalized aggressive periodontitis: a case report.

UNLABELLED: This case report describes the management of an 18-year-old female who presented with generalized aggressive periodontitis, gingival enlargement and a mesiodens. Diagnosis for aggressive periodontitis was determined based on history, clinical findings and radiographic examination. Treatment included oral prophylaxis, extraction of the mesiodens and elimination of infectious microorganisms, using a combination of surgical intervention and antimicrobial therapy with long-term maintenance. CLINICAL RELEVANCE: Presence of gingival enlargement in cases of aggressive periodontitis may be clinically confusing; hence, the diagnosis should always be based on the patient's history as well as the clinical and radiographic findings.

A dynamic human health risk assessment system.

An online human health risk assessment system (OHHRAS) has been designed and developed in the form of a prototype database-driven system and made available for the population of India through a website - www.healthriskindia.in. OHHRAS provide the three utilities, that is, health survey, health status, and bio-calculators. The first utility health survey is functional on the basis of database being developed dynamically and gives the desired output to the user on the basis of input criteria entered into the system; the second utility health status is providing the output on the basis of dynamic questionnaire and ticked (selected) answers and generates the health status reports based on multiple matches set as per advise of medical experts and the third utility bio-calculators are very useful for the scientists/researchers as online statistical analysis tool that gives more accuracy and save the time of user. The whole system and database-driven website has been designed and developed by using the software (mainly are PHP, My-SQL, Deamweaver, C++ etc.) and made available publically through a database-driven website (www.healthriskindia.in), which are very useful for researchers, academia, students, and general masses of all sectors.

Peripheral odontogenic fibroma associated with a dilacerated maxillary central incisor: a case report.

The authors report a case of a 16-year-old male with peripheral odontogenic fibroma (POF) in the anterior maxilla associated with dilaceration of a tooth in its vicinity. A solitary, exophytic and sessile growth was present between the maxillary right central and lateral incisors and extended from the labial mucosa to the palatal gingiva. A periapical radiograph of the maxillary right central incisor revealed a shortened and dilacerated root. The growth was excised and sent for histopathologic examination. A diagnosis of POF (World Health Organization type) was rendered. The clinical and microscopic features are discussed.