State of the art and future challenges for polycyclic aromatic hydrocarbons is sediments: sources, fate, bioavailability and remediation techniques.

Polycyclic aromatic hydrocarbons (PAHs) are amongst the most abundant contaminants found in the aquatic environment. Due to their toxicity and carcinogenicity, their sources, fate, behaviour, and cleanup techniques have been widely investigated in the last several decades. When entering the sediment-water system, PAH fate is determined by particular PAH and sediment physico-chemical properties. Most of the PAHs will be associated with fine-grained, organic-rich, sediment material. This makes sediment an ultimate sink for these pollutants. This association results in sediment contamination, and in this manner, sediments represent a permanent source of water pollution from which benthic organisms may accumulate toxic compounds, predominantly in lipid-rich tissues. A tendency for biomagnification can result in critical body burdens in higher trophic species. In recent years, researchers have developed numerous methods for measuring bioavailable fractions (chemical methods, non-exhaustive extraction, and biomimetic methods), as valuable tools in a risk-based approach for remediation or management of contaminated sites. Contaminated sediments pose challenging cleanup and management problems, as conventional environmental dredging techniques are invasive, expensive, and sometimes ineffective or hard to apply to large and diverse sediment sites. Recent studies have shown that a combination of strategies including in situ approaches is likely to provide the most effective long-term solution for dealing with contaminated sediments. Such in situ approaches include, but are not limited to: bioaugmentation, biostimulation, phytoremediation, electrokinetic remediation, surfactant addition and application of different sorbent amendments (carbon-rich such as activated carbon and biochar) that can reduce exposure and limit the redistribution of contaminants in the environment.

A chemical and microbiological characterization and toxicity assessment of the Pancevo industrial complex wastewater canal sediments, Serbia.

The wastewater canal Vojlovica of the Pancevo industrial area, Serbia, is the main collector of the effluents from the local industrial complex. The canal is directly connected to the Europe's second largest river, the Danube. Here, we present a chemical and microbiological analysis of the sediment in order to determine the fate of pollutants over the years, as well as its current condition. Dry matter, clay and organic matter content, a Kjeldahl ammonia, phosphorus, metals, and polychlorinated biphenyls as well as polycyclic aromatic hydrocarbons concentrations were measured. Microbiological analysis included heterotrophic and oil-degrading bacterial counts, isolation of the phenanthrene-degrading bacteria, and identification of cyanobacteria. Generally, in comparison to the results from previous studies, concentrations of the measured pollutants have been in a decline. Specifically, the metal and polycyclic aromatic hydrocarbon concentrations were reduced whereas microbial counts and toxicity tests did not indicate significant pollution. The obtained results are probably a consequence of an improved wastewater treatment and microbial degradation of pollutants.

Using chemical desorption of PAHs from sediment to model biodegradation during bioavailability assessment.

This work compares the biodegradation potential of four polycyclic aromatic hydrocarbons (PAH) (phenanthrene, pyrene, chrysene and benzo(a)pyrene, chosen as representatives of the 3, 4 and 5 ring PAHs) with their desorption from sediment by XAD4 resin and methyl-ß-cyclodextrin (MCD). The biodegradation study was conducted under various conditions (biostimulation, bioaugmentation and their combination). The results show that total PAH removal in all treatments except biostimulation gave similar results, whereby the total amount of PAHs was decreased by about 30-35%. The desorption experiment showed that XAD4 desorbed a greater fraction of phenanthrene (77% versus 52%), and benzo(a)pyrene (44% versus 25%) than MCD. The results for four ring PAHs were similar for both desorption agents (about 30%). Comparing the maximum biodegraded amount of each PAH with the rapidly desorbed XAD4 and MCD fraction, XAD4 was found to correlate better with biodegradation for the high molecular PAHs (pyrene, chrysene, benzo(a)pyrene), although it overestimated the availability of phenanthrene. In contrast, MCD showed better correlation with the biodegradation of low molecular weight PAHs.

Impact of hydrocarbon type, concentration and weathering on its biodegradability in soil.

The objective of this research was to investigate the impact of the hydrocarbon type and concentration, as well as the total effect of the natural weathering process to hydrocarbon biodegradability in sandy soil and the environment. In this experiment, sandy soil was separately contaminated with 0.5%, 1.0%, 2.0% and 3.5% of diesel and crude oils. Oil contaminated soil was taken from the Oil Refinery dumping sites after 9 years of weathering, and its concentration was adjusted to the above-mentioned levels. The biodegradation process was monitored by measuring CO(2), evolution rate, hydrocarbon degradation rate and dehydrogenase activity. The favourable concentration ranges for the soil contaminated with diesel oil were 1.0%, with concentrations at about 2.0% causing slightly adverse effects to CO(2) production which was overcome after 2 weeks, and with 3.5% diesel oil causing significant toxicity. For soil contaminated with crude oil, 2.0% was found to be optimum for effective biodegradation, with 3.5% crude oil also causing adverse effects to CO(2) production, although less so than the same concentration of diesel oil. No adverse effect was obtained for any concentration of the weathered oil, as after the weathering process, the remaining contaminants in the soil were mostly poorly degradable constituents like asphaltenes, resins etc. It has been proposed that such residual material from oil degradation is analogous to, and can even be regarded as, humic material. Due to its inert characteristics, insolubility and similarity to humic materials it is unlikely to be environmentally hazardous.

Correlation between the results of sequential extraction and effectiveness of immobilization treatment of lead- and cadmium-contaminated sediment.

The assessment of the quality of sediment from the Great Backi Canal (Serbia), based on the pseudo-total lead (Pb) and cadmium (Cd) content according to the corresponding Dutch standards and Canadian guidelines, showed its severe contamination with these two metals. A microwave-assisted BCR (Community Bureau of Reference of the Commission of the European Union) sequential extraction procedure was employed to assess their potential mobility and risk to the aquatic environment. Comparison of the results of sequential extraction and different criteria for sediment quality assessment has led to somewhat contradictory conclusions. Namely, while the results of sequential extraction showed that Cd comes under the high-risk category, Pb shows low risk to the environment, despite its high pseudo-total content. The contaminated sediment, irrespective of the different speciation of Pb and Cd, was subjected to the same immobilization, stabilization/solidification (S/S) treatments using kaolinite, montmorillonite, kaolinite-quicklime, montmorillonite-quicklime, fly ash, zeolite, or zeolite-fly ash combination. Semi-dynamic leaching tests were conducted for Pb- and Cd-contaminated sediment in order to assess the long-term leaching behavior of these metals. In order to simulate "worst case" leaching conditions, the semi-dynamic leaching test was modified using 0.014 M acetic acid (pH = 3.25) and humic acid solutions (20 mg TOC l-1) as leachants instead of deionized water. The effectiveness of S/S treatment was evaluated by determining diffusion coefficients (De) and leachability indices (LX). The standard toxicity characteristic leaching procedure (TCLP) was applied to evaluate the extraction potential of Pb and Cd. A diffusion-based model was used to elucidate the controlling leaching mechanisms. Generally, the test results indicated that all applied S/S treatments were effective in immobilizing Pb and Cd, and the treated sediments may be considered acceptable for "controlled utilization" based on LX values, irrespective of their different availability in the untreated samples. In the majority of samples, the controlling leaching mechanism appeared to be diffusion, which indicates that a slow leaching of Cd and Pb could be expected when the above S/S agents were applied. The TCLP results showed that all S/S samples were nonhazardous.