High-Gain Millimeter-Wave Beam Scanning Transmitarray Antenna.

In this article, a high-gain millimeter-wave transmitarray antenna (TAA) maintaining scanning ability is developed, integrating an array feed as the primary emitter. The work is achieved within a limited aperture area, avoiding the replacement or extension of the array. The addition of a set of defocused phases along the scanning direction to the phase distribution of the monofocal lens allows the converging energy to be dispersed into the scanning scope. The beam forming algorithm proposed in this article can determine the excitation coefficients of the array feed source, and is beneficial to improve the scanning capability in array-fed transmitarray antennas. A transmitarray based on the square waveguide element illuminated by an array feed is designed with a focal-to-diameter ratio (F/D) of 0.6. A 1-D scan with a scope of -5° to 5° is realized through calculation. The measured results show that the transmitarray can achieve a high gain, 37.95 dBi at 160 GHz, although a maximum 2.2 dB error appears compared with the calculation in the operating band of 150-170 GHz. The proposed transmitarray has been proven to generate scannable high-gain beams in the millimeter-wave band and is expected to demonstrate its potential in other applications.

Low-Profile Dual-Band Reflector Antenna for High-Frequency Applications.

A high-gain low-profile reflector antenna with dual-band radiation ability is presented in this paper. The antenna achieves a relative 2 dB gain bandwidth of 10% around fl, and a relative 2 dB gain bandwidth of 20%, around fh, where fl and fh are the center operating frequencies of the frequency bands of 29.4~32.4 GHz and 142~174 GHz, respectively. To achieve the dual-band radiation ability, a composite dual-band feed with an fh/fl ratio of around 5 is proposed as the feed for the reflector antenna, which includes a higher-band circular waveguide and a lower-band coaxial horn. The metallic elliptical surface serves as the subreflector (SR) in the higher band, while the SR is the planar reflectarray in the lower band. Due to the design of the dual reflector, the dual-band reflector antenna features a low focal-to-diameter (F/D) ratio of approximately 0.2. According to the simulated results, the proposed reflector antenna achieves efficiencies of 59.0% and 42.9% at fl and fh, respectively. For verification purposes, a Ku/E-band scaled prototype is manufactured. The measured VSWRs, radiation patterns, and gains are in reasonable agreement with the simulated ones, proving the correctness of the proposed design method.

Metasurface-based Fourier lens fed by compact plasmonic optical antennas for wide-angle beam steering.

A Fourier lens can perform the Fourier transform of an incident wavefront at the focal plane. This paper reports a metasurface-based Fourier lens fed by compact plasmonic optical antennas for wide-angle beam steering. The metasurface, composed of six elements with different configurations covering the 2π phase range, features a large field-of-view (FOV) of ±50°. A novel plasmonic optical antenna for broadside radiation is then designed as the feed source of the metasurface. The proposed antenna has ultra-compact size of 0.77λ × 1.4λ, and achieves a high directivity of 9.6 dB and radiation efficiency of over 80% at the wavelength of 1550 nm. Full-wave simulations are carried out to evaluate the performances of the designed metasurface-assisted beam steering device. The results show that this device can achieve a maximum directivity of 21.5 dB at broadside radiation. Compared to conventional Yagi-Uda antenna feed, a directivity enhancement of about 2.7 dB can be obtained, exhibiting a great superiority of the proposed feed antenna. In addition, a large beam steering range of ±50° can be achieved with an acceptable gain drop of 2.83 dB. With the advantages of wide beam steering range, good radiation characteristics, small footprint, and ease of integration, the proposed metasurface-assisted beam steering device would be a promising candidate for integrated photonic applications, including wireless optical communications, light detection and ranging, and augmented reality.

Current Sheet Antenna Array and 5G: Challenges, Recent Trends, Developments, and Future Directions.

