Micromechanical Modeling for Tensile Properties of Wood Plastic Composites: Use of Pruned Waste from Pecan Orchards as Sustainable Material for Reinforcement of Thermoplastic Composite.

Wood plastic composites (WPCs) specimens containing high-density polyethylene (HDPE) and wood pruning waste were manufactured and evaluated for their mechanical properties. Pecan waste was used as an accessible and sustainable source in this study, and the effects of its particle size and concentration on WPC strengths were evaluated. Pecan waste was milled and sieved to various particle sizes, and testing samples were fabricated by mixing them in a twin-screw extruder and injection molding. A coupling agent was used to create a stable bond between the HDPE and wood. Both tensile modulus and strength were increased with an increasing pecan flour concentration up to about 60 weigh percent. A micromechanical model is proposed for predicting the mechanical properties of the wood flour/fiber reinforce composite. This model uses a correction factor of an elliptical of carried sizes and shapes. The preliminary results of the model have a high correlation with the experimental values of the composite in all mesh sizes.

Chemical modification of nanocellulose with canola oil fatty acid methyl ester.

Cellulose nanocrystals (CNCs), produced from dissolving wood pulp, were chemically functionalized by transesterification with canola oil fatty acid methyl ester (CME). CME performs as both the reaction reagent and solvent. Transesterified CNC (CNCFE) was characterized for their chemical structure, morphology, crystalline structure, thermal stability, and hydrophobicity. Analysis by Fourier transform infrared (FTIR) and FT-Raman spectroscopies showed that the long chain hydrocarbon structure was successfully grafted onto CNC surfaces. After transesterification the crystal size and crystallinity of nanocrystals were not changed as determined by Raman spectroscopy and wide angle X-ray diffraction (XRD). CNCFE showed higher thermal stability and smaller particle size than unmodified CNCs. Water contact angle measurement indicated the CNCFE surface has significantly higher hydrophobicity than unmodified CNCs. The transesterified CNCs could be potentially used as hydrophobic coatings and reinforcing agents to hydrophobic polymer for nanocomposites.

A composite generator film impregnated with cellulose nanocrystals for enhanced triboelectric performance.

A novel polydimethylsiloxane (PDMS)/cellulose nanocrystal flake (CNCF) composite triboelectric nanogenerator (CTG) using CNCFs as effective dielectrics exhibited a 10-times-enhanced triboelectric performance compared with its pure PDMS counterpart. Positive charges generated on the surface of the CNCFs during cyclic compression boosted electron transfer and induced extra charges. The CTG exhibited an instantaneous output power (density) of 1.65 mW (0.76 mW cm-2) under continuous operation.