Raman and infrared study of 4f electron-phonon coupling in HoVO3.

First-order Raman scattering and multiphonons are studied in RVO3 (R = Ho and Y) as a function of temperature in the orthorhombic and monoclinic phases. Raman spectra of HoVO3 and YVO3 unveil similar features since both compounds have nearly identical R-radii. However, the most important difference lies in the transition temperature involving the V(3+) orbitals, the V(3+) magnetic moments as well as the crystallographic structure. Particularly, the magnetic and orbital reorientations occur at T N2 = 40 K for HoVO3 instead T N2 =77 K in the case of YVO3. For both systems, anomalous phonon shifts which are related to spin-phonon coupling are observed below the V(3+) magnetic ordering temperature (T N1 ≈ 110 K) while additional phonon anomalies are exclusively observed in HoVO3 around T (*) ≈ 15 K. On the other hand, infrared (IR) transmittance measurements as a function of temperature reveal Ho(3+5)I8 → (5)I7 excitations and additional excitations assigned as vibronics. These latter combined with drastic changes in Ho(3+5)I8 → (5)I7 excitations at T N2, are indicative of a strong coupling between the Ho(3+) ions and the ligand field. This could explain the large magnetocaloric capacity shown by HoVO3.

Micro-Raman and infrared studies of multiferroic TbMn2O5.

We have studied the Raman and infrared spectral response of TbMn2O5 under an applied magnetic field parallel to the easy magnetic a-axis at 4.2 K. Strong spin-lattice coupling in TbMn2O5 is evidenced by a frequency shift of Raman and infrared phonons as a function of magnetic field compared to the phonon response of BiMn2O5 that remains unaffected. The magnetic field behavior of the highest frequency phonons retraces the polarization switching in TbMn2O5 and shows an important frequency softening below 3 T that is modulated by the J 3 and J 4 exchange parameters. The role of the Tb(3+) spin alignment with H is interpreted in terms of a local lattice striction and the contribution of the charge transfer mechanism to the magnetoelectric process is evaluated.

Modeling ventilation time in forage tower silos.

The fermentation process in forage tower silos produces a significant amount of gases, which can easily reach dangerous concentrations and constitute a hazard for silo operators. To maintain a non-toxic environment, silo ventilation is applied. Literature reviews show that the fermentation gases reach high concentrations in the headspace of a silo and flow down the silo from the chute door to the feed room. In this article, a detailed parametric analysis of forced ventilation scenarios built via numerical simulation was performed. The methodology is based on the solution of the Navier-Stokes equations, coupled with transport equations for the gas concentrations. Validation was achieved by comparing the numerical results with experimental data obtained from a scale model silo using the tracer gas testing method for O2 and CO2 concentrations. Good agreement was found between the experimental and numerical results. The set of numerical simulations made it possible to establish a simple analytical model to predict the minimum time required to ventilate a silo to make it safe to enter. This ventilation time takes into account the headspace above the forage, the airflow rate, and the initial concentrations of O2 and CO2. The final analytical model was validated with available results from the literature.

Effect of varying the combustion parameters on the emissions of carbon monoxide and nitrogen oxides in the exhaust gases from propane-fueled vehicles.

Propane-fueled forklifts are one source of carbon monoxide (CO) contamination of workplace air. The previous study carried out by the Quebec Occupational Health and Safety Research Institute dealt with worker exposure to CO during forklift use in buildings. It recommends that exhaust gas emissions be kept below a 1 percent concentration. However, this control has not produced a significant reduction in worker exposure to CO, when factors (ventilation, type of work tasks, and management of vehicle fleet) specific to companies are taken into account. Consequently, a reduction in CO emissions below the threshold of 0.3 percent should be considered. The experience acquired with propane-fueled ice resurfacers can be used to determine the effect of combustion parameters on exhaust gas emissions. It is known that a reduction in CO emissions from ice resurfacers resulted in the appearance of nitrogen oxides (NOx) and eventually in nitrogen dioxide (NO2) poisoning. Few publications present NOx results in relation to the CO measured in the exhaust gases of propane-fueled vehicles. The objective of this study is to define the level to which CO emissions can be reduced without increasing NOx concentrations. This real-situation study quantified the CO, NO, and NOx in the exhaust gases of a fleet of propane-fueled forklifts in relation to the mixture ratio. The results show the impact of the motor speed and mixture ratio on the CO, NO, and NO2 concentrations. They confirm an increase in NOx concentrations when CO concentrations are reduced. They also show that proper maintenance of forklifts combined with optimal adjustments can reduce CO and NOx emissions. The study proposes a compromise between CO and NOx emissions by taking into account worker health and safety as well as vehicle performance. Monitoring must be done to control air quality in work areas and worker exposure to CO and NO2. A forklift preventive maintenance program and general building ventilation are the favored and recommended means of control.

Production in vitro of antibodies directed against alloantigen-specific recognition sites on T cells and on lymphocytotoxic HLA antibodies.

We have examined the mechanism of immunological unresponsiveness in a recipient (P.S.) with a long-term functioning renal allograft. P.S., whose HLA type is A1, A30; B14, B18; DR1, w8; DRw52; DQw1 and in whose serum we had earlier demonstrated the presence of antiidiotypic antibodies, received a kidney from a cadaver donor of HLA type A1, A10, B8 in March, 1970. Peripheral blood B lymphocytes from the patient were transformed with Epstein-Barr virus (EBV), and by the cluster-picking technique a B cell line was propagated with continuous production of antibodies. Antiidiotypic antibodies with two distinct biological functions were demonstrable; one specifically inhibiting the lymphocytotoxic activity of anti-HLA-B8, B5, and DR3 reference typing sera, and the other specifically inhibiting proliferative responses in MLC of the recipient's lymphocytes and of third party cells sharing B14, DR1, DQw1 with the patient against stimulator cells carrying B8, DR3 antigens. Immunodepletion experiments demonstrated that the inhibitory activity was associated with the IgM fraction. Absorption experiments suggested that different antibodies may be responsible for the inhibition of lymphocytotoxic activity of anti-HLA sera and of the proliferative responses in MLC. Antiidiotypic antibodies have been postulated to be important in maintaining allograft tolerance in vivo, thereby enhancing renal allograft survival. The availability of such antibodies in large quantities, produced in vitro, could provide antisera for the immunochemical characterization of specific idiotypic receptors on immunoglobulins and T lymphocytes.