Designing an ultra-wideband array antenna for fifth generation (5G) is challenging for the antenna designing community because of the highly fragmented electromagnetic spectrum. To overcome bandwidth limitations, several millimeter-wave bands for 5G and beyond applications are considered; as a result, many antenna arrays have been proposed during the past decades. This paper aims to explore recent developments and techniques regarding a specific type of phased array antenna used in 5G applications, called current sheet array (CSA). CSA consists of capacitively coupled elements placed over a ground plane, with mutual coupling intentionally introduced in a controlled manner between the elements. CSA concept evolved and led to the realization of new array antennas with multiple octaves of bandwidth. In this review article, we provide a comprehensive overview of the existing works in this line of research. We analyze and discuss various aspects of the proposed array antennas with the wideband and wide-scan operation. Additionally, we discuss the significance of the phased array antenna in 5G communication. Moreover, we describe the current research challenges and future directions for CSA-based phased array antennas.

High-efficiency unidirectional vertical emitter achieved by an aperture-coupling nanoslot antenna array.

Coupling light from in-plane guided light into free space or optical fibers is crucial for many photonic integrated circuits and vice versa. However, traditional grating couplers or waveguide grating antennas suffer from low upward coupling efficiency due to the light radiating in both upward and downward directions simultaneously. In this paper, a compact aperture-coupling nanoslot antenna array is proposed for high-efficiency unidirectional radiation, where a two-dimensional high-contrast grating (HCG) is employed as a mirror to reflect the undesired downward radiation. Upon the HCG separated by a low-index spacing layer, a thin silver layer is deposited. Finally, a series of H-shaped slots are patterned on the silver thin film to arrange the aperture fields and radiate the in-plane guided light into free space. The proposed nanoslot antenna array features a front-to-back ratio (F/B) over 10 dB within the wavelength range of 1500 ∼ 1600 nm. At the same time, a high radiation efficiency of over 75% and a maximum radiation efficiency of 87.6% are achieved within the 100 nm bandwidth. The high-efficiency unidirectional antenna array is promising for the integrated photonic applications including wireless optical communications, light detection and ranging, and fiber input/output couplers.

Grating lobe suppression in optical phased arrays by loading near-wavelength grating.

Optical phased arrays based on optical waveguides are compelling components enabling efficient and accurate beam steering. However, to avoid crosstalk between the waveguides, the element pitch is typically larger than one wavelength, which gives rise to grating lobes in real space. In this Letter, we report that near-wavelength gratings can be employed to suppress the grating lobes by utilizing the angular low-pass-filter characteristics. The properly designed near-wavelength grating acts as an angle-sensitive transmission structure. Nearly 100% transmissivity can be realized at small incident angles. However, it quickly declines to a low level when the incident angle is over the critical one. Then, a simple line current array is utilized to demonstrate the grating lobe suppression effect with the grating designed for TE-polarized incidence. Finally, we demonstrate that by loading the proposed grating designed for TM-polarized incidence upon a waveguide grating array with a 2.4 µm pitch, a grating lobe suppression of 10 dB can be achieved when scanning up to ±14∘.

All-plasmonic Optical Phased Array Integrated on a Thin-film Platform.

Optical phased arrays have been demonstrated to enable a variety of applications ranging from high-speed on-chip communications to vertical surface emitting lasers. Despite the prosperities of the researches on optical phased arrays, presently, the reported designs of optical phased arrays are based on silicon photonics while plasmonic-based optical phased arrays have not been demonstrated yet. In this paper, a passive plasmonic optical phased array is proposed and experimentally demonstrated. The beam of the proposed plasmonic optical phased array is steerable in the far-field area and a high directivity can be achieved. In addition, radio frequency phased array theory is demonstrated to be applicable to the description of the coupling conditions of the delocalized surface plasmons in optical phased arrays and thus the gap between the phased arrays at two distinctly different wavelengths can be bridged. The potential applications of the proposed plasmonic phased arrays include on-chip optical wireless nanolinks, optical interconnections and integrated plasmonic lasers.

Flat Terahertz Reflective Focusing Metasurface with Scanning Ability.

