RESUMO
Short-chain chlorinated paraffins (SCCPs) were defined as persistent organic pollutants in 2017, and they can migrate and transform in the environment, accumulate in organisms, and amplify through the food chain. Although they pose a serious threat to environmental safety and human health, there are few papers on their removal. The current SCCP removal methods are expensive, require severe operating conditions, involve time-consuming biological treatment, and have poor removal specificities. Therefore, it is important to seek efficient methods to remove SCCPs. In this paper, a pressurized reactor was introduced, and the removal performance of SCCPs by Escherichia coli strain 2 was investigated. The results indicated that moderate pure oxygen pressurization promoted bacterial growth, but when it exceeded 0.15 MPa, the bacterial growth was severely inhibited. When the concentration of SCCPs was 20 mg/L, the removal rate of SCCPs was 85.61% under 0.15 MPa pure oxygen pressurization for 7 days, which was 25% higher than at atmospheric pressure (68.83%). In contrast, the removal rate was only 69.28% under 0.15 MPa air pressure. As the pressure continued to increase, the removal rate of SCCPs decreased significantly. The total amount of extracellular polymeric substances (EPS) increased significantly upon increasing the pressure, and the amount of tightly bound EPS (TB-EPS) was higher than that of loosely bound EPS (LB-EPS). The pressure mainly promoted the secretion of proteins in LB-EPS. Furthermore, an appropriate pure oxygen pressure of 0.15 MPa improved the dehydrogenase activity. The gas chromatography-mass spectrometry (GC-MS) results indicated that the degradation pathway possibly involved the cleavage of the C-Cl bond in SCCPs, which produced Cl-, followed by C-C bond breaking. This process degraded long-chain alkanes into short-chain alkanes. Moreover, the main degradation products detected were 2,4-dimethylheptane (C9H20), 2,5-dimethylheptane (C9H20), and 3,3-dimethylhexane (C8H18).
RESUMO
The washing wastewater from the desulfuration and denitration of power plants has high salt (chloride and sulfate) and ammonia-nitrogen concentrations and is difficult to treat using microbiological methods. A novel anoxic/oxic biofilm process was developed to remove ammonia from wastewater. Three rapid strategies (sulfate concentration was increased from 0 to 60 g/L in 6, 13, and 22 days (R1, R2, and R3, respectively)) were applied and produced biofilm with the same nitrification capacity as slow strategies (100-203 days). Excessive organics inhibited the nitrification capacity of the biofilm. R1 excelled at ammonia removal (from 30% to 95%, 70 mg/(L·d), with an effluent ammonia concentration of 4 mg/L) at 60 g/L salinity after the organic load was reduced. The content of extracellular polymeric substances in biofilm depended on its capacity to remove organics. Pseudomonas and Thauera were enriched in the three reactors. Controlling the organic load might prevent the sulfur cycle.
Assuntos
Amônia , Águas Residuárias , Biofilmes , Reatores Biológicos , Nitrificação , Nitrogênio , Salinidade , Eliminação de Resíduos LíquidosRESUMO
This study compared the membrane fouling mitigation in two novel types of biofilm membrane bioreactor coupled with a pre-anoxic tank (BF-AO-MBR)-namely a fixed biofilm membrane bioreactor (FB-MBR) with fiber bundle bio-carriers and a moving-bed biofilm membrane bioreactor (MB-MBR) with suspended bio-carriers-relative to an anoxic/oxic MBR (AO-MBR), at salinities ranging from zero to 60 g/L. The results showed that the FB-MBR mitigated membrane fouling to a greater degree than the MB-MBR and AO-MBR. During operation, the FB-MBR exhibited the lowest fouling development, with three membrane filtration cycles, while the AO-MBR and MB-MBR had 22 and nine cycles, respectively. The key fouling factor in all reactors was cake layer resistance (RC), which contributed to 89.61, 62.20, and 83.17% of the total fouling resistance (RT) in AO-MBR, FB-MBR and MB-MBR, respectively. Additionally, in the FB-MBR, the pore blocking resistance (30.07%) was also an important cause of fouling. Fiber bundle bio-carriers and suspended bio-carriers reduced the RT by 37.68% and 21.24% (mainly the RC) compared to that of AO-MBR. Furthermore, FB-MBR and MB-MBR caused a decrease of suspended biomass (80.14 and 15.90%, respectively), and the latter exhibited a higher sludge particle size than AO-MBR, possibly resulting in the cake layer decline. The studied BF-AO-MBRs further alleviated the fouling propensity by reducing the amount of soluble microbial product (SMP) and extracellular polymeric substances (EPS) under all salinity levels, especially the FB-MBR. Among the protein components, the amounts of tryptophan protein-like substance and aromatic protein-like substance were significantly lower in the FB-MBR compared to the AO-MBR and MB-MBR. Additionally, at 60 g/L salinity, the structure of the microbial community in the FB-MBR had a lower abundance of Bacteroidetes and more biomacromolecule degraders, which may have contributed to the moderation of membrane fouling.
Assuntos
Incrustação Biológica , Águas Residuárias , Biofilmes , Reatores Biológicos , Membranas Artificiais , Veículos Automotores , EsgotosRESUMO
The performance of pollutant removals, activated sludge characteristics, and microbial communities of two biofilm membrane bioreactors coupled with pre-anoxic tanks (BF-AO-MBRs) (one using fiber bundle bio-carriers (FB-MBR) and the other using suspended bio-carriers (MB-MBR)) were compared at the salinity between zero and 60â¯g/L. At all salinities, three bioreactors showed good COD average removal efficiencies (>94.1%), and FB-MBR showed the best TN removal efficiency (90.4% at 30â¯g/L salinity). Moreover, FB-MBR had the faster process start-up time and better salt shock resistance. At high salinities (30-60â¯g/L), more extracellular polymeric substances were produced by the BF-AO-MBRs to avoid the penetration of salt and protect the bacterial community. Because of the different attachment patterns of biofilms, the microbial community structure in the FB-MBR exposed to 30â¯g/L salinity had higher nitrite-oxidizing/ammonia-oxidizing bacteria ratio (6.44) with more abundance of denitrifiers, which contribute to higher TN removal efficiency and lower nitrite accumulation.
Assuntos
Microbiota , Águas Residuárias , Biofilmes , Reatores Biológicos , Membranas Artificiais , Esgotos , Eliminação de Resíduos LíquidosRESUMO
Sorption and degradation are considered two primary modes of pollutant removal by microorganisms, and extracellular polymeric substances (EPS) have been shown to play an important role in these biological processes. However, their role in removing refractory organic pollutants the effects of intracellular substances in microorganisms remain unclear. In this study, we investigated both the removal mechanism and intracellular substances involved in removing the pollutant acenaphthene (ACE) from Pseudomonas sp. bacteria in anaerobic conditions. The results indicated that the ACE was mainly adsorbed rather than degraded by bacteria. Moreover, ACE had little impact on EPS secretion at concentrations ranging 0-3â mg/L. Cell walls and membranes accounted for more than 70% of ACE adsorption, whereas intra-cellular substances accounted for about 10-25% and the effect of other components on ACE adsorption was not obvious. A possible mechanism of ACE removal by bacteria is proposed.