Effect of Interfacial SiOx Defects on the Functional Properties of Si-Transition Metal Oxide Photoanodes for Water Splitting.

The transfer of photogenerated charges through interfaces in heterojunction photoanodes is a key process that controls the efficiency of solar water splitting. Considering Co3O4/SiOx/Si photoanodes prepared by physical vapor deposition as a representative case study, it is shown that defects normally present in the native SiOx layer dramatically affect the onset of the photocurrent. Electron paramagnetic resonance indicates that the signal of defects located in dangling bonds of trivalent Si atoms at the Si/SiOx interface vanishes upon vacuum annealing at 850 °C. Correspondingly, the photovoltage of the photoanode increases to ≈500 mV. Similar results are obtained for NiO/SiOx/Si photoanodes. Photoelectrochemical analysis and impedance spectroscopy (in solution and in the solid state) indicate how the defect annealing modifies the Co3O4/SiOx/Si junction. This work shows that defect annealing at the solid-solid interface in composite photoanodes strongly improves the efficiency of charge transfer through interfaces, which is the basis for effective solar-to-chemical energy conversion.

Monolayer doping of germanium by phosphorus-containing molecules.

The DPP (diethyl 1-propylphosphonate) and ODPA (octadecylphosphonic acid) molecules are studied as precursors for the monolayer doping (MLD) of germanium. Their adsorption behaviour is investigated, revealing different physicochemical interactions between the phosphorus-containing molecules and the Ge surfaces. It is discovered that DPP adsorption occurs after the oxidation of Ge surface, while the ODPA undergoes chemisorption on -H terminated surfaces. Quantitative phosphorus analysis demonstrates that in the first case more than one monolayer is formed (from 2 to 4), while in the second a single monolayer is formed. Moreover, the analysis of phosphorus diffusion from the surface layers into the Ge matrix reveals that conventional thermal annealing processes are not suitable for Ge injection due to a higher activation energy of the process in comparison with silicon. On the contrary, pulsed laser melting is effective in forming a doped layer, owing to the precursor's decomposition under UV light.

Green synthesis and electrophoretic deposition of Ag nanoparticles on SiO2/Si(100).

Plasmonic substrates were prepared by electrophoretic deposition of Ag nanoparticles on SiO2/Si(100). The Ag nanoparticles were obtained using [Ag(NH3)2](+) as the Ag precursor and d-glucose as the reducing agent. Under optimized conditions, this simple and green synthesis method furnished a suspension of Ag nanoparticles with a narrow dimensional dispersion (centered around 27 nm) and a negative z-potential, suitable for electrophoretic deposition. Samples were chemically, optically and morphologically characterized by photoemission and UV-vis spectroscopy and electron microscopy, and tested as substrates for surface enhanced Raman spectroscopy. Despite being a very simple procedure, good enhancement factors were measured thanks to the formation of hot spots, formed by sandwiching the analyte (benzenethiol) between sequentially deposited Ag nanoparticles.

Growth and optical properties of silver nanostructures obtained on connected anodic aluminum oxide templates.

Ag nanostructures are grown by AC electrodeposition on anodic alumina oxide (AAO) connected membranes acting as templates. Depending on the thickness of the template and on the voltage applied during the growth process, different Ag nanostructures with different optical properties are obtained. When AAO membranes about 1 µm thick are used, the Ag nanostructures consist in Ag nanorods, at the bottom of the pores, and Ag nanotubes departing from the nanorods and filling the pores almost for the whole length. When AAO membranes about 3 µm thick are used, the nanostructures are Ag spheroids, at the bottom of the pores, and Ag nanowires that do not reach the upper part of the alumina pores. The samples are characterized by angle resolved x-ray photoelectron spectroscopy, scanning electron microscopy and UV-vis and Raman spectroscopies. A simple NaOH etching procedure, followed by sonication in ethanol, allows one to obtain an exposed ordered array of Ag nanorods, suitable for surface-enhanced Raman spectroscopy, while in the other case (3 µm thick AAO membranes) the sample can be used in localized surface plasmon resonance sensing.