The ability to manipulate the propagation properties of electromagnetic waves, e.g., divergence, focusing, holography or deflection, is very significant in terahertz applications. Metasurfaces with flat structures are attractive for achieving such manipulations in terahertz band, as they feature low profile, lightweight, and ease of design and installation. Several types of terahertz reflective or transmitting metasurfaces with focusing function have been implemented recently, but none of them can provide scanning ability with controllable focus. Here, a flat reflective metasurface featuring controllable focal shift is proposed and experimentally demonstrated. Furthermore, the principle of designing a focus scanning reflective metasurface is presented and the focusing characteristics are discussed, including focus scanning along a line parallel or orthogonal to the metasurface with a large bandwidth. These interesting properties indicate that this flat reflective metasurface could play a key role in many terahertz imaging and detection systems.

Loss control between symmetric and anti-symmetric modes for single-lobed surface emitting of terahertz quantum cascade laser.

Single-mode surface-emitting distributed feedback terahertz (THz) quantum cascade lasers (QCLs) operating around 2.76 THz are investigated in metal-metal waveguide. The design consists of one conventional long slit and two additional short slits aside in a single unit cell. Based on the symmetric modes, the two short slits provide radiating components in phase to form higher beam quality. Meanwhile the long slit provides the main feedback and lower extracted power with out-of-phased components, which contributes less to the beam. The surface-current analysis method is first introduced in QCL to analyze the losses between symmetric and anti-symmetric modes as the distance of the two short slits changes. The designed band-edge mode operates at a relative low loss, and a main single lobe is achieved with low side lobe level.

Controlling dispersion characteristics of terahertz metasurface.

Terahertz (THz) metasurfaces have been explored recently due to their properties such as low material loss and ease of fabrication compared to three-dimensional (3D) metamaterials. Although the dispersion properties of the reflection/transmission-type THz metasurface were observed in some published literature, the method to control them at will has been scarcely reported to the best of our knowledge. In this context, flexible dispersion control of the THz metasurface will lead to great opportunities toward unprecedented THz devices. As an example, a THz metasurface with controllable dispersion characteristics has been successfully demonstrated in this article, and the incident waves at different frequencies from a source in front of the metasurface can be projected into different desired anomalous angular positions. Furthermore, this work provides a potential approach to other kinds of novel THz devices that need controllable metasurface dispersion properties.

Plasmonic nanopatch array for optical integrated circuit applications.

Future plasmonic integrated circuits with the capability of extremely high-speed data processing at optical frequencies will be dominated by the efficient optical emission (excitation) from (of) plasmonic waveguides. Towards this goal, plasmonic nanoantennas, currently a hot topic in the field of plasmonics, have potential to bridge the mismatch between the wave vector of free-space photonics and that of the guided plasmonics. To manipulate light at will, plasmonic nanoantenna arrays will definitely be more efficient than isolated nanoantennas. In this article, the concepts of microwave antenna arrays are applied to efficiently convert plasmonic waves in the plasmonic waveguides into free-space optical waves or vice versa. The proposed plasmonic nanoantenna array, with nanopatch antennas and a coupled wedge plasmon waveguide, can also act as an efficient spectrometer to project different wavelengths into different directions, or as a spatial filter to absorb a specific wavelength at a specified incident angle.

Improved biodesulfurization of hydrodesulfurized diesel oil using Rhodococcus erythropolis and Gordonia sp.

Substituted benzothiophenes (BTs) and dibenzothiophenes (DBTs) remain in diesel oil following conventional desulfurization by hydrodesulfurization. A mixture of washed cells (13.6 g dry cell wt l(-1)) of Rhodococcus erythropolis DS-3 and Gordonia sp. C-6 were employed to desulfurize hydrodesulfurized diesel oil; its sulfur content was reduced from 1.26 g l(-1) to 180 mg l(-1), approx 86% (w/w) of the total sulfur was removed from diesel oil after three cycles of biodesulfurization. The average desulfurization rate was 0.22 mg sulfur (g dry cell wt)(-1) h(-1). A bacterial mixture is therefore efficient for the practical biodesulfurization of diesel oil.