Incorporating the benefits of vegetative filter strips into risk assessment and risk management of pesticides.

The pesticide registration process in North America, including the USA and Canada, involves conducting a risk assessment based on relatively conservative modeling to predict pesticide concentrations in receiving waterbodies. The modeling framework does not consider some commonly adopted best management practices that can reduce the amount of pesticide that may reach a waterbody, such as vegetative filter strips (VFS). Currently, VFS are being used by growers as an effective way to reduce off-site movement of pesticides, and they are being required or recommended on pesticide labels as a mitigation measure. Given the regulatory need, a pair of multistakeholder workshops were held in Raleigh, North Carolina, to discuss how to incorporate VFS into pesticide risk assessment and risk management procedures within the North American regulatory framework. Because the risk assessment process depends heavily on modeling, one key question was how to quantitatively incorporate VFS into the existing modeling approach. Key outcomes from the workshops include the following: VFS have proven effective in reducing pesticide runoff to surface waterbodies when properly located, designed, implemented, and maintained; Vegetative Filter Strip Modeling System (VFSMOD), a science-based and widely validated mechanistic model, is suitable for further vetting as a quantitative simulation approach to pesticide mitigation with VFS in current regulatory settings; and VFSMOD parametrization rules need to be developed for the North American aquatic exposure assessment. Integr Environ Assess Manag 2024;20:454-464. © 2023 The Authors. Integrated Environmental Assessment and Management published by Wiley Periodicals LLC on behalf of Society of Environmental Toxicology & Chemistry (SETAC).

Fixed bed column experiments using cotton gin waste and walnut shells-derived biochar as low-cost solutions to removing pharmaceuticals from aqueous solutions.

Acetaminophen (ACT), sulfapyridine (SPY), ibuprofen (IBP) and docusate (DCT) are pharmaceuticals with widespread usage that experience incomplete removal in wastewater treatment systems. While further removal of these pharmaceuticals from wastewater effluent is desired prior to beneficial reuse, additional treatment technologies are often expensive and energy intensive. This study evaluated the ability of biochar produced from cotton gin waste (CG700) and walnut shells (WS800) to remove four pharmaceuticals (ACT, SPY, IBP, and DCT) from aqueous solution. Physico-chemical properties of the biochars were characterized by Brunauer-Emmett-Teller (BET) analysis, scanning electron microscopy (SEM), Fourier Transform Infrared Spectroscopy (FT-IR), and zeta potential. The increased pyrolysis temperature during the production of WS800 led to an increase in the specific surface area and increased dehydration of the biochar represented by the loss of the OH-group. Fixed-bed column experiments were performed to determine the difference in removal efficiency between the biochars and elucidate the effects of biochar properties on the adsorption capacity for the pharmaceuticals of interest. Results showed that CG700 had a greater affinity for removing DCT (99%) and IBP (50%), while WS800 removed 72% of SPY and 68% of ACT after 24 h. Adsorption was influenced by the solution pH, surface area, net charge, and functional groups of the biochars. The mechanisms for removal included pore filling and diffusion, hydrophobic interactions, hydrogen bonding, and π-π electron donor acceptor interactions. To conduct predictive modeling of the column breakthrough curves, the Thomas, Adams-Bohart, and Yoon-Nelson models were applied to the experimental data. Results demonstrated that these models generally provided a poor fit for the description of asymmetrical breakthrough curves. Overall, the results demonstrate that biochars from cotton gin waste and walnut shells could be used as cost-effective, environmentally friendly alternatives to activated carbon for the removal of pharmaceuticals from aqueous solutions.

Spatiotemporal patterns of PFAS in water and crop tissue at a beneficial wastewater reuse site in central Pennsylvania.

