RESUMO
Agriculture is the economic backbone of Pakistan. 67% of country's population resides in rural areas and primarily depends on agriculture. Pakistan's soils are poor in OM and have a low C : N ratio, and the overall fertility status is insufficient to support increased crop yields. Compost is an excellent alternative solution for improving soil OM content. However, this excellent alternative supply in Pakistan has yet to be used. Mass volumes of leaves, grass clippings, plant stalks, vines, weeds, twigs, and branches are burned daily. In this study, different compost piles (P1, P2, and P3) of compost were made using different agricultural and animal waste combinations to assess temperature, pH, and NPK. Results revealed that P3 demonstrated the most successful composting procedure. The temperature and pH levels throughout the composting process were determined in a specified range of 42-45oC and 6.1-8.3, respectively. Total nitrogen content ranged from 81.5 to 2175 ppm in farm compost. Total phosphorus concentrations range from 1.33 to 13.98 ppm, and potassium levels, on the other hand, range from 91.53 to 640 ppm in farm compost. The overall nitrogen concentration grew progressively between each pile at the end of a week. The varied concentrations revealed that adding various forms of agricultural waste would result in a variation in the quantity of NPK owing to microbial activity. On-farm composting has emerged as an effective technique for the sustainability of agricultural activities, capable of resolving crucial problems like crop residues and livestock waste disposal. Based on this study's results, the pile (P3) combination shows the best NPK value performance and is recommended for agricultural uses to overcome the OM deficiency.
RESUMO
Proper identification of critical source areas (CSAs) is important for economic viability of any best management practices (BMPs) aimed at reducing sediment and phosphorus loads to receiving water bodies. Both continuous and event-based hydrologic and water quality models are widely used to identify and assess CSAs, however, their comparative assessment is lacking. In this study, we have used continuous Soil and Water Assessment Tool (SWAT) and event-based Agriculture Non-Point Source (AGNPS) pollution models to identify CSAs for sediment and phosphorus in a watershed in Ontario, Canada. Along with their original version, both models were re-conceptualized to incorporate saturation excess mechanism of runoff generation, which is also refereed as variable source area (VSA) integration. The models were set-up using high resolution spatial, crop- and land-management, and meteorological dataset; and calibrated with reasonable accuracy against streamflow, sediment and phosphorus concentration data at multiple locations. Threshold value (t-value) approach was used to identify CSA areas in the watershed. Results showed that both models were in agreement (up to 96% of fields) that summer season did not constitute hot-moments (<6% of the watershed area as CSAs) for both sediment and phosphorus. SWAT models identified winter (~50% of watershed area as CSA) and AGNPS models identified early spring (~50% of watershed areas as CSAs) season as the hot-moment for both sediment and phosphorus. Contrasting result, as indicated by low (1%) matching in field CSA potential, was observed in autumn season. In the same season, VSA integrated SWAT and AGNPS models showed better matching (43% for sediment and 31% for phosphorus), highlighting the importance of VSA integration in the models. Qualitative validation of model-based CSA potential with oblique aerial-photograph-based CSA potential in two soil moisture conditions (wetter and drier) indicated slightly better performance of the SWAT models, and over-prediction of the AGNPS models. However, a more comprehensive analysis based on more detailed field observations is needed to further confirm the results.
Assuntos
Agricultura , Fósforo , Monitoramento Ambiental , Modelos Teóricos , Ontário , Fósforo/análise , Solo , Qualidade da ÁguaRESUMO
Vegetated filter strips (VFS) are used recently for removal, at or near the source, of sediment and sediment-bound chemicals from cropland runoff. Vegetation within the flowpath increases water infiltration and decreases water turbulence, thus enhancing pollutant removal by sedimentation within filter media and infiltration through the filter surface. Field experiments have been conducted to examine the efficiency of vegetated filter strips for phosphorus removal from cropland runoff with 20 filters with varying length (2 to 15 m), slope (2.3 and 5%), and vegetated cover, including bare-soil plots as control. Artificial runoff used in this study had an average phosphorus concentration of 2.37 mg L(-1) and a sediment concentration of 2700 mg L(-1). The average phosphorus trapping efficiency of all vegetated filters was 61% and ranged from 31% in a 2-m filter to 89% in a 15-m filter. Filter length has been found to be the predominant factor affecting P trapping in VFS. The rate of inflow, type of vegetation, and density of vegetation coverage had secondary influences on P removal. Short filters (2 and 5 m), which are somewhat effective in sediment removal, are much less effective in P removal. Increasing the filter length beyond 15 m is ineffective in enhancing sediment removal but is expected to further enhance P removal. Sediment deposition, infiltration, and plant adsorption are the primary mechanisms for phosphorus trapping in VFS.
Assuntos
Fósforo/isolamento & purificação , Poluentes do Solo/isolamento & purificação , Biodegradação Ambiental , Fertilizantes , Filtração , Plantas , Chuva , Movimentos da ÁguaRESUMO
Laboratory experiments were conducted to examine the effect of detergents on transport of atrazine [2-chloro-4-(ethylamino)-6-(isopropylamino)-s-triazine] through loam and sandy loam soils under saturation conditions. The Convection Dispersion Equation (CDE) was used to model and quantify the effects of detergents on atrazine model parameters: the retardation factor (R), pore velocity (v) and dispersion coefficient (D). The transport parameters were estimated using moment technique and partition coefficient obtained from batch experiments and compared with best-fitted parameters, R and D, keeping pore velocity constant. Results indicated the CDE model was not successful in predicting atrazine transport in the presence of surfactants at high concentrations. In the case of anionic surfactant with Elora loam, the average predicted R and D from moment technique of 3.4 and 11.1 cm2/h, respectively were significantly different than fitted parameters (R = 39 and D = 227 cm2/h). The poor performance of CDE in the presence of surfactants results from physiochemical changes in herbicide solubility and retention to the soil matrix rather than changes in soil hydraulic properties since the predicted pore water velocities from moment technique were similar to those measured during leaching experiments. Nevertheless, BTC analysis with CDE showed that land application of anionic surfactant (sulphonic) significantly increased R and D and decrease v for both soils. Addition of sulphonic increased R of atrazine by 12 and 26 folds for loam and sandy loam soils, respectively. On the other hand non-ionic surfactants seemed to decrease R, especially in sandy loam soil, thus facilitating atrazine leaching through soil. Non-equilibrium conditions seemed to govern atrazine transport in the presence of surfactants; double peaks in breakthrough curves were observed, indicating a need for mathematical models to account for such phenomena. Atrazine dispersion and tailing seemed to be higher through Elora loam compared to Caledon sandy loam due to higher aggregation of the Elora soil.