RESUMO
Fe(ii) pyridyl-NHC sensitizers bearing thienylcyanoacrylic (ThCA) anchoring groups have been designed and characterized with the aim of enhancing the metal to surface charge separation and the light harvesting window in iron-sensitized DSSCs (FeSSCs). In these new Fe(ii) dyes, the introduction of the ThCA moiety remarkably extended the spectral response and the photocurrent, in comparison with their carboxylic analogues. The co-sensitization based on a mixture of a carboxylic and a ThCA-iron complex produced a panchromatic absorption, up to 800 nm and the best photocurrent and efficiency (J sc: 9 mA cm-2 and PCE: 2%) ever reported for an FeSSC.
RESUMO
Lindqvist polyoxometalate (POM) additives increase VOC in p-type DSSCs by up to 140%, yielding substantial efficiency gains for poorly matched dyes and redox mediators. For better dye/electrolyte combinations, these gains are typically outweighed by losses in JSC. Charge lifetime and transient IR measurements show that this is due to retardation of both recombination and electron transfer to the mediator, and a positive shift in the NiO valence band edge. The POMs also show their own, limited sensitizing effect.
RESUMO
A new Ru(II) dye, Ru(L1)(L2) (NCS)2, L1 = (4-(5-hexylthiophen-2-yl)-4'(4-carboxyl-phenyl 2,2'-bipyridine) and L2 = (4-4'-dicarboxy-2,2'-bipyridine), labelled MC112, based on a dissymmetric bipyridine ligand for improved interfacial and optical properties, was synthesized and used in DSCs, yielding photovoltaic efficiencies of 7.6% under standard AM 1.5 sunlight and an excellent device stability. Increased light harvesting and IPCE maximum were observed with MC112 compared to the prototypical homoleptic N719 dye, due to the functionalized bipyridyne ligand acting as an antenna. In addition, the mixed bipyridyne ligand allowed MC112 binding to TiO2 to occur via three anchoring carboxylic groups, thus exhibiting similar interfacial properties to those of the N719 dye. DFT/TDDFT calculations were performed on the new dye, both in solution and adsorbed on a TiO2 surface model, revealing that the peculiar photovoltaic properties of the MC112 dye are related to its anchoring mode. The new design rule thus allows us to engineer both light-harvesting and interfacial properties in the same dye.
RESUMO
We report a joint experimental and computational work on new organic donor-acceptor dye sensitizers in which a carbazole (CZ) and a phenothiazine (PTZ) units are linked together by an alkyl C6H13, while two different anchoring groups are employed: the cyanoacrylic acid (CS1A, CSORG1) and the rhodanine-3-acetic acid (CS4A, CSORG4). The CZ moiety has multiple roles of (i) acting as an extra-electron donor portion, providing more electron density on the PTZ; (ii) suppressing the back-electron transfer from TiO2 to the electrolyte by forming a compact insulating dye layer; (iii) modulating dye aggregation on the semiconductor surface; and (iv) acting as an antenna, collecting photons and, through long-range energy transfer, redirecting the captured energy to the dye sensitizer. We show that the introduction of the CZ donor remarkably enhances the photovoltaic performances of the rhodanine-based dye, compared to the corresponding simple PTZ dye, with more than a two-fold increase in the overall efficiencies, while it does not bring beneficial effects in the case of the cyanoacrylic-based sensitizer. Based on quantum mechanical calculations and experimental measurements, we show that, in addition to a favored long-range energy transfer, which increases the light absorption in the blue region of the spectrum, the presence of the CZ unit in the CSORG4 dye effectively induces a beneficial aggregation pattern on the semiconductor surface, yielding a broadened and red-shifted light absorption, accounting for the two-fold increase in the generated photocurrent.
