Effect of tungsten doping on the structural, morphological and bactericidal properties of nanostructured CuO.

Copper oxide (CuO) has been broadly used in different technological and biological applications. However, based on the literature review, there are few reports describing the synthesis of tungsten doped copper oxide and its biological applications, although CuO and W (tungsten) based nanomaterials have been reportedly already synthesized. In this study we synthesized novel CuO and CuO/W (at.1%, 2% and 4%) nanoparticles and explored their tungsten content-dependent bactericide activity. In order to obtain the materials, was used a co-precipitation method which is of low cost. The synthesized materials were characterized by x-ray diffraction (XRD); XRD results indicated that only the sample with at.1% of W presented pure Tenorite phase. Diffuse reflectance spectroscopy (DRS) allowed to obtain the band gap energy values; CuO/W (at.2%) sample exhibited the minimum value of 2.62 eV. Grains sizes ranging from 39.78 to 53.47 nm were established through field emission-scanning electronic microscopy (FE-SEM), and these sizes were confirmed by transmission electron microscopy (TEM). Doping with W also influenced the morphology obtained in all cases. BET (Brunauer, Emmett, Teller) analysis allowed to establish an increase in specific surface area and pore size with W doping. The particle size was determined by dynamic light scattering (DLS). The bactericidal properties were tested using well diffusion method for Escherichia coli and Staphylococcus aureus bacteria. Bactericide response of CuO nanoparticles was improved by the inclusion of W dopant into the CuO structure, leading to an expansion in the inhibition zone for the CuO/W (at.1%) sample; inhibition halo diameters were 1.5 and 12 mm for CuO and CuO/W (at.1%), respectively. Hence, it was possible to infer the remarkable importance of the crystalline phase, morphology, particle size and specific superficial area of the CuO/W (at.1%) nanoparticles in its bactericide performance. WO3 secondary phase affected the bactericide response of the materials obtained at at.2% and at.4% of tungsten content.

Evaluation of Photocatalytic Activity in Water Pollutants and Cytotoxic Response of α-Fe2O3 Nanoparticles.

α-Fe2O3 samples were manufactured by means of the polymeric precursor method. The powders were sintered and calcined at temperatures of 300-700 °C for 2 h, respectively. In the X-ray diffraction results, the formation of the rhombohedral phase without secondary phases was exhibited. The size of the particle increased after calcination at 700 °C, exhibiting a slightly more irregular morphology for the samples calcined with the addition of NH4OH in the synthesis process. From the field-emission scanning electron microscopy measurements, the particle size was determined, showing a smaller size for the samples without NH4OH in the synthesis process. The samples calcined at 600 °C had a size of 100 nm, with the sizes for lower temperatures being smaller. The size of the nanoparticle agglomerates was largest for the samples with NH4OH; however, the zeta potential was slightly lower over time for these samples. The phase study of the α-Fe2O3 nanoparticles was confirmed by means of Raman spectroscopy, without additional bands of another crystal structure. In addition, the synthesized nanoparticles exhibited good photocatalytic activity in the degradation of rhodamine B (RhB) and atrazine (ATZ) within 40 min, with a maximum degradation of 59% for ATZ and 40% for rhodamine. The best responses in the degradation were for the samples without the addition of NH4OH in the synthesis process and in proportions lower than 0.1 g. The cytotoxic effects of the nanoparticles obtained at 600 °C were evaluated in apical cells of onion roots. The results are promising for future applications because no changes were observed in the mitosis of the cells.