Per- and polyfluoroalkyl substances (PFAS) are a collective name for thousands of synthetic compounds produced to enhance consumer and industrial products since the 1940s. They do not easily degrade, and some are known to pose serious ecological and human health concerns at trace concentrations (ng L-1 levels). Per- and polyfluoroalkyl substances persist in treated wastewater and are inadvertently introduced into the environment when treated wastewater is reused as an irrigation source. The Pennsylvania State University (PSU) has been spray-irrigating its wastewater at a 2.45 km2 mixed-use agricultural and forested site known as the "Living Filter" since the 1960s. To understand the spatiotemporal patterns of 20 PFAS at the Living Filter, water samples were collected bimonthly from fall 2019 through winter 2021 from the PSU's wastewater effluent and from each of the site's 13 monitoring wells. Crop tissue was collected at the time of harvest to assess PFAS presence in corn silage and tall fescue grown at the study site. Total measured PFAS concentrations in the monitoring wells ranged from nondectable to 155 ng L-1 , with concentrations increasing with the direction of groundwater flow. Concentrations within each well exhibited little temporal variability across sampling events, with mixed relationships between PFAS and groundwater elevation observed between wells. Further, >84% of the PFAS present in livestock feed crops were short-chain compounds, with PFAS consumed annually by livestock fed crops harvested from the site estimated to be 2.46-7.67 mg animal-1 yr-1 . This research provides insight into the potential impacts of long-term beneficial reuse of treated wastewater on groundwater and crop tissue quality.

Impacts of the COVID-19 pandemic on pharmaceuticals in wastewater treated for beneficial reuse: Two case studies in central Pennsylvania.

During the COVID-19 pandemic, wastewater surveillance was leveraged as a powerful tool for monitoring community-scale health. Further, the well-known persistence of some pharmaceuticals through wastewater treatment plants spurred concerns that increased usage of pharmaceuticals during the pandemic would increase the concentrations in wastewater treatment plant effluent. We collected weekly influent and effluent samples from May 2020 through May 2021 from two wastewater treatment plants in central Pennsylvania, the Penn State Water Reclamation Facility and the University Area Joint Authority, that provide effluent for beneficial reuse, including for irrigation. Samples were analyzed for severe acute respiratory syndrome coronavirus 2 (influent only), two over-the-counter medicines (acetaminophen and naproxen), five antibiotics (ampicillin, doxycycline, ofloxacin, sulfamethoxazole, and trimethoprim), two therapeutic agents (remdesivir and dexamethasone), and hydroxychloroquine. Although there were no correlations between pharmaceutical and virus concentration, remdesivir detection occurred when the number of hospitalized patients with COVID-19 increased, and dexamethasone detection co-occurred with the presence of patients with COVID-19 on ventilators. Additionally, Penn State decision-making regarding instruction modes explained the temporal variation of influent pharmaceutical concentrations, with detection occurring primarily when students were on campus. Risk quotients calculated for pharmaceuticals with known effective and lethal concentrations at which 50% of a population is affected for fish, daphnia, and algae were generally low in the effluent; however, some acute risks from sulfamethoxazole were high when students returned to campus. Remdesivir and dexamethasone persisted through the wastewater treatment plants, thereby introducing novel pharmaceuticals directly to soils and surface water. These results highlight connections between human health and water quality and further demonstrate the broad utility of wastewater surveillance.

Comparison of POCIS and grab sampling techniques for monitoring PPCPs in vernal pools in central Pennsylvania.

Active ingredients in pharmaceuticals and personal care products (PPCPs) can persist through wastewater treatment plants and be released into the environment where they can inadvertently pose risks to non-target organisms. Emerging contaminants (ECs), including PPCPs, are commonly detected in wastewater effluent. With the increasing beneficial re-use of treated wastewater globally, there is a need to understand how spray-irrigation activities affect the occurrence and persistence of ECs in the environment to which they are introduced. Here, we explore the impacts of wastewater spray-irrigation on nearby ephemeral wetlands (e.g., vernal pools) through the use of grab and Polar Organic Chemical Integrative Sampling (POCIS) techniques. This study sought to determine whether integrative sampling techniques are better suited than traditional grab sampling techniques in assessing the presence and concentrations of ECs in vernal pools by evaluating 34 ECs in six vernal pools in central Pennsylvania. Three pools were impacted by wastewater spray-irrigation activities and three were in a nearby forested area. Results of this study found that POCIS detected a wide range of 25 ECs (log Kow between -2.6 and 9.37) more or, in some cases, equally frequently, relative to grab samples. Additionally, grab samples were found to best capture short-lived elevated inputs of ECs (from irrigation events) while POCIS were found to best capture ECs that were present in vernal pools over a longer period of time (weeks to months). For ECs detected more frequently in grab samples, concentrations were higher compared to time weighted average aqueous concentrations estimated from POCIS. This study advances understanding of the potential impact of wastewater beneficial reuse on vernal pools and informs how best to monitor the presence of ECs in vernal pools using integrative and grab sampling techniques.

The emergence, trajectory, and impacts of emerging contaminants publications in the Journal of Environmental Quality.

As analytical capabilities in the early 2000s began to enable the detection of chemicals in environmental media at increasingly small concentrations, chemicals with the potential to cause adverse human and ecosystem health effects began to be found nearly ubiquitously worldwide. The types of chemicals that were targeted for analysis included natural and synthetic hormones, human and veterinary pharmaceuticals, chemicals in personal care products, novel pesticides, nanoparticles, microplastics, and other chemicals of natural and synthetic origin. The impacts of these chemicals on environmental and human health in many cases remain unknown. Collectively, these chemicals became known as "emerging contaminants" or "contaminants of emerging concern." Much progress has been made toward understanding the sources of these contaminants in the environment, the processes that control their fate and transport once they are released into the environment, and the ability of technology and/or best management practices to mitigate their occurrence. As the Journal of Environmental Quality (JEQ) celebrates its 50th anniversary, we sought to understand how publications in the journal have made impactful contributions in the research area of emerging contaminants. Here, we present the trajectory of publications in JEQ that have shaped knowledge in this field, highlight the importance of these contributions, and conclude with opportunities for JEQ to continue attracting high-quality emerging contaminants research.

Assessing surface and subsurface transport of neonicotinoid insecticides from no-till crop fields.

Increased use of neonicotinoid-coated crop seeds introduces greater amounts of insecticides into the environment, where they are vulnerable to transport. To understand the transport of neonicotinoids from agricultural fields, we planted maize (Zea mays L.) seeds coated with thiamethoxam in lysimeter plots in central Pennsylvania. Over the next year, we sampled water generated by rainfall and snowmelt and analyzed these samples with mass spectrometry for the neonicotinoids thiamethoxam and clothianidin (metabolite), which originated from the coated seeds. For surface and subsurface transport, thiamethoxam exhibited "first-flush" dynamics, with concentrations highest during the first events following planting and generally decreasing for the remainder of the study. The metabolite clothianidin, however, persisted throughout the study. The mass of thiamethoxam and clothianidin exported during the study period accounted for 1.09% of the mass applied, with more than 90% of the mass transported in subsurface flow and less than 10% in surface runoff. These results suggest that surface runoff, at least for our site, is a relatively small contributor to the overall fate and transport of these insecticides and that the delivery ratio (i.e., mass exported/mass applied) observed for these compounds is similar to those of other trace-level emerging contaminants known to negatively influence aquatic ecosystems.

Riparian buffer effectiveness as a function of buffer design and input loads.

Although many agricultural watersheds rely heavily on riparian buffer adoption to meet water quality goals, design and management constraints in current policies create adoption barriers. Based on focus group feedback, we developed a flexible buffer design paradigm that varies buffer width, vegetation, and harvesting. Sixteen years of daily-scale nutrient and sediment loads simulated with the Soil and Water Assessment Tool (SWAT) were coupled to the three-zone Riparian Ecosystem Management Model (REMM) to compare the effectiveness of traditional, policy-based buffer designs with designs that are more flexible and integrate features important to local farmers. Buffer designs included (i) 10 m grass, (ii) 15 m grass, (iii) 15 m deciduous trees, (iv) 30 m grass and trees, (v) 30 m grass and trees with trees harvested every 3 yr, and (vi) 30 m grass and trees with grass harvested every year. Allowing harvesting in one zone of the buffer vegetation (either trees or grasses) minimally affected water quality, with annual average percent reductions differing by <5% (p > .05; 76-78% for total nitrogen [TN], 51-55% for total phosphorus [TP], and 68% for sediment). Under the highest input loading conditions, buffers with lower removal efficiencies removed more total mass than did buffers with high removal efficiencies. Thus, by focusing on mass reduction in addition to percent reduction, watershed-wide buffer implementation may be better targeted to TN, TP, and sediment reduced. These findings have important implications for informing flexible buffer design policies and enhanced placement of buffers in watersheds impaired by nutrient and sediment.